Instruction/ maintenance manual of the product 8353 Calphalon
Go to page of 25
FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid. 4. If odor continues, immediately call your gas supplier or your fire department. FOR YOUR SAFETY 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
2 IMPORTANT SAFEGUARDS FAILURE TO FOLLOW THESE SAFEGUARDS COULD RESULT IN DEATH, SERIOUS BODILY INJURY, AND/OR PROPERTY LOSS. READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY OR USE OF THE LP GAS GRILL. 1. WARNING! Read and follow all instructions.
7. WARNING! If your grill catches on fire: 8. Check the inside body of your grill for grease buildup. Remove excess grease to avoid a grease fire in the bowl.
— NOTICE — AMG STRIVES TO BE A QUALITY SUPPLIER OF CONSUMER PRODUCTS. IF WE INADVERTENTLY OMITTED ANY PARTS NEEDED FOR ASSEMBLY OR YOU NEED TROUBLESHOOTING INFORMATION, PLEASE CONTACT US USING OUR TOLL FREE NUMBER. THANK YOU FOR PURCHASING AN AMG PRODUCT.
GRILL PARTS LIST 5 1. 03.4074.00 Spacer, Body 8 ea. 2. 03.4100.00 Handle 1 ea. 3. 03.4101.00 Bolt M5X15mm 3 ea. 6. 03.4104.00 Wing Nut M8 1 ea. 5. 03.4103.00 Heat Indicator 1 ea. 4. 03.4102.00 Handle Spacer 1 ea. 10. 03.4111.00 L. Side End Cap 1 ea. 9.
NOTICE: Be careful and do not set the Grill Body on the Manifold Extension. Bending or damaging this connection can make the grill unusable. •Remove The contents from the grill. •Remove all packing materials from •Use the Packing Blocks to support the grill until ready to assemble.
7 •With Base upside down, screw Caster Assembly (Item 28) into Caster mounting hole. Rotate clockwise to tighten. •Place Base right side up. place with 2 M6 X15 bolts as shown. No nuts are required. •Assemble other half of Pedestal to Base. (Item 37) M6 X 15mm Actual Size 6 Pcs.
8 STEP 3 - Assemble the Grill Body •Place Body on Pedestal. Caution: Do not leave grill unattended until bolts are secured. •Attach Cylinder Retaining Wire (Item 26) through hole in back of Pedestal as shown in detail. Step 2 - Continued •Make sure contents of grill have been removed for easy lifting.
9 •From the inside of the grill, secure Body to Pedestal using 4 M6 X 15 screws through the holes as shown above in Fig. A , securing with 4 M6 nuts from below as shown to the right in Fig. B . Caution: Do not leave grill unattended until bolts are secured.
•Place Foil Pan (Item 32) in Grease Tray (Item 33) and slide Grease Tray all the way into brackets. STEP 5 - Install Grease Tray •With Handle (Item 2) positioned as shown, place felt Handle Spacer (Item 4) between Handle and Hood, then insert locating pin into top holes of Spacer and Hood.
11 11 Item 20 M6 X 30mm Actual Size 8 Pcs Item 29 M6 Nut Actual Size 8 Pcs Item 1 Body Spacer Actual Size 8 Pcs Notice: The control panel cover can be opened by gently pulling down on the top of the cover.
FIG. 6B Burner Locator Hole in lower shoulder of rear firewall Burner Peg FIG. 6A Item 27 COTTER PIN Item 34 BURNER Holes in Front Firewall Gas Nozzle Control Valve Gas Collector Plate and Electrode V.
13 COOKING GRIDS CERAMIC BRIQUETTES TRAYS STEP 8 - INSTALL CERAMIC BRIQUETTE TRAYS/ COOKING GRIDS •Remove plastic completely from two Ceramic Briquette Trays (Item 36). Place Briquette Trays side by side on middle shoulder of front and rear firewall over the Burners.
14 Step 10 - LEAK TESTING (TO BE PERFORMED IN A WELL-VENTILATED AREA) Supplies Needed for a Leak Test Clean paint brush, water, and dishwashing liquid detergent. How to perform a leak test Warning! Never use an open flame to test for gas leaks. 1) Mix one cup of water with one cup of dishwashing liquid detergent.
15 OPERATING AND MAINTAINING YOUR GAS GRILL GAS, CYLINDER, HOSE AND REGULATOR INFORMATION This LP gas grill was designed to use propane gas. Propane cylinders will supply gas all year round, even on cold winter days.
16 How to Connect your LP gas cylinder (See STEP 9 of Assembly Instructions for diagram) 1) Make sure all of the control panel knobs are turned to the “off” position and verify that the LP gas cylinder valve is closed by turning the handle on the LP gas cylinder valve clockwise until it stops.
17 · Always perform a leak test before each use. · Leak test must be performed in a well ventilated area. · Never perform a leak test on a grill while in use or hot. · If you detect a gas leak that cannot be corrected by using the leak test procedures below, do not use the LP gas grill.
· Wash the porcelain coated Cooking Grids with a mixture of hot water and soap. · Empty the foil pan and grease tray after each cook - ing session so excessive grease does not accumulate. Failure to remove grease may result in grease dripping onto the cart and/or a grease fire in the tray.
· Open Hood before lighting the grill to prevent an explosion from gas build-up. · Always inspect the gas hose and regulator assembly before each use. If the hose is cut, damaged, or showing signs of excessive abrasion or wear, do not use the LP gas grill.
Your burners have been preset by the manufacturer for optimal flame performance. A blue flame, possibly with a small yellow tip, is the result of the optimal air and LP gas mixture.
Regularly clean your LP gas grill between uses and espe - cially after extended periods of storage. Ensure the grill and its components are cool before cleaning.
TROUBLESHOOTING Problem Possible Cause Solution Burners will not light using the igniter Burners not assembled cor - rectly Not pausing long enough before clicking the control panel knob No spark LP g.
TROUBLESHOOTING Problem Flames blow out Flare up Persistent grease fire Unable to fill LP tank Humming or whistling from the regulator Possible Cause High or gusting winds Gas in LP cylinder is low Ex.
24 IMPORTANT NOTICE IMPORTANT NOTICE The Gas Grill is setup to operate with a LP Gas Cylinder equipped with an OPD (Overfilling Prevention Device). This is a secondary device to prevent the overfilling of your LP Gas cylinder. The proper methods for the filling of your LP Gas cylinder are by weight or volume, as described in NFPA 58.
Calphalon Grill LIMITED WARRANTY This product is warranted to the original consumer purchaser against defects in material and workman - ship under normal outdoor household use and correct assembly (if assembled by the consumer-pur - chaser).
An important point after buying a device Calphalon 8353 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Calphalon 8353 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Calphalon 8353 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Calphalon 8353 you will learn all the available features of the product, as well as information on its operation. The information that you get Calphalon 8353 will certainly help you make a decision on the purchase.
If you already are a holder of Calphalon 8353, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Calphalon 8353.
However, one of the most important roles played by the user manual is to help in solving problems with Calphalon 8353. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Calphalon 8353 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
