Instruction/ maintenance manual of the product COH-ED BKI
Go to page of 20
INST ALLA TION AND OPERA TING INSTRUCTIONS FULL SIZE (CO1-E) & 1/2 SIZE (COH-E) ELECTRIC CONVECTION O VENS Models: CO1-E and COH-E INTENDED FOR OTHER THAN HOUSEHOLD USE RET AIN THIS MANUAL FOR FUT.
INDEX INST ALLA TION INSTRUCTIONS SECTION ITEM P AGE 1 Receiving 2 2 Location & Minimum Clearances 2 3A Set-Up & Mounting for COH-E1 3 3B Set-up & Mounting for CO1-E 3 4 E l e c t r i c a .
MINIMUM CLEARANCES C O H - E 1 C O 1 - E 1 I n c h e s m m I n c h e s m m R i g h t 1 2 5 1 2 5 L e f t 1 2 5 2 5 0 R e a r 1 2 5 1 2 5 Suitable for installation on combustible floors when installed on factory supplied legs or casters. 3A. SET -UP / MOUNTING FOR COH-E1 Counter-top installation must conform to one of the following methods: 1.
4 2. CO1-E2: INST ALLA TION / MOUNTING 6” LEGS a. After unpacking the unit, remove legs and any other material from inside the oven. b. Tilt the bottom oven onto its left side and attach the two mounting plates to the right underside using ½” bolts and washers and tighten firmly .
2. FIELD CONNECTIONS a. Remove access panel from the right side of the oven. b. Feed power cable (supplied by the customer) through the access hole in the rear of the oven and pull the cable to the front of the oven under the access panel where it may be attached to the cable support bracket.
7. STEAM INJECTION OPTION The solenoid valve for steam injection is mounted behind the service panel on the right hand side of the unit on COH-E and on the back of the unit on CO1-E. It is pre-wired at the factory . The electronic timer is pre-set at the factory .
3. COOK & HOLD ROT ARY CONTROL a. Close the oven door(s). b. T urn selector switch to “High” or “Low” position. The green indicator light near the selector switch will be illuminated. c. T urn the thermostat knob to the desired cooking temperature.
8 OVEN INTERIOR: Clean The Racks And Rack Support Guides: Open the doors and remove all wire racks and rack support guides. T ake them to the sink and thoroughly clean in warm water with mild detergent or soap. Use a nylon scouring pad or stiff nylon brush.
4. SERVICING 1. The power supply to the unit must be disconnected prior to service. 2. Most of the service to this unit can be performed from the front and/or the control panel side. 3. For proper service, access to the control panel side of the unit is required.
17 B L K 2 B L K A4 W H T C2 WHT A5 W H T A6 WHT 9 BLK 10 BLK H5 W H T H3 WHT H6 WHT 6 WHT 16 W H T 1 B L K COM NO L2 9 B L K 12 B L K S B L K A3BLK C1 BLK 13 WHT A3 BLK A4 WHT 4 3 2 P4 P3 P2 P1 BUZZE.
4- ALL POLES DISCONNECT MUST BE PROVIDED BY THE INSTA LLER RC 1 F, 250VAC m 1 F, 250V AC m m 1 F, 250V AC 2 SPEED 250V 10 B L U C2 BRN S B L U 2 B L U 2 B L U 1 B R N C1 BLU 17 B L U H5 B R N A5 B R N.
CO1-E F ull Size Electric Convection Oven Figure A Exterior / Interior / Elements / Controls / Door BR KS AE BR KS AE E R PI D E R PI D w S r i o t c o h D w S r i o t c o h D 1 2 3 4 5 6 7 8 9 10 11 .
Exterior / Interior / Elements / Controls / Door Item Part # Description Item Part # Description 1 E3450X Door Seal, To p & Bottom (2) 47 Q1407A Screw , Hx Hd, #10x1/2 2 E3451K Door Seal, Sides (2.
Figure B Door Chain / Legs & Open Rack Stand Part # Description Item Part # Description Steam Option (Not Shown) Door Chain Assy Legs & Open Rack Stand 1 2 3 4 6 7 8 10 11 12 13 14 15 16 17 18.
Figure A Exterior / Interior / Elements / Controls / Door 1 3 4 5 6 Co l o Co l o Dow n Dow n Up Se t l ec Se t le c M n u e M nu e S r ta t S r ta t S o p t S o p t Down Down g i He a t n g i He a t .
Exterior / Interior / Elements / Controls / Door I t e m P a r t # D e s c r i p t i o n I t e m Part # Description Optional Steam Injection (Not Shown) 1 E1 178K Outer Shell 44 U1 169A Motor Rotation Arrow , Label 2 E1 179K Outer Side (Right) 45 S1 195X Blower Wheel 3 E1 180X Access Cover Assy .
34 Figure B Door Latch / Electrical Components Item Part # Description Item Part # Description r Rea 1 2 3 5 4 8 6 7 9 10 12 13 14 15 16 17 19 21 20 22 23 24 25 26 29 30 31 27 32 33 24 28 18 1 U1210A .
NOTES: 18.
19 WHA T IS COVERED This warranty covers defects in material and workmanship under normal use, and applies only to the original pur chaser providing that: ♦ The equipment has not been accidentally o.
P h o n e : ( 8 6 4 ) 9 6 3 - 3 4 7 1 Fax: (864) 963-5316 T oll Free: (800) 927-6887 Website: www .bkideas.com E-mail: customerservice@bkideas.com BKI Worldwide Headquarters PO Box 80400 Simpsonville,.
An important point after buying a device BKI COH-ED (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought BKI COH-ED yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data BKI COH-ED - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, BKI COH-ED you will learn all the available features of the product, as well as information on its operation. The information that you get BKI COH-ED will certainly help you make a decision on the purchase.
If you already are a holder of BKI COH-ED, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime BKI COH-ED.
However, one of the most important roles played by the user manual is to help in solving problems with BKI COH-ED. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device BKI COH-ED along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
