Instruction/ maintenance manual of the product EGL-E30AS Zephyr
Go to page of 21
www .zephyronline.com Glide EGL-E30AS EGL-E36AS Guide d’utilisation, d’entretien et d’inst allation Use, Care, and Inst allation Guide Model number: Numéro de modèle: _________________________.
2 PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING . INST ALLA TION MUST COMPL Y WITH ALL LOCAL CODES. IMPORT ANT : Save these Instructions for the Local Electrical Inspector ’ s use. INST ALLER: Please leave these Instructions with this unit for the owner .
3 www .zephyronline.com T able of Contents Important safety Notice ..................................................................... 4 Electrical & Inst allation requirements ............................................. 5 Electrical requirements .
4 Import ant safety Notice CAUTION: FOR GENERAL VENTILA TING USE ONL Y . DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MA TERIALS OR V APORS. W ARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: A. Use this unit only in the manner intended by the manufacturer .
5 www .zephyronline.com Electrical & Inst allation requirement s ELECTRICAL REQUIREMENTS Important: Observe all governing codes and ordinances. It is the customer’s responsibility: • T o contact a qualified electrical inst aller .
6 List of Materials PARTS SUPPLIED: • Blower unit housing • Hood canopy • Metal filter x 1 • Halogen light bulb x 2 • Hardware Packet: Transition Allen spanner x 1 Lower bracket x 2 Upper Br.
7 www .zephyronline.com 21" 9" 1/16 9" 13/16 15/16" - 1" 3/4 30"-36" 2" 3/4 9" 13/16 Dimensions and clearances Cut out for venting system and conduit 1&quo.
8 Inst allation Instructions Closely follow the instructions set out in this manual. All responsibility , for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. VENTING METHODS The hood is equipped with a transition B for discharge of fumes to the outside ( Ducting version ).
9 www .zephyronline.com Inst allation - Ductwork Calculation Sheet 3 1/4 ” x 10” Rect., straight 6 ” Round,, straight 7", 8” Round,, straight 3 1/4 ” x 10” Rect.90° elbow 3 1/4 ” x 10” Rect.45° elbow 3 1/4 ” x 10” Rect.90° flat elbow 3 1/4 ” x 10” Rect.
10 Inst allation 1. If possible, disconnect and move freestanding or slide-in range from cabinet opening to provide easier access to rear wall. Otherwise put a thick, protective covering over countertop, cooktop or range to protect from damage or dirt.
11 www .zephyronline.com 8. Fit the blower unit housing inside the cabinet through the bottom opening. Check that fixing springs goes over the bottom panel.. Bottom opening Bottom panel Fixing springs 9. Apply two brackets (one per side) to the blower unit housing.
12 ..... tighten securely the two screws on upper brackets, check that blower housing is now well blocked, then, from the inside of the hood, fix definitively the lower brackets with one screw each. Adjusting screws Upper + lower bracket definitive fixing screws 10.
13 www .zephyronline.com 12. Electrical connection W ARNING Electrical Shock Hazard W arning: T urn off power circuit at the service panel before wiring this unit.
14 Description of the hood 1 Control panel 2 Grease filter 3 Grease filter release handle 4 Halogen lamp (position and nr . of lamps may vary) 5 Sliding Glass 6 Hood canopy 6 1 2 3 4 5.
15 www .zephyronline.com Controls Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.
16 Maintenance CLEANING The cooker hood should be cleaned regularly internally and externally . For cleaning use the supplied cloth moistened with a neutral liquid detergents. Avoid abrasive detergents. Warning: Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the filters may cause fire risks.
17 www .zephyronline.com T rouble Shooting After inst allation, the unit doesn’t work? Light works, but motor is not turning. The unit is vibrating. The motor is working, but the lights are not. The hood is not venting out properly . Metal filter is vibrating.
18 W arranty T O OBT AIN SERVICE UNDER W ARRANTY : or any Service Related Questions, please call: 1-888-880-8368 S taple your receipt here. Proof of the original purchase date is needed to obtain service under the warranty . T O OBT AIN SERVICE UNDER W ARRANTY : Y ou must present proof of original purchase date.
19 www .zephyronline.com List of Part and Accessories Part Description Part# halogen bulb, 12V 20 W metal filter Part Description Part# Ductless Recirculating Kit charcoal replacement filter Z0B-0013 .
20.
21 www .zephyronline.com.
An important point after buying a device Zephyr EGL-E30AS (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Zephyr EGL-E30AS yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Zephyr EGL-E30AS - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Zephyr EGL-E30AS you will learn all the available features of the product, as well as information on its operation. The information that you get Zephyr EGL-E30AS will certainly help you make a decision on the purchase.
If you already are a holder of Zephyr EGL-E30AS, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Zephyr EGL-E30AS.
However, one of the most important roles played by the user manual is to help in solving problems with Zephyr EGL-E30AS. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Zephyr EGL-E30AS along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
