Instruction/ maintenance manual of the product SPF-40-1VER Casio
Go to page of 9
2273-1 Module No. 2273 GETTING ACQUAINTED Congratulations upon your selection of this CASIO watch. To get the most out of your purchase, be sure to read this manual carefully and keep it on hand for later reference when necessary.
2273-2 To set the time and date 1. In the Timekeeping Mode, hold down A until the second ’ s digits start to flash, which indicates the setting screen. • While the second ’ s digits are flashing, press E to reset the seconds count to 00 . 2. Press D to move the flashing in the sequence shown below to select other settings.
2273-3 Not visible on the display. Barometric pressure graph (unit: 1hPa (mb)/0.05inHg) Temperature Barometric pressure BAROMETER/THERMOMETER This watch uses a pressure sensor to measure air pressure (barometric pressure) and a temperature sensor to measure a temperature.
2273-4 Countdown Mode Beeper Operations The watch beeps at various times during a countdown to keep you informed about the countdown status without looking at the display. The following describes the types of beeper operations the watch performs during a countdown.
2273-5 To measure times with the stopwatch Elapsed Time Split Time Two Finishes * Pressing A here normally clears the stopwatch to all zeros. In the case of a stopwatch operation started automatically.
2273-6 To turn an alarm and the Hourly Time Signal on and off 1. In the Alarm Mode, use E and B to select an alarm or the Hourly Time Signal. 2. When the alarm or the Hourly Time Signal you want is selected, press C to turn it on and off. Indicates alarm is ON.
2273-7 Moon Phase Indicator The Moon phase indicator of this watch indicates the current phase of the Moon as shown below. • The light part of the Moon phase indicator shows the part of the Moon that is visible in the sky during each particular phase.
2273-8 More than 15 degrees too high Auto light switch precautions • Avoid wearing the watch on the inside of your wrist. Doing so causes the auto light switch to operate when it is not needed, which shortens battery life. If you want to wear the watch on the inside of your wrist, turn off the auto light switch feature.
2273-9 Calibrating the Temperature Sensor The temperature sensor of this watch is calibrated at the factory before shipment and further adjustment is normally not required. If you notice serious errors in the temperature readings produced by the watch, you can calibrate the sensor to correct the errors.
An important point after buying a device Casio SPF-40-1VER (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Casio SPF-40-1VER yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Casio SPF-40-1VER - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Casio SPF-40-1VER you will learn all the available features of the product, as well as information on its operation. The information that you get Casio SPF-40-1VER will certainly help you make a decision on the purchase.
If you already are a holder of Casio SPF-40-1VER, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Casio SPF-40-1VER.
However, one of the most important roles played by the user manual is to help in solving problems with Casio SPF-40-1VER. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Casio SPF-40-1VER along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
