Instruction/ maintenance manual of the product ZQF6114 Zanussi
Go to page of 20
FREEZER ZQF 6114 2222740-67 INSTRUCTION BOOKLET.
Children should be supervised to ensure that they do not play with the appliance. • There is a risk of suffocation! Keep packaging material away from children! General Safety • This appliance contains hydrocarbons in it s cooling unit; maintenance and recharging must therefore only be carried out by authorised technicians.
3 Maintenance and Cleaning • Before cleaning, always switch off the appliance and disconnect from the electrical supply . • When unplugging always pull the plug from the mains socket, do not pull on the cable. Servicing • This product should be serviced by an authorised engineer and only genuine spare part s should be used.
4 T emperature acoustic alarm This appliance incorporates an alarm which gives off an audible signal whenever the warning light comes on. This signal can be temporarily stopped by depressing the push button for fast-freezing (4). The fast-freezing push button can be released as soon as the warning light is off.
Frozen food storage When you first start the freezer or if the freezer has been out of use for some time, we advise you to run your appliance for at least two hours in the «fast freeze» mode before storing frozen food.
Important In the event of a power failure causing the temperature within your freezer to rise, do not re- freeze the food without checking its condition. The following guidelines should assist you: Ice-cream: once thawed should be discarded. Fruits & V egetables: if soft should be cooked and used up.
Defrosting Maintenance and Cleaning W arning Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply . Important This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians.
8 Something not W orking? Before contacting your local Service Force Centre check the following points. IMPORT ANT : If you call out an engineer to a fault listed below , or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
9 Service and Sp are Part s In the event of your appliance requiring service, or if you wish to purchase spare part s, please contact your local Service Force Centre by telephoning:- 08705 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area.
10 St andard guarantee conditions We, Zanussi, undertake that if within 12 months of the date of purchase this Zanussi appliance or any p art thereof is proved to be defective by reason only of faulty.
11 DIMENSIONS Height 81,5 cm Width 59,6 cm Depth 55 cm POWER SUPPL Y VOL T AGE AND FREQUENCY 220-240 V / 50 Hz TOT AL POWER ABSORBED 90 W A VERAGE DAIL Y UNITS ELECTRICITY(*) 0,57 kWh GROSS CAP ACITY .
12 Door reversal T o reverse the opening direction of the door, proceed as shown in the figures: Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet.
13 If you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows: Connect the .
14 Building-in instructions Before carrying out any work, remove the plug from the power socket. Grid prep aration Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure).
15 B 4 1 5. Screw appliance into place and ret ain the cabinet with screws (I) through the securing brackets into the worktop or adjacent woodwork as necessary . 4. The joint cover (B) is to be assembled after having installed the appliance in the recess.
16 7 ab c C click click 8 b = = 9 I c Möbeltür Innenseite a Upper part of kitchen furniture panel I 27,5 cm 27,5 cm 55 cm 10 F 1 2 3 45 ° 11 = = 10 12 1 2.
17 Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. • For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments.
.
.
© Electrolux plc 2008 www .electrolux.com www .zanussi-electrolux.co.uk.
An important point after buying a device Zanussi ZQF6114 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Zanussi ZQF6114 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Zanussi ZQF6114 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Zanussi ZQF6114 you will learn all the available features of the product, as well as information on its operation. The information that you get Zanussi ZQF6114 will certainly help you make a decision on the purchase.
If you already are a holder of Zanussi ZQF6114, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Zanussi ZQF6114.
However, one of the most important roles played by the user manual is to help in solving problems with Zanussi ZQF6114. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Zanussi ZQF6114 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
