Instruction/ maintenance manual of the product 40885.0000E Bunn
Go to page of 9
TIT AN SINGLE™ INST ALLA TION & OPERA TING GUIDE BUNN-O-MA TIC CORPORA TION POST OFFICE BO X 3227 SPRINGFIELD , ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 40885.
Page 2 BUNN-O-MA TIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) Airpots, thermal carafes, decanters, GPR servers, iced tea/coffee dispensers, MCP/MCA pod brewers thermal ser vers and Thermofresh servers (mechanical and digital)- 1 year parts and 1 year labor .
Page 3 40885 112611 USER NOTICES Carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should be kept in good condition. Replace any unreadable or damaged labels. #00986.0000 #37881.0000 #00658.0000 03408.
Page 4 40885 080108 ELECTRICAL REQUIREMENTS WARNING - If the power cord is ever damaged, it must be replaced by the manufacturer or its service agent with a special cord available from the manufacturer or its service agent in order to avoid a hazard.
Page 5 PLUMBING REQUIREMENTS This brewer must be connected to a cold water system with operating pressure between 20 and 90 psi (138 and 620 kPa) with a minimum of 4.0 gpm from a 1⁄2" or larger supply line. A shut-off valve should be installed in the line before the brewer .
Page 6 ENABLE ON / OFF BREW SMALL LARGE BREW A. MAIN ON/OFF SWITCH This switch, located under the brewer in front of the right rear leg, turns power on and off to all components in the brewer . B. ON/OFF SWITCH (ENABLE BREW) Pressing the "ON/OFF" switch will alternately turn the brew components on and off.
Page 7 INITIAL SET -UP VIEWING ASSET & SERIAL NUMBER 1. T o view the asset number of the machine, press and hold the left hidden switch until the display reads: ANXXXXXX...ASSET NUMBER . Release the left hidden switch. 2. After a 5 second delay , the display will read: DTTNXXXXXX .
Page 8 COFFEE BREWING 1. Begin each brew cycle with a clean empty brew funnel. 2. Insert a BUNN filter into the funnel. NOTE: The funnels are equipped with 4 wire loops that can be folded over top edge of filter if desired, to prevent filter from folding in during the brew cycle.
Page 9 CLEANING 1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment. Do NOT clean this equipment with a water jet device. 2. Check and clean each sprayhead. The sprayhead holes must always remain open.
An important point after buying a device Bunn 40885.0000E (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Bunn 40885.0000E yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Bunn 40885.0000E - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Bunn 40885.0000E you will learn all the available features of the product, as well as information on its operation. The information that you get Bunn 40885.0000E will certainly help you make a decision on the purchase.
If you already are a holder of Bunn 40885.0000E, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Bunn 40885.0000E.
However, one of the most important roles played by the user manual is to help in solving problems with Bunn 40885.0000E. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Bunn 40885.0000E along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
