Instruction/ maintenance manual of the product EMX88s Yamaha
Go to page of 34
Owner’s Manual E Keep This Manual For Future Reference..
EMX88S/EMX68S 1 The Owner’ s Manual Revisions Thank you for pur chasing the Y amaha EMX88S/EMX68S P o wered Mix er . P arts of the EMX88S, EMX68S owner’ s manual hav e been rev ised. Please refer to the following revisions rather than the corresponding sections of the original owner’ s manual.
6 EMX88S/EMX68S ■ Block and Level diagram CH INPUT (CH1-2) (CH1-4) CH INPUT (CH3-4) (CH5-6) CH INPUT (CH5-6) (CH7-8) Hi-Z [–40/–10dB] Low-Z [–50/–20dB] Low-Z [–50/–20dB] LINE [–10dB] M.
FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.
3 EMX88S/EMX68S—Owner’s Manual Precautions WARNING • Connect this unit’ s power c o r d only t o an AC outlet of the t ype stated in this Owner’ s M anual or as marked on the unit. Failur e to do so is a fire and electrical sho ck hazard. • Do not allow water to enter this unit or allow the unit to become wet.
4 Precautions EMX88S/EMX68S—Owner’s Manual.
5 EMX88S/EMX68S—Owner’s Manual Introduction Thank you for pur chasing the Y amaha EMX88S/EMX68S P owered M ixer . The EMX88S/EMX68S has the following features.
6 EMX88S/EMX68S Quick Guide EMX88S/EMX68S—Owner’s Manual EMX88S/EMX68S Quick Guide The following steps (1–5) explain the basic c on- nection and operation of the EMX88S/EMX68S. Also , please read “Fr ont and Rear P anel” and “Basic Operation ” following this Quick Guide section to learn more about using the EMX88S/ EMX68S.
EMX88S/EMX68S Quick Guide 7 EMX88S/EMX68S—Owner’s Manual Connecting a microphone Mak e sure that the powe r is tur ned off to the EMX88S/EMX68S. Connect a micr ophone to the Low-Z jack or MIC jack. Using a condenser microphone T ur n on the PHANT OM switch (located in the upper right corner on the panel).
8 EMX88S/EMX68S Quick Guide EMX88S/EMX68S—Owner’s Manual Connecting an electric acoustic guitar or electr ic bass Connect an electric acoustic guitar or electric bass to the Super H i-Z jacks. • If you wish to use a guitar signal processor or bass effect unit, connect them to the Hi-Z jack or LINE jack.
EMX88S/EMX68S Quick Guide 9 EMX88S/EMX68S—Owner’s Manual Sound output Set the MASTER contr ol in the MAIN section to “ √ √ √ √ , ” then while playing an inst rument co n- nected to a c.
10 Front and rear panel EMX88S/EMX68S—Owner’s Manual Front and rear panel Control panel ■ Channel section U se these controls t o adjust factors such as the equalization, (frequency response), volume, effect and monitor output level for the input sig- nal to each c hannel.
Control panel 11 EMX88S/EMX68S—Owner’s Manual ■ DIGIT AL EFFECT section This section allows y ou to turn the built-in digital effect on/off and to select the effect type. 7 PROGRAM selector This knob selects the effect ty pe for the internal digital effect.
12 Front and rear panel EMX88S/EMX68S—Owner’s Manual D 2TR IN control This adjusts the amount of signal that is sent from the 2TR IN jacks t o the stereo (MAIN L, R) bus. E MASTER control This contr ol adjusts the stereo (MAIN L, R) bus signal output level.
Control panel 13 EMX88S/EMX68S—Owner’s Manual ■ POWER AMP section He re y ou can select the oper ating mode of the powe r amp. Y ou can also check the operation of the limiter circuit.
14 Front and rear panel EMX88S/EMX68S—Owner’s Manual Input/output panel 1 Channel input jacks (Hi-Z, Low-Z) 1 – 6 (EMX88S), 1 – 4 (EMX68S) These are the input jacks for channels 1–6 (EMX88S), 1–4 (EMX68S).
Input/output panel 15 EMX88S/EMX68S—Owner’s Manual 4 EFFECT OUT jack The input of an exte r nal effect such as a dela y or echo can be co nnected to this jack. The signal adjusted by the EFFECT co nt r ol of each channel will be sent to the EFFECT bus, its level adjusted b y the EFFECT OUT control, and output from this jack.
16 Front and rear panel EMX88S/EMX68S—Owner’s Manual Rear panel 1 Speaker output jacks (SPEAKERS) Connect speak ers here. The EMX88S/EMX68S has two internal po wer amps. Ther e are three ways in whic h speakers can be connected t o the EMX88S/EMX68S.
Connections 17 EMX88S/EMX68S—Owner’s Manual Connections W hen connecting various dev ices, make sur e the cables and plug s ha ve the correct rating.
18 Connections EMX88S/EMX68S—Owner’s Manual ■ When the power amp select switch is set to MAIN (L+R) BRIDGE: • Bridge connection Connect only one 8–16 ohm speak er t o the BRIDGE jack. The speak er will output the combined signal of the MAIN L bus + R bus.
Connections 19 EMX88S/EMX68S—Owner’s Manual ■ Example connections 88 Cassette Deck Foot switch (YAMAHA FC5) Microphone Monitor Speakers Main Speakers Synthesizer, Drum Box Power amp Effect Processor CD Player * Speakers normally connect to the jacks on the rear panel.
20 Basic Operation EMX88S/EMX68S—Owner’s Manual Basic Operation This section explains basic operation of the EMX88S/EMX68S. Connecting microphones and instruments 1 Before connecting mics or instruments, make sure that the power of all equip- ment (where applicable) is turned off.
Using the digital effect 21 EMX88S/EMX68S—Owner’s Manual * The LED can not blink an y f aster than an inter val of 256 ms (234.3 bpm). No. Program Description Controllable parameter Parameter V ariable range REVERB HALL Re verberation simulating a spacious e xpanse such as a concer t hall.
22 Example setups EMX88S/EMX68S—Owner’s Manual Example setups This section pro v ides some ways in whic h the EMX88S/EMX68S can be used, and explains c onnections and operation. As a conference P A system/installed sound system This example shows the EMX88S/EMX68S used as a c onference P A system or sound system.
As a band PA 23 EMX88S/EMX68S—Owner’s Manual As a band P A Her e is an example of using the EMX88S/EMX68S as a small P A for a band. I n this example, an external effect such as dela y or reve r b is also being used.
24 Example setups EMX88S/EMX68S—Owner’s Manual • Connect mics or instruments, such as k eyboards, to the channel input jacks. • Connect the main speakers to the SP EAKERS A, B 1/2 jacks and the monitor speak ers.
Installing an optional rack mount kit 25 EMX88S/EMX68S—Owner’s Manual Installing an optional rack mount kit Y ou can rack-mount the EMX88S/EMX68S using an optional rack mount kit (RK-88).
26 Troubleshooting EMX88S/EMX68S—Owner’s Manual T roubleshooting The following table describes the possible malfunctions of this dev ice, and the appropriate actions t o be taken in each case. Powered Mixer Q&A Prob lem Cause Action Sound is no longer out- put from the speakers .
Specifications 27 EMX88S/EMX68S—Owner’s Manual Speci fi cations ■ General speci fi cations Maximum output po wer MAIN L, R: 400 W+400 W/4 Ω @0.
28 Specifications EMX88S/EMX68S—Owner’s Manual ■ Input speci fi cations ■ Output speci fi cations • All output jacks are unbalanced. • 0 dB=0.775 Vrms, 0 dBV=1 Vrms. Specifications are subject to c hange w ithout prior notice. For E uropean M odel Pur chaser/U ser Information specified in EN55103-1 and EN55103-2.
Dimensions 29 EMX88S/EMX68S—Owner’s Manual ■ Dimensions 482 305 328 Unit: mm.
30 Specifications EMX88S/EMX68S—Owner’s Manual ■ Block and Level diagram CH INPUT (CH1-2) (CH1-4) CH INPUT (CH3-4) (CH5-6) CH INPUT (CH5-6) (CH7-8) Hi-Z [ – 40/ – 10dB] Low-Z [ – 50/ – 2.
.
YAMAHA CORPORATION V832100 R0 1 AP 32 Pro Audio & Digital Musical Instrument Division P.O. Box 3, Hamamatsu, 430-8651, Japan NP Printed in Taiwan.
An important point after buying a device Yamaha EMX88s (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Yamaha EMX88s yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Yamaha EMX88s - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Yamaha EMX88s you will learn all the available features of the product, as well as information on its operation. The information that you get Yamaha EMX88s will certainly help you make a decision on the purchase.
If you already are a holder of Yamaha EMX88s, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Yamaha EMX88s.
However, one of the most important roles played by the user manual is to help in solving problems with Yamaha EMX88s. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Yamaha EMX88s along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
