Instruction/ maintenance manual of the product WAT28460GB Bosch
Go to page of 36
en Instruction Manual and Installation Instructions Washer WAT....
2 Y our new washing machine You have selected a washing machine from Bosch. Please take a couple of minutes to read and become familiar with the advantages of your washing machine.
en 3 Contents enInstruction Manual and Installation Instructions 8 Intended use . . . . . . . . . . . . . . . . . 4 ( Safety instructions . . . . . . . . . . .5 Electrical safety . . . . . . . . . . . . . . . . . . 5 Risk of injury . . . . . . . . . .
en Intended use 4 4 After-sales service . . . . . . . . . . 27 J T echnical data . . . . . . . . . . . . . . 27 5 Positioning and connecting. . . 27 Included with the appliance . . . . . . . 27 Safety instructions . . . . . . . . . . . . . . 28 Installation surface .
Safety instructions en 5 ( Safety instructions S a f e t y i n s t r u c t i o n s Electrical safety : Warning Danger of death! There is a risk of electric shock if you touch live components. ■ Never touch or hold the mains plug with wet hands. ■ Only pull out the mains cable by the plug and never by the cable, as this could damage it.
en Safety instructions 6 : Warning Danger of death! Children may lock themselves in appliances, putting their lives at risk. For appliances that have reached the end of their service life: ■ Disconnect the mains plug. ■ Cut through the mains cable and remove it, along with plug.
Environmental protection en 7 7 En vironmental protection E n v i r o n m e n t a l p r o t e c t i o n Packaging/used appliance Tips on economical use ■ Always fill the appliance with the maximum amount of laundry for each programme. Overview of programmes ~ : Supplementary sheet for the operating and installation instructions.
en Getting to know the appliance 8 * Getting to know the appliance G e t t i n g t o k n o w t h e a p p l i a n c e W ashing machine 6 7 # ( Detergent drawer ~ Page 16 0 Operati.
Getting to know the appliance en 9 Control panel Control panel depending on the model *depending on the model Note: The buttons are sensitive, they only need to be touched gently.
en Getting to know the appliance 10 Displa y panel Note: You will find settings and information for the selected program in the table. *depending on the model ** depending on the selected program, set.
Laundry en 11 Z Laundr y L a u n d r y Prepare the laundr y Caution! Damage to the appliance/fabrics Foreign objects (e.g. coins, paper-clips, needles, nails) may damage the laundry or components in the washing machine. Therefore, note the following tips when preparing your laundry: ■ Empty pockets.
en Detergent 12 Dyeing/bleaching Dye should only be used in normal household quantities. Salt may damage stainless steel. Always follow the dye manufacturer's instructions. Do not use the washing machine to bleach clothes. Soaking 1. Switch on the appliance.
Programme default settings en 13 Saving energy and detergent For light and normal soiling, you can save energy (lower washing temperature) and detergent. Note: When measuring the amount of all detergents/additives/care products and cleaning agents, please always check the manufacturer's instructions and information.
en Additional programme settings 14 stays wet inside the drum, e.g. for items that should not be spun. Setting - - - -: Spülstopp (Rinse Stop) = no final spin.
Operating the appliance en 15 Note: Do not exceed the maximum load. ■ Eco Energy-optimised washing by reducing the temperature while achieving a washing result that is consistent with the selected program, without the Speed Eco setting. Press the button to do this.
en Operating the appliance 16 Change the programme default settings You can use the default settings for each wash cycle or change them. To do this, repeatedly press the corresponding button until the required setting is displayed. The settings are activated without needing to be confirmed.
Operating the appliance en 17 ■ The amount of laundry ■ Soiling ~ Page 13 Filling : Warning Eye/skin irritation! Detergent and care products may spray out if the detergent drawer is opened while the machine is in operation. Open the drawer carefully.
en Operating the appliance 18 Childlock ( E 3 sec., E 3 δευτ .) You can lock the washing machine to prevent the functions you have set from being changed inadvertently.
Sensors en 19 ■ Selecting a spin speed or setting the program selector to 0 Spin/Drain// Spin/Empty [ and then pressing the A button. Programme end End appears in the display panel and the indicator lamp of the A button is off. Remo ving laundry/switching of f the appliance 1.
en Setting the signal 20 M Setting the signal S e t t i n g t h e s i g n a l You can change the following settings: ■ The volume of the buttons and information signals (e.g. at the end of the program) and/or ■ The volume of the button signals. You will need to activate the setting mode in order to change these settings.
Cleaning and maintenance en 21 Machine housing/control panel ■ Wipe the housing and the control panel with a soft, damp cloth. ■ Remove the detergent residue immediately. ■ Do not clean with a water jet. Drum Use chlorine-free cleaning agents, do not use steel wool.
en Cleaning and maintenance 22 4. Take the drain hose out of the retainer. Remove the sealing cap, allow the detergent solution to flow out into a suitable container. Replace the sealing cap and place the drainage hose in the retainer. 5. Carefully unscrew the pump cover, residual water may leak out.
Faults and what to do about them. en 23 Remove the hose from the rear of the appliance. Use pliers to remove the filter and then clean it. 7. Connect the hose and check for leaks. 3 Faults and what t o do about them. F a u l t s a n d w h a t t o d o a b o u t t h e m .
en Faults and what to do about them. 24 Information on the displa y panel Display Cause/Remedy è lights up ■ The temperature is too high. Wait until the temperature drops. ■ The water level is too high. It is not possible to add laundry. Close the door immediately, if necessary.
Faults and what to do about them. en 25 Faults and what t o do about them. Faults Cause/Remedy Water is leaking from the machine. ■ Attach the drain hose correctly or replace it. ■ Tighten the screw connection of the drain hose. The machine is not filling with water.
en Faults and what to do about them. 26 Odours in the washing machine. Depending on the model, run the ¾ Drum Clean or i Cottons 90 °C pro- gram without laundry. Add washing powder or a detergent containing bleach. Note: To prevent foaming, only use half the amount of detergent recommended by the detergent manufacturer.
After-sales service en 27 4 Af ter -sales ser vice A f t e r - s a l e s s e r v i c e If you cannot rectify a fault yourself, contact customer services. ~ Cover page We will always find an appropriate solution in order to avoid unnecessary visits by engineers.
en Positioning and connecting 28 In addition , a hose clamp (24 - 40 mm diameter, available from specialist dealers) is required to connect the water drain hose to a siphon.
Positioning and connecting en 29 Installation sur face Note: The washing machine be stable so that it does not move around. ■ The installation surface must be firm and level.
en Positioning and connecting 30 Remove the sleeves. To do this, remove the mains cable from the holders. 3. Fit the covers. Lock the covers firmly in place by applying pressure to the snap-in hooks.
Positioning and connecting en 31 ■ Do not use a used supply hose. Only use the supply hose supplied or one that was purchased from an authorised specialist retailer. ■ Do not bend, squash, modify or cut through the water supply hose (otherwise its strength is no longer guaranteed).
en Positioning and connecting 32 Connection to the appliance Connection of hot water appliances only to cold water If there is no hot water connection, you need a Y-piece, available from customer service with single part number: 050871.
Positioning and connecting en 33 ■ Outlet into a plastic pipe with rubber bushing or into a drainage pit Lev elling Level the appliance using a spirit level. Incorrect levelling may result in intense noise, vibrations and "wandering". 1. Loosen the lock nuts using a wrench, by turning it in a clockwise direction.
en Positioning and connecting 34 Before washing f or the first time The washing machine was thoroughly tested before leaving the factory. To remove any water that may be left over from the test, run the first wash cycle without any laundry. Not es ■ The washing machine must be correctly installed and connected .
Positioning and connecting en 35 ■ To prevent unused detergent from flowing straight into the drain during the next wash: Pour approx. 1 litre of water into compartment II and start the [ Drain/Empty program.
Robert Bosch, Hausgeräte GmbH Carl-Wery-Straße 34 81739 München DEUTSCHLAND *9000979140* 9000979140 (9408) Aqua-Stop warranty Only for appliances with Aqua-Stop In addition to warranty claims against the vendor based on the purchase agreement and to our appliance warranty, we will provide compensation under the following conditions: 1.
An important point after buying a device Bosch WAT28460GB (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Bosch WAT28460GB yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Bosch WAT28460GB - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Bosch WAT28460GB you will learn all the available features of the product, as well as information on its operation. The information that you get Bosch WAT28460GB will certainly help you make a decision on the purchase.
If you already are a holder of Bosch WAT28460GB, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Bosch WAT28460GB.
However, one of the most important roles played by the user manual is to help in solving problems with Bosch WAT28460GB. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Bosch WAT28460GB along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
