Instruction/ maintenance manual of the product jazz 300 Xantrex Technology
Go to page of 32
T el: 604.422.8595 1.800.670.0707 Fax: 604.420.1591 1.800.994.7828 Email: support.jazz@xantrex.com W eb: www .xantrex.com 445-0120-01-01 Printed in China.
Trademarks and Disclaimer Jazz is a trademark of Xantrex International. Xantrex is a registered trademark of Xantrex T echnology Inc. © 2001 Xantrex International. All rights reserved. Jazz 3 00 Owner s Guide © April 2001 Xantrex International. UNLESS SPECIFICALL Y AGREED TO IN WRITING , XANTREX TECHNOLOGY INC.
Contents Safety First .......................................................................... 1 1 Introduction ........................................................................ 4 2 Installation Guidelines ................................
.
1 Safety First Incorrect installation or misuse of the Jazz 300 may result in danger to the user or hazardous conditions. W e urge you to pay special attention to all CAUTION and W ARNING statements. CAUTION statements identify conditions or practices that may result in damage to the Jazz 300 or to other equipment.
2 WARNING! Heated surface. · The Jazz 300 s housing may become uncomfortably w arm, reaching 140°F (60°C) under extended high power operation. Ensure at least 2 inches (5 cm) of air space is maintained on all sides of the Jazz 300. During operation, keep away from materials that may be affected by high temperatures.
3 CAUTION! Do not use the Jazz 300 with the following equipment: · Small battery oper ated products such as rechargeable flashlights, some rechargeable shavers, and night-l ights that ar e plugged directly into an AC receptacle to recharge. · Certain battery chargers for battery packs used in hand powered tools.
4 1 Introduction Thank you for purchasing the Jazz TM 300 Power Inverter . The Jazz 300 is a compact and highly portable power inverter from Xantrex, the leader in the field of high frequency inverter design.
5 Safety Features These advanced safety features are built into the Jazz 300: · Electronic overload protection with automatic shutdown. · Built-in internal backup DC fuse provides added safety . · Low battery voltage warning followed by automatic shutdown.
6 2 Installation Guidelines Selecting a Suitable Location For safe and optimum performance, install the Jazz 300 in a location that is Dry . Do not expose to water drip or spray . Cool . Operate only in ambient temperatures between 32°F (0°C) and 104°F (40°C).
7 Using the DC Cable-Plug Due to limitations in the common 12-volt outlet in a vehicle or boat, the Jazz 300 should only be used to supply AC power to products that require 150 watts (about 1.
8 Using the DC Cable-Clips By directly connecting the Jazz 300 to a 12-volt battery with the DC Cable-Clips , you can operate products with power requirements up to 240 watts continuous. If you want to permanently connect the Jazz 300 to a battery , contact Xantrex customer service (see Contact Information ).
9 3 Using the Jazz 300 The Jazz 300 is capable of continuously powering most 120-volt AC products that use 240 watts or less. Its AC output waveform, called modified-sine wave, is designed to function similarly to the sine wave shape of utility power .
10 Figure 1 - Features and Accessories.
11 Indicators and Controls (see Figure 1) · T wo AC outlets are provided on one end of the Jazz 300. Any combination of 120-volt AC products with a total continuous power consumption of 240 watts or less may be plugged in. · The ON/OFF switch enables output AC power at the AC outlets when switched ON.
12 3. As the battery charge is used up, battery voltage begins to fall. When the Jazz 300 senses that the voltage at its DC input has dropped to 10.7 volts, an audible alarm sounds. This allows time for computers or other sensitive devices to be shut down.
13 6. If the Jazz 300 exceeds a safe operating temperature, due to insuf ficient ventilation or a high temperature environment, it will automatically shut down.
14 Battery Operating Time Operating time will vary depending on the char ge level of the battery , its capacity and the power level drawn by the particular AC load. With a typical vehicle battery and a 100-watt load (such as a small TV), an operating time of 23 hours or more can be expected.
15 Interference with Electronic Equipment Generally , most AC products operate with the Jazz 300 just as they would with household AC power . Below is information concerning two possible exceptions.
16 4 Troubleshooting PROBLEM: AC product will not operate, no inverter lights are ON. PROBLEM: Inverter will run some small loads, but not larger ones. Possible Cause Battery is defective. Inverter has been connected with reverse DC input polarity . Loose cable connections.
17 PROBLEM: Measured inverter output is too low. PROBLEM: Alarm is sounding. Possible Cause Standard average-reading AC voltmeter used to measure output voltage, resulting in an apparent reading 5 to 15 volts too low . Battery voltage is too low .
18 PROBLEM: Battery run time is less than expected. Possible Cause AC product power consumption is higher than rated. Battery is old or defective. Battery is not being properly charged. Power dissipation in DC cables. Suggested Remedy Use a larger battery to make up for increased power requirement.
19 PROBLEM: AC product will not operate, red FAULT light ON. Possible Cause AC product(s) connected are rated at more than 240 watts; overload shutdown has occurred. AC Product is rated less than 240 watts; high starting surge has caused overload shutdown.
20 5 Limited Warranty (USA and Canada only) What Does This Warranty Cover? Xantrex manufactures its products from parts and components that are new or equivalent to new , in accordance with industry standard practices. This warranty covers any defects in workmanship or materials.
21 What Will Xantr ex Do? At its option, Xantrex will repair or replace the defective product free of charge. Xantrex will, also at its option, use new and/or reconditioned parts made by various manufacturers in performing warranty repair and building replacement products.
22 Y ou must obtain a Return Material Authorization (RMA) number from Xantrex before returning a product directly to Xantrex. Do not return a product to Xantrex without first obtaining an RMA number .
23 For Our Canadian Customers: When used herein implied warranties of merchantability and fitness for a particular purpose includes all warranties and conditions, express or implied, statutory or otherwise, including without limitation implied warranties and conditions of merchantability and fitness for a particular purpose.
24 6 Out-Of-Warranty Service Information If the warranty period for your Jazz 300 has expired, if the unit was damaged due to misuse, incorrect installation or if other conditions of the warranty have not been met, or if no dated proof of purchase is available, your unit may be serviced/replaced for a minimum flat fee of $35.
25 7 Specifications AC output voltage (nominal) 1 10 V ac DC input voltage range 1015 Vdc Continuous AC output power 240 W 30-minute AC output power 300 W Maximum AC output surge power 500 W AC output frequency 60 ± 4 Hz AC output waveform modified sine wave Battery drain with no AC load (at 12V input) 0.
26 Low battery alarm trigger point (nominal) 10.7 V Low battery shut down point (nominal) 10.0 V High battery shut down point (nominal) 15 V Dimensions (L x W x H) 5.1 x 3.7 x 1.9 in 129 x 94 x 49 mm W eight 1.2 lbs / 550 g Specifications subject to change without notice.
27.
T el: 604.422.8595 1.800.670.0707 Fax: 604.420.1591 1.800.994.7828 Email: support.jazz@xantrex.com W eb: www .xantrex.com 445-0120-01-01 Printed in China.
An important point after buying a device Xantrex Technology jazz 300 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Xantrex Technology jazz 300 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Xantrex Technology jazz 300 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Xantrex Technology jazz 300 you will learn all the available features of the product, as well as information on its operation. The information that you get Xantrex Technology jazz 300 will certainly help you make a decision on the purchase.
If you already are a holder of Xantrex Technology jazz 300, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Xantrex Technology jazz 300.
However, one of the most important roles played by the user manual is to help in solving problems with Xantrex Technology jazz 300. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Xantrex Technology jazz 300 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
