Instruction/ maintenance manual of the product PM-1378AB Century
Go to page of 32
Instruction Manual A void injury or death - Read and understand this manual! Para instrucciones en Español, llamar al: 1-800-837-4044 www .centuryproducts.
T ABLE OF CONTENTS Important Information..................................... 1 W arnings......................................................... 2 Basic Information.
IMPORT ANT INFORMA TION No car seat can guarantee protection fr om injury in every situation, but proper use helps reduce the risk of serious injury or death. Child restraints (car seats) could be recalled for safety reasons. Y ou must register this restraint to be reached in a recall.
W ARNINGS - Prevent serious injur y or death: 2 x Never use a vehicle “lap-only” belt across front of child. Never put a car seat in a front vehicle seat unless recommended by vehicle owner’ s manual.
3 W ARNINGS - Prevent serious injur y or death (continued): DO NOT use car seat if it is damaged or has missing parts. DO NOT use accessories or parts other than those provided by Century or Graco. Their use could alter the function of the car seat. Never leave child unattended, even when sleeping.
DO NOT use after date shown on back of car seat due to changing requirements and normal wear and tear . Look for: BASIC INFORMA TION Always secure car seat with a vehicle seat belt, even when unoccupied. An unsecured car seat can injure passengers. Protect vehicle seat.
Without Harness System With Harness System Child MUST meet all of the following requirements: • W eight is 30 - 40 lbs. (13.6 - 18 kg). • Height is 27 - 43 inches (68.6 - 110 cm) tall. • Child is able to sit upright unassisted. • Child’ s shoulders are not above top harness slots.
Place forward-facing on vehicle seat. Lift seat pad flap, thread vehicle seat belt through openings and buckle belt (fig. a) . Press down firmly in center of car seat to compress vehicle seat cushion while tightening vehicle seat belt. HINT : Use your knee to press down in center of car seat (fig.
Place forward-facing on vehicle seating position with a vehicle lap/shoulder belt. See “V ehicle Seat Belts” section. T ether may be used to stabilize booster seat: Attach tether hook (A) to anchor hardware (B) and tighten strap to remove any slack (fig.
Adjust harness system: Harness straps must be through slots at or just above shoulders. Place child in car seat with child’ s back flat against back of car seat. Place harness straps over child’ s shoulders and insert tongues into buckle. Pull up on tongues to be sure they are locked.
9 2 3 (fig. a) (fig. b) PLACING CHILD IN CAR SEA T - with harness system (continued).
Remove harness system (see “Harness System - removal and re-assembly” section). Place child in car seat with child’ s back flat against back of car seat. Place shoulder belt across child’ s chest and lap belt under both armrests. Buckle belt and pull shoulder belt to adjust lap belt snugly .
11 (fig. a) (fig. c) (fig. b) Loops PLACING CHILD IN CAR SEA T - without harness system (continued).
OPERA TIONS and ADJUSTMENTS 12 Harness Straps: • T o tighten: Pull belt tab (fig. a) . • T o loosen: Lift lever on front of car seat while pulling harness straps (fig. b) . Harness Tie: • T o open: Press tab and pull apart (fig. c) . • T o close: Snap halves together .
13 (fig. b) (fig. c) (fig. a) (fig. e) 1 2 3 (fig. d) Tighten Adjuster Loosen OPERA TIONS and ADJUSTMENTS (continued).
HARNESS SYSTEM - removal and re-assembly 14 Removal: Harness with Breast Plates: • Remove harness strap loops from Splitter Plates on back and bottom of car seat. • Pull harness strap out of car seat. NOTE: It is not necessary to remove harness tie and tongues from harness straps.
15 1 5 Splitter Plate (Bottom) 3 (Harness with Breast Plates) Splitter Plate (Back) 4 1 5 3 (Harness without Breast Plates) HARNESS SYSTEM - removal and re-assembly (continued) (Clip) (Clip) (Clip) (C.
16 VEHICLE SEA T BEL TS If car seat with harness system is not held securely after following instructions in this manual, vehicle seat belt labels, and vehicle owner’ s manual: • Move car seat to another seating location and try again, or • Contact vehicle dealer for possible seat belt modification parts.
17 With Harness System: The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if positioned at a certain angle. If this happens, flip latch plate over (fig. a) and re-buckle. T est installation again to see if this works.
With Harness System: Lap belts with retractors may or may not hold a car seat securely . Follow these steps to determine if you have a retractor system that will hold car seat securely: a. Pull belt all the way out. b. Allow belt to retract about 6 inches (15 cm).
19 With or Without Harness System: DO NOT use with any car seat. ❃ Passive Restraint - Lap Belt with Motorized Shoulder Belt With or Without Harness System: DO NOT use with any car seat.
20 With Harness System: V ehicle seat belts located for ward of seat crease may not securely hold car seat. Check vehicle owner’ s manual or see vehicle dealer for car seat installation requirements. If approved for use with car seat by vehicle manufacturer , install car seat and check for secure installation by pulling car seat fr ont to back.
21 (fig. b) ❃ Combination Lap/Shoulder Belt with Locking Latch Plate With Harness System: OK to use. Follow vehicle owner’ s manual for specific instructions on how to use vehicle seat belts. The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if positioned at a certain angle.
(fig. a) ❃ Combination Lap/Shoulder Belt with Sliding Latch Plate Pull 22 VEHICLE SEA T BEL TS (continued) With Harness System: Pull on latch plate (fig. a) . If belt slides freely through latch plate, a locking clip MUST be used. (See “Locking Clip”section.
23 1/2 inch (1 cm) Avoid serious injury or death: • Failure to use locking clip where required will result in car seat not being securely held in place. • Remove locking clip from seat belts when not being used with car seat. W ARNING ❃ Locking Clip (fig.
ADDITIONAL INFORMA TION V ehicle may already be equipped with a tether anchor (top strap anchor). See vehicle owner’ s manual for location. If vehicle does not have a tether anchor , one must be installed: • Contact vehicle dealership for proper anchor location and installation.
25 For storage of tether hook if not used with a belt position booster: • Adjust tether strap length so hook end is as short as possible. • Roll loose end of strap up. • Place rolled up strap on top of adjuster and place rubber band around bundle.
❃ Care & Cleaning 26 3 2 2 ADDITIONAL INFORMA TION (continued) Removing Seat Pads: If using harness system, remove harness system (see “Harness System - removing and re-assembly” section). T urn car seat upside down: Using a screwdriver , pr y metal rod loose from car seat shell and slide elastic off.
27 Ta b ADDITIONAL INFORMA TION (continued) Removing Cup Holder: • Feel bottom of armrest and locate tab on bottom edge of cup holder . • Press tab in while lifting cup holder up.
28 Prevent serious injury or death: • Buckle must be properly latched. • Periodically inspect and clean buckle to remove objects or debris that could prevent latching. W ARNING Seat Pad and Armrest Pads: Machine-wash separately on gentle cycle and machine-dry on cool air setting or line dry .
Century advises against loaning or passing along car seat. With Harness System: This car seat is certified for use on aircraft when used with harness system (see label on car seat). Contact airline about their policy . Use this car seat only on forward-facing aircraft seats.
Store in pocket. Fold instruction manual. 1 2 PM-1378AB 2/00 If a part is damaged, missing, or you need help or replacement parts, DO NOT return car seat to the store. CALL US FIRST Call toll-free 1-800-837-4044 from anywhere in the U.S. or Canada or fax at 1-610-286-4555.
An important point after buying a device Century PM-1378AB (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Century PM-1378AB yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Century PM-1378AB - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Century PM-1378AB you will learn all the available features of the product, as well as information on its operation. The information that you get Century PM-1378AB will certainly help you make a decision on the purchase.
If you already are a holder of Century PM-1378AB, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Century PM-1378AB.
However, one of the most important roles played by the user manual is to help in solving problems with Century PM-1378AB. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Century PM-1378AB along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
