Instruction/ maintenance manual of the product Buoyancy Compensator XS Scuba
Go to page of 24
EVERYTHING FOR THE PERFECT DIVE... Buo y ancy C ompensa t or Owner ’s Manual.
. 2 BC Owner’s Manual XS Scuba, Inc Warning / Disclaimer WARNING: This manual provides some basic guidelines for certain buoyancy control techniques using your XS Scuba Buoyancy Compensator (BC), but it is not a substitute for training from a professional diving instructor.
BC Owner’s Manual 3 . XS Scuba, Inc Table of Contents GENERAL WARNINGS & PRECAUTIONS........................................4 INTRODUCTION.........................................................................5 INTENDED USE & FUNCTION.....
. 4 BC Owner’s Manual XS Scuba, Inc General Precautions and Warnings • Do not use this Buoyancy Compensator (BC) if you have not received supervised instruction and certification in SCUBA diving and buoyancy control from a recognized training agency .
BC Owner’s Manual 5 . XS Scuba, Inc Introduction Thank you for choosing XS Scuba. Your new BC has been designed, manufactured and individually tested to ensure that it consistently meets the highest performance and safety standards possible.
. 6 BC Owner’s Manual XS Scuba, Inc S tandard F e a tures WARNING: A Buoyancy Compensator (BC) is NOT a life jacket! It is not designed to provide face-up flotation in all situations, and it does not meet U.S. Coast Guard regulations for a life preserver or personal flotation device (PFD).
BC Owner’s Manual 7 . XS Scuba, Inc vent air by pulling the power inflator straight down. It works best while you are in a vertical heads-up position or in a face-down swimming position.
. 8 BC Owner’s Manual XS Scuba, Inc Cylinder Band with Buckle This mechanism attaches your BC to your cylinder so that it is securely held at the desired height, without slipping. Some models are equipped with the exclusive Micro Pac™ and two cylinder bands for extra support.
BC Owner’s Manual 9 . XS Scuba, Inc Releasable T rim W eights If your BC is equipped with this feature, you will find two releasable weight compartments located on the backside of either the air cell or the harness – on opposite sides.
. 1 0 BC Owner’s Manual XS Scuba, Inc Preparation & Setup XS Scuba recommends that you bring your BC, together with your regulator, to your Authorized XS Scuba Dealer for the installation of the low pressure (LP) quick disconnect inflator hose that is provided with your BC.
BC Owner’s Manual 1 1 . XS Scuba, Inc 1. Ensure that the metal bale of the buckle is as close to the rear of the BC as possible. This provides the greatest range of adjustment. 2. With the buckle fully open, thread the cylinder band up the middle slot and back down through the slot closest to the metal bale.
. 1 2 BC Owner’s Manual XS Scuba, Inc Integrated Weight System Releasable Trim Weights To install weight in each compartment, unfasten the Velcro ® to open each flap.
BC Owner’s Manual 1 3 . XS Scuba, Inc same amount of weight in order to provide optimum balance in the water. You may otherwise experience a tendency to roll to one side if one pocket is more heavily loaded than the other.
. 1 4 BC Owner’s Manual XS Scuba, Inc T o install either pocket, slide the closed end into the opening of the compartment, with the band of loop Velcro ® facing up. Guide it firmly inward until the V elcro ® connection has fully engaged near the end of the compartment.
BC Owner’s Manual 1 5 . XS Scuba, Inc NOTE: Remember , adjusting the shoulder straps too tightly will transfer the cylinder weight from the hips onto the shoulders, and may restrict your arm movement. 5. Readjust the cummerbund, if necessary , so that it is comfortably snug but not restricting, with an overlap of at least 3 inches.
. 1 6 BC Owner’s Manual XS Scuba, Inc 4. Check the function of the oral inflator button, rapid exhaust valve (REV), and OPV to ensure a rapid and unobstructed exhaust from each valve. Fully inflate the BC once again, and disconnect the Power Inflator to listen for any leakage.
BC Owner’s Manual 1 7 . XS Scuba, Inc or if you use a different cylinder, BC, or exposure suit. Diving With an X-Lock™ Integrated Weight System It is important to remember that the X-Lock™ Integ.
. 1 8 BC Owner’s Manual XS Scuba, Inc Power Inflation To connect the LP hose, grip the grooved sleeve at the connection fitting between your thumb and forefinger, and slide the sleeve back. Place the fitting over the inflator valve QD nipple, and firmly push inward while releasing the sleeve.
BC Owner’s Manual 1 9 . XS Scuba, Inc NOTE: Depressing the oral inflator while the BC is empty may allow water to enter the air cell. Venting With the REV Inside the power inflator’s corrugated hose is a cable that attaches the power inflator to the rapid exhaust valve at the top of the airway assembly.
. 2 0 BC Owner’s Manual XS Scuba, Inc Post Dive Care & Maintenance With proper care, your XS Scuba BC will provide many years of reliable service. The following preventative maintenance must be performed to extend the life of your BC: • Avoid prolonged exposure to direct sunlight and extreme heat.
BC Owner’s Manual 2 1 . XS Scuba, Inc Safety Tube (part no. AC190) This high-visibility surface signal device can be inflated to a length of 6’, and is carried inside a compact 5”x35” nylon mesh bag that can be clipped to your BC or stored in a pocket.
. 2 2 BC Owner’s Manual XS Scuba, Inc Limited Two-Year Warranty XS Scuba, Inc. warrants to the original owner, this product to be free of defects in materials and/or workmanship for a period of two years from date of original purchase. Warranty applies only under normal sport and skin diving use and with proper care and maintenance.
BC Owner’s Manual 2 3 . XS Scuba, Inc the supervision of an instructor, could lead to serious injury or death. This warranty gives you specific legal rights. You may have rights, which vary from state to state and country to country. XS SCUBA DISCLAIMS AND EXCLUDES ANY LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
2740 S. Harbor Blvd., Suite E Santa Ana, CA 92704 tel: 714.424.0434 fax: 714.424.0454 www.XSscuba.com ©2005 XS Scuba, Inc..
An important point after buying a device XS Scuba Buoyancy Compensator (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought XS Scuba Buoyancy Compensator yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data XS Scuba Buoyancy Compensator - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, XS Scuba Buoyancy Compensator you will learn all the available features of the product, as well as information on its operation. The information that you get XS Scuba Buoyancy Compensator will certainly help you make a decision on the purchase.
If you already are a holder of XS Scuba Buoyancy Compensator, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime XS Scuba Buoyancy Compensator.
However, one of the most important roles played by the user manual is to help in solving problems with XS Scuba Buoyancy Compensator. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device XS Scuba Buoyancy Compensator along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
