Instruction/ maintenance manual of the product IC3 Bunn
Go to page of 7
B UNN-O-MA TIC CORPORA TION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 FAX: (217) 529-6644 www .bunnomatic.com IC3 & IC3B ICED COFFEE BREWERS INTRODUCTION This equipment will brew a batch of fresh coffee into an awaiting vessel and dispense at approximately room tempera- ture to conserve ice.
Page 2 These brewers require either 3-wire, grounded service rated 120/208 or 120/240 volts ac or 2-wire, grounded service rated 200 volts ac, or 20 amp, single phase, 60 Hz. Refer to the product’ s data plate above the dilution nozzle for actual voltage of your particular brewer model.
Page 3 Electrical Hook-Up CAUTION – Improper electrical installation will damage electronic components. 1. An electrician must provide electrical service as specified. 2. Remove the top lid and rotate the control thermostat knob fully counter clockwise to the “OFF” position and reinstall the top lid.
Page 4 10792 091701 INITIAL SET -UP (cont.) W ater will flow into the tank and dispenser for five minutes and forty-five seconds. Empty the dispenser when this first cycle stops and press the ST ART switch again. Empty the dispenser when the second cycle stops and press the ST ART switch once more.
Page 5 10792 091701 ADJUSTING BREW VOLUMES (cont.) to be removed from the total brew time period; then immediately press and hold down the ST ART or BREW switch until three clicks are heard.
Page 6 REPLACEMENT P ARTS 03772.0001 .... Base Guide 05920.0000 .... Cable Clamp .25” 00603.0000 .... Cable Clamp .437” 03024.0005 .... Control Thermostat 03409.0000 .... Decal, Caution, Hot Liquid 03408.0000 .... Decal, Caution, Remove Funnel Slowly 24447.
Page 7 FULL/HALF SW 4 2 4000W READY INDICATOR SW. & THERMOSTAT N SCHEMATIC WIRING DIAGRAM IC3 BLK L1 BLK GRN L2 TANK HEATER RED 10793.0000A 2/94 ©1994 BUNN-O-MATIC CORPORATION 120/208 VOLTS AC OR.
An important point after buying a device Bunn IC3 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Bunn IC3 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Bunn IC3 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Bunn IC3 you will learn all the available features of the product, as well as information on its operation. The information that you get Bunn IC3 will certainly help you make a decision on the purchase.
If you already are a holder of Bunn IC3, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Bunn IC3.
However, one of the most important roles played by the user manual is to help in solving problems with Bunn IC3. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Bunn IC3 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
