Instruction/ maintenance manual of the product ZEF 100 W Zanussi
Go to page of 16
FREEZER ZEF 100 W 2222693-08 INSTRUCTION BOOKLET.
General Safety ¥ This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorised technicians. ¥ T ake utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages.
Servicing ¥ This product should be serviced by an authorised engineer and only genuine spare parts should be used. ¥ Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning.
W arning light (red) If the temperature warning light ➃ lights up, it indicates that the temperature within the freezer has reached a level where safe food storage is no longer ensured. When the freezer is first switched on, the warning light will stay on until the temperature has dropped to a safe level for the storage of frozen food.
Normal Operating Sounds Y ou may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear , to the fixed freezer shelves. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor .
6 Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever .
The freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 1/4". During this operation it is not necessary to switch off the power supply or to remove the foodstuffs.
8 Maintenance and Cleaning Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly . NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHL Y PERFUMED CLEANING PRODUCTS OR W AX POLISHES, T O CLEAN THE INTERIOR AS THESE WILL DAMAGE THE SURF ACE AND LEA VE A STRONG SMELL.
9 Symptom Solution No power to appliance The temperature in the freezer is too high The freezer door will not open The compressor runs continuously Excessive frost and ice has built up. Noise - Check there is power at the socket. - Check there is not a power cut by checking the house hold lights.
10 Service and Spare Parts Customer Care Department For general enquiries concerning your Zanussi Electrolux appliance or for further information on Zanussi Electrolux products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www .
11 Standard guarantee conditions We, Zanussi Electrolux, undertake that if within 12 months of the date of purchase this ZANUSSI ELECTROLUX appliance or any part thereof is proved to be defective by r.
12 Installation Positioning For this appliance to work efficiently , it must not be located where the temperatures will fall below 10¡C (50¡F) or rise above 32¡C (90¡F), e.g. conservatories. For correct operation this appliance must be located in a dry atmosphere, away from heat sources, e.
Door Reversal 13 Before carrying out the operations described below , pull out the mains plug from the wall socket. T o carry out this reversal go through the following steps: 1. Gently lay the appliance on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing.
14 If you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows: Connect the .
.
© Electrolux plc 2003 922 721 758.
An important point after buying a device Zanussi ZEF 100 W (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Zanussi ZEF 100 W yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Zanussi ZEF 100 W - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Zanussi ZEF 100 W you will learn all the available features of the product, as well as information on its operation. The information that you get Zanussi ZEF 100 W will certainly help you make a decision on the purchase.
If you already are a holder of Zanussi ZEF 100 W, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Zanussi ZEF 100 W.
However, one of the most important roles played by the user manual is to help in solving problems with Zanussi ZEF 100 W. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Zanussi ZEF 100 W along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
