Instruction/ maintenance manual of the product ZEI6840FBV Zanussi
Go to page of 16
EN ZEI6840FBV User Manual Hob.
Contents Safety information 2 Safety instructions 3 Product description 5 Daily use 6 Hints and tips 8 Care and cleaning 9 Troubleshooting 10 Installation 11 Technical information 14 Energy efficiency 15 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
• Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. • Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. • Do not store items on the cooking surfaces.
• Make sure the mains cable or plug (if applicable) does not touch the hot appliance or hot cookware, when you connect the appliance to the near sockets • Do not use multi-plug adapters and extension cables. • Make sure not to cause damage to the mains plug (if applicable) or to the mains cable.
• Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Disposal WARNING! Risk of injury or suffocation. • Contact your municipal authority for information on how to discard the appliance correctly.
Sen- sor field Function Comment 1 ON / OFF To activate and deactivate the hob. 2 Lock / The Child Safety Device To lock / unlock the control panel. 3 - To select the cooking zone. 4 - Heat setting display To show the heat setting. 5 / - To set a heat setting.
pan, a cloth, etc.). An acoustic signal sounds and the hob deactivates. Remove the object or clean the control panel. • the hob gets too hot (e.g. when a saucepan boils dry). Let the cooking zone cool down before you use the hob again. • you use incorrect cookware.
connected to a single phase exceeds 3700 W. • The function decreases the power to the other cooking zones connected to the same phase. • The heat setting display of the reduced zones changes between two levels. Hints and tips WARNING! Refer to Safety chapters.
not proportional to the increase of the cooking zone consumption of power. It means that the cooking zone with the medium heat setting uses less than a half of its power. The data in the table is for guidance only. Heat setting Use to: Time (min) Hints 1 Keep cooked food warm.
Troubleshooting WARNING! Refer to Safety chapters. What to do if... Problem Possible cause Remedy You cannot activate or operate the hob. The hob is not connected to an electrical supply or it is connec- ted incorrectly. Check if the hob is correctly con- nected to the electrical supply.
Problem Possible cause Remedy The cookware is incorrect. Use the correct cookware. Refer to “Hints and tips” chapter. The diameter of the bottom of the cookware is too small for the zone. Use cookware with correct di- mensions. Refer to “Technical information” chapter.
H05BB-F Tmax 90°C. Speak to your local Service Centre. Attaching the seal 1. Clean the worktop around the cut out area. 2. Attach the supplied seal stripe to the lower edge of the hob along the outer edge of the glass ceramic. Do not extend it. Make sure that the ends of the seal stripe are located in the middle of one side of the hob.
R 5mm min. 55mm 560 +1 mm 490 +1 mm min. 38 mm min. 2 mm min. 12 mm min. 2 mm www.zanussi.com 13.
Protection box If you use a protection box (an additional accessory), the front airflow space of 2 mm and the protective floor directly below the hob are not necessary. The protection box accessory may not be available in some countries. Please contact your local supplier.
Energy efficiency Product information according to EU 66/2014 Model identification ZEI6840FBV Type of hob Built-In Hob Number of cooking zones 4 Heating technology Induction Diameter of circular cooking zones (Ø) Left front Left rear Right front Right rear 21.
www .zanussi.com/shop 867301887-A-262014.
An important point after buying a device Zanussi ZEI6840FBV (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Zanussi ZEI6840FBV yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Zanussi ZEI6840FBV - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Zanussi ZEI6840FBV you will learn all the available features of the product, as well as information on its operation. The information that you get Zanussi ZEI6840FBV will certainly help you make a decision on the purchase.
If you already are a holder of Zanussi ZEI6840FBV, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Zanussi ZEI6840FBV.
However, one of the most important roles played by the user manual is to help in solving problems with Zanussi ZEI6840FBV. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Zanussi ZEI6840FBV along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
