Instruction/ maintenance manual of the product AX-392 Yamaha
Go to page of 16
Natural Sound Stereo Integrated Amplifier Préampli/ampli de puissance stéréo de la série “Natural Sound” Natural Sound Stereo-V erstärker Natural Sound Integrerad Stereo Förstärkare Amplifi.
2 ● Remote Control Transmitter ● Emetteur de télécommande ● Fernbedienung ● Fjärrkontroll ● Telecomando ● Transmisor del control remoto ● Afstandbediening ● Batteries (size AA, R6, .
3 English Thank you f or selecting this Y AMAHA stereo amplifier . ● 60W + 60W (8 Ω ) RMS Output P ower , 0.04% THD, 20–20,000 Hz ● High Dynamic P ower , Low Impedance Drive Capability ● Con.
4 1. T o assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2. Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold.
5 English NO TES ABOUT THE REMO TE CONTR OL TRANSMITTER Battery installation Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes ● Use only AA, R6, UM-3 batteries for replacement.
6 CONNECTIONS Never plug in this unit and other components until all connections are completed. ● When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L , R (right) to R , “+” to “+” and “ – ” to “ – ”.
7 English Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed.
8 CONTR OLS AND THEIR FUNCTIONS FR ONT P ANEL 1 STANDBY/ON switch Press this switch to turn the power to this unit on. Press it again to turn this unit into the standby mode. Standby mode In this state, this unit consumes a very small quantity of power to receive infrared-signals from the remote control transmitter.
9 English B SPEAKERS switches Set the switch A or B (or both A and B ) for the speaker system (connected to this unit) you will use to the ON position. Set the switch for the speaker system you will not use to the OFF position. C Tone controls BASS Used to increase or decrease the low frequency response.
10 For Contr ol of This Unit 1 SLEEP timer key This unit is automatically turned into the standby mode one hour after this key is pressed (so that SLEEP indicator lights up). 2 POWER key Turns the power to this unit on and turns this unit into the standby mode alternately.
11 English 1 Set to the “ ∞ ” position. 2 Turn the power on. 3 Select a desired input source. The indicator for the selected source lights up. 4 Select the speakers to be used. * If you use two speaker systems, press both the A and B switches. 5 Play the source.
12 T O RECORD A SOURCE T O T APE (OR MD) BALANCE 55 4 3 2 l 0 l 2 3 4 LR LOUDNESS SLEEP AUX TAPE MD CD TUNER PHONO TAPE 6 BASS 55 4 33 22 ll 0 4 TREBLE 55 4 33 22 ll 0 4 NATURAL SOUND STEREO AMPLIFIER.
13 English Adjusting the B ASS and TREBLE contr ols Adjusting the B ALANCE contr ol Selecting the SPEAKER system Adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused from speaker location or listening room conditions.
14 If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help.
15 English SPECIFICA TIONS Minimum RMS Output Power per Channel 8 ohms, 20 Hz to 20 kHz, 0.04% THD ...................60W+60W 6 ohms, 20 Hz to 20 kHz, 0.08% THD ...................70W+70W Maximum Output Power (6 ohms, 1 kHz, 10% THD) [China and General models only] .
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A. YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.
An important point after buying a device Yamaha AX-392 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Yamaha AX-392 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Yamaha AX-392 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Yamaha AX-392 you will learn all the available features of the product, as well as information on its operation. The information that you get Yamaha AX-392 will certainly help you make a decision on the purchase.
If you already are a holder of Yamaha AX-392, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Yamaha AX-392.
However, one of the most important roles played by the user manual is to help in solving problems with Yamaha AX-392. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Yamaha AX-392 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
