Instruction/ maintenance manual of the product FMD0013000-UP Bunn
Go to page of 9
FMD-3 (S/N FMD0013000-UP) INST ALLA TION & OPERA TING GUIDE BUNN-O-MA TIC CORPORA TION POST OFFICE BO X 3227 SPRINGFIELD , ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 T o ensure.
2 29170 080112 BUNN-O-MA TIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) Airpots, thermal carafes, decanters, GPR servers, iced tea/coffee dispensers, MCP/MCA pod brewers thermal ser vers and Thermofresh servers (mechanical and digital)- 1 year parts and 1 year labor .
3 INTRODUCTION This equipment dispenses hot beverages or soup on demand from powdered product. It has three hoppers. This equipment may also dispense cold beverages from powdered product from the left dispense station. It is for indoor use only on a sturdy counter or shelf.
4 INITIAL SET -UP 1. Locate the drip tray assembly above the dispenser nested in the packing material. 2. Remove the drip tray and the drip tray cover and set them aside.
5 PLUMBING REQUIREMENTS This dispenser must be connected to a cold water system with operating pressure between 20 and 90 psi (138 and 620 kPa) from a 1/2˝ or larger supply line.
6 LIQUID LEVEL CONTROL The system automatically maintains the hot water tank’ s level by energizing the refill solenoid when the water level drops below the liquid level probe. If the system has not successfully refilled in 7 1/2 minutes, a refill error occurs.
7 ADJUSTMENTS The hot or cold beverage solenoids are preset to dispense approximately 9 / 10 ounce per second. This amount can be adjusted: 1. Disconnect the dispenser from the power source.
8 CLEANING The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all sur - faces on Bunn-O-Matic equipment.
9 DRAINING THE HOT W A TER T ANK CAUTION - The dispenser must be disconnected from the power source throughout these steps. 1. Disconnect the dispenser from the power source. 2. Open front door and place tank heater switch in the “OFF” (upper) position.
An important point after buying a device Bunn FMD0013000-UP (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Bunn FMD0013000-UP yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Bunn FMD0013000-UP - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Bunn FMD0013000-UP you will learn all the available features of the product, as well as information on its operation. The information that you get Bunn FMD0013000-UP will certainly help you make a decision on the purchase.
If you already are a holder of Bunn FMD0013000-UP, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Bunn FMD0013000-UP.
However, one of the most important roles played by the user manual is to help in solving problems with Bunn FMD0013000-UP. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Bunn FMD0013000-UP along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
