Instruction/ maintenance manual of the product A10 Bunn
Go to page of 15
A10 & A10-A INST ALLA TION & OPERA TING GUIDE Designs, materials, weights, specifications, and dimensions for equipment or replacement parts are subject to change without notice. BUNN-O-MA TIC CORPORA TION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 43422.
2 43422.1 030912 BUNN-O-MA TIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) Airpots, thermal carafes, decanters, GPR servers, iced tea/coffee dispensers, MCP/MCA pod brewers thermal servers and Thermofresh ser vers (mechanical and digital)- 1 year parts and 1 year labor .
3 SPECIFICA TIONS E lectrical - UL Listed. Refer to Data Plate on the Brewer , and local/national elec- trical codes to determine circuit requirements. Dimensions - 14 1/4 inches high; 6 3/4 inches wide; 13 1/2 inches deep. Capacity - T wo to eight 6-ounce cups (12-48 ounces) per batch.
4 IMPOR T ANT SAFEGUARDS Follow these basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury: • Readallinstructions. • Do not touch hot surfaces. Use handles or knobs.
5 GENERAL INFORMA TION NOTE - THE BREWER IS NOT READY TO PLUG IN Improper installation will result in permanent damage and void the war - ranty . Read & follow the instructions on the next page. • Be certain the tank is full of water before plugging in the brewer .
6 HOT WA TER T ANK (LOCA TED INSIDE) V ACA TION SWITCH LID ST ART SWITCH WARMER SWITCH FULL/HALF BA TCH SWITCH MODEL A-10/A-10 AUTOMA TIC COFFEE BREWER Hazardous Voltage! Can Cause Fire Or Electrical .
7 CAUTION - Do not plug-in the brewer until specified in Initial Set-Up. The A10/A10 Automatic Brewer has an attached cordset and requires 2-wire grounded service rated 120 volts ac, 10 amp, single phase, 60 Hz.
8 PREP ARING THE BREWER FOR USE NOTE: THE BREWER IS NOT READY TO PLUG IN Raisethehingediplid. Place the decanter on the warmer . Pour two pitchers of water (filled to the top line) into the screened area on top of the brewer . Wait two minutes between pitchers to allow the water to fill the tank.
9 BREWING DELICIOUS COFFEE Insert a Bunn ® coffee filter into the brew funnel. (Be sure to use Bunn ® coffee filters for proper brewing. There is a difference.) Measure coffee into the filter and gently shake to level the bed of grounds. Make sure that the sprayhead is tight.
10 TIMER SETTING - AUTOMA TICS ONL Y CAUTION – Disconnect the power source from the brewer prior to the removal of any panel for the replacement or adjustment of any component. NOTE: Check that the brewer is connected to water supply , the tank is properly filled, and a funnel and server are in place, prior to setting or modifying batch sizes.
11 HOT WA TER The same basic steps can be used to obtain hot water by omitting the filter and coffee and using the enclosed hot water funnel. The hot water from your Bunn ® coffee brewer is approximately 200˚F . This ishotter thanthe hotwater from your faucet and must be handled with care.
12 ROUTINE CLEANING Rinsing the brew funnel and decanter after each use is the only routine cleaning required. Occasionally , wipe the outside of the brewer including the area above the funnel with a damp cloth. (The brew funnel, hot water funnel and decanter are top rack dishwasher safe.
13 DRAINING THE BREWER The water in your Bunn ® Coffee Brewer should be emptied whenever it is taken on a trip, shipped, or stored in an unheated location with a chance of freezing. P2084 P2082 1) Unplug the brewer and cool the hot water in the tank.
14 BUNN ® COMP ANION PRODUCTS COFFEE & TEA FIL TERS Constant quality testing assures consistency from pot to pot. The best flavor without any grounds in the cup. BUNN ® paper filters are packaged to maintain their fluted shape for use in most basket type drip coffee makers and the Bunn ® Easy T ea TM Pitcher .
15 10627.0000A 5/92 © 1992 BUNN-O-MATIC CORPORATION L2 L1 BLK WHI GRN/YEL SCHEMATIC WIRING DIAGRAM A10 A "KEEP WARM" HEATER WHI LOWER WARMER 80W RED RED BLK RED 230 VOLTS AC 2 WIRE SINGLE PHASE LIMIT THERMOSTAT RED SW. & THERMOSTAT SW1 LIMIT THERMOSTAT BLK BLU TANK HEATER 1000W SW2 40W 10627.
An important point after buying a device Bunn A10 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Bunn A10 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Bunn A10 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Bunn A10 you will learn all the available features of the product, as well as information on its operation. The information that you get Bunn A10 will certainly help you make a decision on the purchase.
If you already are a holder of Bunn A10, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Bunn A10.
However, one of the most important roles played by the user manual is to help in solving problems with Bunn A10. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Bunn A10 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
