Instruction/ maintenance manual of the product DHE645M Bosch
Go to page of 16
en Operating and Installat ion instruct ions DH E 635... / DH E 645... Internet : http://www.bosch-hausgeraete.de Bosch Info- T eam: de T el. 01 80/5 30 40 50 ( E 0, 1 2/ Min.
2 min. 650 min. 650 min. 470 min. 650 GAZ ELECTR. 9000.022 729.qxd 12.10.2006 9:34 Uhr Seite 2.
If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the roo m. An air -intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded.
4 ❑ Before using your appliance for the first time, please read these Instructions for Use carefully . They contain important information concerning your personal safety as well as on use and care of the appliance. ❑ Please retain the operating and installation instructions for a subsequent owner .
5 Using the extractor hood ❑ Switching on the extractor hood when you start cooking. ❑ Switching off the extractor hood a few minutes after you have finished cooking. Switching on the fan: ❑ Open the door . ❑ Select fan speed. Switching off the fan: ❑ Close the door .
Filters and maintenance Differ ent grease filters can be used to absorb the grease particles in kitchen vapour . Fleece grease filter: The filter mat consists of highly flameresistant material. Attention: A build up of greasy r esidue increases flammability , and the function of the extractor hood may be impaired.
Filters and maintenance Fitting grease filters: 1. Clamp in the filter mats with the wire grid. 2. Position the filter screen against the housing and push upwards. Push in the lower edge over the lugs and lower the grid into place. Check that the filter screen is secur ely located behind the retaining brackets on both sides.
8 Filters and maintenance Activated carbon filter: For binding odours in recir culating air mode. Fitting and removal: 1. Open door to the stop. 2. Push the filter screen up slightly , lift it towards you over the brackets and take it out downwards. 3.
9 1. Switch off the extractor hood and deenergize by pulling out the mains plug or switching off the fuse. 2. Press the edges of the lamp cover together where indicated and lift it out towards you. 3. Replace the bulb (standard filament bulb, max 40 W , E14 bulb holder).
10 Important information Before installation Optimum efficiency of the extractor hood: ❑ Short, smooth exhaust pipe. ❑ As few bends as possible. ❑ Pipe diameter as large as possible (ideally 150 mm dia.
11 Before installation Exhaust-air mode The exhaust air is discharged upwards through a ventilation shaft or dir ectly through the outside wall into the open. Exhaust air must not be discharged via a smoke or exhaust gas flue which is already in use or via a shaft which is used for ventilating rooms in which fir eplaces are located.
12 Before installation With exhaust mode , a backwash valve should be installed unless it is already in- corporated in the exhaust pipe or wall box. If a backwash valve is not included with your appliance, your dealer can supply you with one (see accessories).
13 WARNING: THIS APPLIANCE MUST BE EARTHED IMPORT ANT : Fitting a Different Plug: The wires in the power cor d are colourcoded as follows: Green and Y ellow – Earth Blue – Neutral Brown – Live If you fit your own plug, the colours of these wires may not corr espond with the identifying marks on the plug terminals.
The extractor hood can also be installed slightly lower , depending on the height of the wall cupboards. Position the template correspondingly lower . Observe the minimum distance from hob to extractor hood of 650 mm (the fixing screws must be fitted at least 1040 mm above the hob ).
5. The two screws to the right and left inside the housing can be used to adjust door gliding according to the weight of the door . T ur ning the screws clockwise will make the door more dif ficult to move. Mounting wall covering rail: The gap between the hood and the rear wall can be dressed with the enclosed covering rail.
9000 022729 Robert Bosch Hausgeräte GmbH Printed in Germany 1006 Hi. DHZ2100 DHZ6201 DSZ1 1AF 086244 088208 DHZ6501 9000.022 729.qxd 12.10.2006 9:35 Uhr Seite 16.
An important point after buying a device Bosch DHE645M (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Bosch DHE645M yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Bosch DHE645M - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Bosch DHE645M you will learn all the available features of the product, as well as information on its operation. The information that you get Bosch DHE645M will certainly help you make a decision on the purchase.
If you already are a holder of Bosch DHE645M, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Bosch DHE645M.
However, one of the most important roles played by the user manual is to help in solving problems with Bosch DHE645M. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Bosch DHE645M along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
