Instruction/ maintenance manual of the product SVV-200 Yamaha
Go to page of 16
1 Thank you for pur chasing the Y amaha Silent V iola. In order to obtain the maxi- mum performance and enjoyment fr om your Silent V iola, we urg e you to r ead this Owner’ s Manual thor oughly befor e using the instrument. Please k eep this Owner’ s Manual in a safe place for later r efer ence .
2 SPECIAL MESSAGE SECTION 92-BP This product utilizes batteries or an external power supply (adaptor). DO NOT connect this product to any power supply or adaptor other than one described in the manual, on the name plate, or specifically recommended by Yamaha.
3 Your Silent Viola will give you years of reliable service if you follow the simple rules given below: ■ Location Do not expose it to the following conditions to avoid deformation, discoloration, or more serious dam- age. • Direct sunlight (e.g. near a window).
4 Main Body/Accessories After opening the packaging, please check that all the parts listed below are in- cluded. • Viola • Bridge • Stereo earphones • 6F22 (S-006P) 9V battery x 1 2-SVV200_E/R1 03.
5 Nomenclatur e ● Front Tuning peg Nut Neck Fingerboard 4th string (C) 2nd string (D) 3rd string (G) 1st string (A) Frame Body Bridge Bridge seat Adjuster T ailpiece Chin rest End pin T ailpiece Wire 2-SVV200_E/R1 03.
6 ● Controls VOLUME POWER switch ON/OFF POWER lamp EQ MODE 1 : Green EQ MODE 2 : Red EQ CTRL (Equalizer control) Pickup balancer (located inside) EQ MODE switch (Equalizer mode switch) EQ MODE 1/EQ MODE 2 6F22 (S-006P) 9V battery PHONES jack : Stereo mini type LINE OUT jack : Standard phone type (monaural) 2-SVV200_E/R1 03.
7 Setup ■ Installing the Bridge The Silent Viola is shipped from the factory with the bridge unfitted. First, set up the bridge and then proceed with tuning. • The lower side of the bridge supports the 1st str ing (A), the higher side supports the 4th string (C).
8 ■ The Shoulder Rest Most standard size viola rests can be attached to the body of the Silent Viola. Shoulder rest • Do not over -tighten or over-loosen the adjuster . It may result in damage to the instrument or be a source of noise during perf ormance .
9 ■ Changing Strings As the strings get old, sound quality will gradually decrease, and it will become difficult to tune the instrument. Change the strings as soon as you think they are getting old. Always change the strings one at a time, even if all strings must be changed.
10 3 Insert the string into the hole on the peg and wind the string onto the peg. • On the 1st (A) and 2nd (D) strings , make two winds to ward the 3rd and 4th string side of the peg, then wind back o ver those winds and to the opposite side of the string hole.
11 Power Supply The Silent Viola is powered by a single 6F22 (S-006P) 9V battery . Before installing the bat- tery , make sure that the POWER switch (ON/OFF) located on the backside of the instrument is in its OFF position. Bij dit produkt zijn batterijen geleverd.
12 Using the Controls q PO WER Switch Used to switch the po wer ON/OFF . w V OLUME Used to control the volume. Rotate the knob to the right to increase the volume.
13 t Pic kup Balancer The Silent V iola's pickup system consists of separate sensors for low strings and high strings. Depending upon the type of strings and your playing style, you might want to adjust the balance of the high and low sensors. If so, please use the follo wing procedure.
14 y LINE OUT jack This jack (standard phone, monaural) deliv ers signal output of the Silent V iola’ s tone. Use an audio cable to connect the instrument to the audio input jack of po w ered speakers, mixing console, cassette player , etc. to listen from external audio equipment or recording.
15 Example Connections Silent Viola Stereo Earphones Electronic Tuner When connecting the instrument to e xternal audio equipment, check the jac k size and make sure to use a plug size that corresponds to the jack being used, and properly connect the cable to the jac k.
16 Specifications Nec k Hard Maple Body Spruce Fingerboard/T uning P egs Ebony Bridge Hard Maple (Aubert) Frame Plywood Chin Rest/T ailpiece Ebony Adjuster 1st string (Wittner) Strings Ball-end type (.
An important point after buying a device Yamaha SVV-200 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Yamaha SVV-200 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Yamaha SVV-200 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Yamaha SVV-200 you will learn all the available features of the product, as well as information on its operation. The information that you get Yamaha SVV-200 will certainly help you make a decision on the purchase.
If you already are a holder of Yamaha SVV-200, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Yamaha SVV-200.
However, one of the most important roles played by the user manual is to help in solving problems with Yamaha SVV-200. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Yamaha SVV-200 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
