Instruction/ maintenance manual of the product RCD 212BTI Caliber
Go to page of 23
RCD 2 1 2 B T i manual • GB •.
RCD 2 1 2 B T i manual 2 Owner’ Manual Contents Precautions.................................................................. ...........3 W arnings Before Installation...................................................4-6 Before Y ou Install.......
RCD 2 1 2 B T i manual 3 Owner’ Manual Precautions • This unit will only play the following discs. T ype of disc CD, MP3, WMA Label on the disc Recorded material Audio only Size of disc 12 cm DO NOT A TTEMP TO MODIFY THE UNIT , MODIFYING THE UNIT MA Y CAUSE AN ACCIDENT .
RCD 2 1 2 B T i • M A N U A L 4 Owner’ Manual Important W arnings to T ake Note of BEFORE Com - mencing Installation Damage Caused By Incorrect Installation or Usage is NOT Covered By W arranty . PLEASE T ake The Time T o Read The Installation Notes Carefully .
RCD 2 1 2 B T i • M A N U A L 5 Owner’ Manual and the speakers. Check the condition of your speakers care - fully- connecting this unit to old or degraded speakers may re - sult in a fault which will damage the audio IC and invalidate the warranty .
RCD 2 1 2 B T i • M A N U A L 6 Owner’ Manual for details on connecting the power amp and other units, then make the connections correctly . • Do not block any vents or heater panels. Blocking them will cause heat to build up and may result in fire.
RCD 2 1 2 B T i • M A N U A L 7 Owner’ Manual Before Y ou Install 2. Mark Polarity of the Speaker Wires Automotive audio equipment installations can be troublesome at times, even to the most experienced of installation technicians.
RCD 2 1 2 B T i • M A N U A L 8 Owner’ Manual Installation W ARNING! Disconnect negative battery terminal from battery before starting installation. Consult the vehicle’ s owner ’ s manual for proper instructions. NOTE: Mark the polarity of the existing speaker wires before disconnecting battery .
RCD 2 1 2 B T i • M A N U A L 9 Owner’ Manual Installation NOTE: Outer trim frame, hook, and mounting sleeve are not used for this installation. This is only intended as a general guide; contact the vehicle's manufacturer for specific instructions.
RCD 2 1 2 B T i • M A N U A L 10 Owner’ Manual W iring Connections Make sure that you have a good chassis ground. Good ground connections will eliminate most electrical noise prob - lems. A good chassis ground requires a tight connection to the vehicle’ s metal chassis.
RCD 2 1 2 B T i • M A N U A L 11 Owner’ Manual Wiring Connections White Panel Light Connect to lighting circuit of vehicle. This will illuminate the but - tons on the display for night time operation. This wire can also be connected to the Orange Remote wire to activate the but - tons when the unit is powered on.
RCD 2 1 2 B T i • M A N U A L 12 Owner’ Manual Control of the Unit 1. Release Panel Button 2 . Power on / off / Mute 3. T A 4. Sound Select / V olume +/- 5. Disc slot 6. LCD Screen 7. Eject Disc Button 8. AF 9. Previous T rack / Backward Button 10.
RCD 2 1 2 B T i • M A N U A L 13 Owner’ Manual 1. Pairing Press and hold PHONE button until the word “P AIRING” blinks on the dis - play waiting for the bluetooth device to connect. At this blinking time, please run the bluetooth search and connect function in your cell phone.
RCD 2 1 2 B T i • M A N U A L 14 Owner’ Manual 1. T uning the unit On / Off Press and hold any Button to turn the unit on, the display will show a mes - sage WELCOME T O CAR AUDIO to indicate it is ready for use. Press and hold the PWR button to turn the unit off.
RCD 2 1 2 B T i • M A N U A L 15 Owner’ Manual 1. Choose Radio Band Press the MOD Button to access the radio function. The unit comes with five bands- three FM Bands (FM1, FM 2 , and FM3) and two MW Bands (MW1, and MW 2) selects. Each of the five bands can store up to six preset stations, for a total of 30 preset memory stations.
RCD 2 1 2 B T i • M A N U A L 16 Owner’ Manual Radio Operation (Cont) RDS Function RDS ( Radio Date System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either .
RCD 2 1 2 B T i • M A N U A L 17 Owner’ Manual Radio Operation (Cont) toggle between MASK DPI and MASK ALL mode. Then leave the unit idle for the mode to take effect.
RCD 2 1 2 B T i • M A N U A L 18 Owner’ Manual C D/MP3/WMA/USB/SD Operation 1. Insert / Eject CD Insert a disc into CD slot with label side up. The disc will be automatically loaded into the unit, even when it is off or at radio mode. The word “LOAD” will blink on the display and the CD will play automatically .
RCD 2 1 2 B T i • M A N U A L 19 Owner’ Manual +/- Button to select the track number . Press and hold the SEL button for 2 seconds,the number of the track is assigned according to you added the file into the media. The file wich are written later will be assigned a larger number .
RCD 2 1 2 B T i • M A N U A L 20 Owner’ Manual 1. Connect your IPOD Connect your IPOD with the original Ipod cable (supplied with the Ipod). This unit can play all the audio Ipod including Ipod T ouch and Iphone. Ipad is not supported. 2. Play / Pause Once the unit has been connected, playback will start automatically .
RCD 2 1 2 B T i • M A N U A L 21 Owner’ Manual Simple T roubleshooting Guide The stereo indicator is blinking PROBLEM No Power Errors are displayed on the screen or no function is active No radio reception CDs cannot be loaded CAUSE/SOLUTION Check and make sure that the fuses did not blow .
RCD 2 1 2 B T i • M A N U A L 22 Owner’ Manual GENERAL Operating Power ......................................................12 V olts DC, Negative Ground Speaker output..............................................................................
WWW .CaliBER.nl CaliBER HEaD OffiCE • The Netherlands • Fax: +31 (0)416 69 90 01 • E-mail: info@caliber .nl.
An important point after buying a device Caliber RCD 212BTI (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Caliber RCD 212BTI yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Caliber RCD 212BTI - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Caliber RCD 212BTI you will learn all the available features of the product, as well as information on its operation. The information that you get Caliber RCD 212BTI will certainly help you make a decision on the purchase.
If you already are a holder of Caliber RCD 212BTI, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Caliber RCD 212BTI.
However, one of the most important roles played by the user manual is to help in solving problems with Caliber RCD 212BTI. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Caliber RCD 212BTI along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
