Instruction/ maintenance manual of the product 100-100621 Xanté
Go to page of 31
100-100621.
2 T rademarks XANTÉ ® is a registered trademark of XANTÉ CORPORA TION. Ad obe®; A dobe® P ageM aker®; A dobe® P ostScript®, the P ostScript®, and A dobe® logos ar e registered trademarks of Adobe S ystems Inc orporated. A dobe® A crobat™ is a trademark of A dobe Syste ms Inc orporated which may be register ed in certain jurisdictions.
3 T rademarks ......................................................... 2 Getting Star ted ................................................... 4 Re moving the Printer ................................... 4 Installing T oner C ar tridges ...............
4 Getting Star ted Re moving the Printer Fig. 1 R e mov ing the P rinter Al ways use two people to lift the printer . Plac e pr inter on a stable surface with adequate ventilation and operation clearance.
5 Installing T oner Cartr idges SealingT ape Ta b Fig. 2 S hake toner cartr idge. Cover Fig. 3 R emove orange protective cover . Getting Started ( continued ) Front Cover Front Cover Latch Fig. 4 Open front cover . K Y M C Toner Cartridge Fig. 5 Align and insert each cart ridge into it’ s corresponding color slot.
6 Guide OPC Guide Gear Fig. 8 Align the OPC cartr idge ’ s side tabs w ith the printer’ s OPC guides. Then, lower cartr idge into place and close guides. Getting Started ( continued ) Installing the F user Oil Bottle Oil Bottle Locks Cleaning Roller Locks Front of Printer Fig.
7 Width Guide Fig. 15 Adjust width guide. Media Loading Limit Mark P APER LABEL OHP FILM Fig. 16 Load media print side up . Getting Started ( continued ) Cassette Cover Paper Cassette Fig. 17 R eplace the casse tte cover . Paper Cassette Cassette Cover Fig.
8 LocalT alk Connection (Macintosh) Connector Box Connector Box T erminating Resistor RJ-1 1 Cable DIN-8 Connector Fig. 20 L ocalT alk Connector Boxes, Resistors, and Cable 1. T urn off your computer . 2. Plug the DIN-8 connector on o ne LocalT alk connector bo x into the printer’ s 8-pin LocalT alk por t.
9 3. Plug the other connect or (either a 25-pin or a 9-pin female co nnector) into the c omputer’ s serial por t. Ethernet Connection (PC and Mac) 10BaseT or 10/100BaseT Unshielded T wisted Pair (UTP) RJ-45 Fig. 23 C onnect to Ethernet port. Getting Started ( continued ) 1.
10 A dobe A crobat Reader -PC Y ou will need to install A dobe A crobat Reade r to view or print your printer docu- mentation. Fig. 27 Select So ftware Utilities: Adobe A crobat Reader . Installing A dob e A crobat R eader Fig. 28 Acrobat R eader Setup; click Next Fig.
11 Not e: If you ar e online, a caution window appears which allows you t o quit Netscape N avigator or Internet Explor er if they are running. In this case, click Quit Applications. Fig. 34 Caution W indow ; click Quit Applications. Fig. 35 I nstallat ion Progress Window Appears.
12 Fig. 37 Click I nstall Printer . Fig. 38 Make Appr opriate Select ions, Click OK. Fig. 39 E nter IP A ddress (Network Install only). Fig. 40 R ead Se tup Information. Click Y es. Fig. 41 R ead File D estination. Click Y es. Fig. 42 Choose Language.
13 Fig. 44 Read License A greement. Click A cce pt. Fig. 45 Choose Connection T ype. Click N ext. Not e: If your printer is dir ectly con- nected to y our computer , click “Local Printer” in figure 45; then, click N ext to continue to figure 46.
14 Fig. 49 R ead Current Setting s. Click I nstall. Fig. 50 Configur e Y our Printer . Click N ext. Fig. 51 Setup Complete. Click Finish. Fig. 52 R eadMe file.
15 Fig. 56 R ead Lice nse A g reement. Click Y es. Fig. 57 Select Location. Click Ne xt. Fig. 58 Select F o lder(s). Clic k Next. Fig. 59 Setup Complete. Click Finish. Not e: After you click Finish (fig. 59), a Rea dMe file windo w appears. Rea d it carefully and then close the window .
16 Fig. 62 Select Printer Model. Click N ext. Fig. 63 N ame Y our Printer . Click N ext. Fig. 64 R ead Current Setting s. Click, Install. Fig. 65 Configur e Y our Printer . Click N ext. Fig. 66 Select Dev ice Options to Configure your Printer . Click Apply , then OK.
17 Not e: If you selected t o read the Rea dMe file, do so and then, close the window . Configuring IP , SubNet, and Gateway A ddresses 1. Fr om the ps_files folder on the XANTÉ CD-R OM, c opy dhcpoff.ps to y our c: drive. 2. Go to DOS (Command) Pr ompt .
18 Fig. 69 Select Details T ab . 11. Select A dd P ort from the Details T ab (fig. 69). 12 . Select Other and highlight XanteLPR; then, click OK. Fig. 70 Highlight XanteLPR; click OK. Fig. 71 E nter IP A ddress and Queue N ame. 13 . Enter y our printer’ s IP address and Queue name; then, click OK (fig.
19 This section is the installation instructions for W indows NT/2000/XP only . IP A ddress Configuration W hen using the IP A ddress interface, use the keys on the fr ont panel to set the address as follows: • Reset key increases the current number flashing by one.
20 Fig. 77 R ead File D estination. Click Y es. Fig. 78 R ead W elcome W indow . Click N ext. Fig. 79 Select Local or N e twork. Click N ext. Fig. 80 Select LPT1 P ort. Click N ext. Fig. 81 Select Printer . Click Next. Fig. 82 Select K eep Ex isting Driver.
21 Fig. 85 Print T est P age. Click Next. Fig. 86 Setup Complete. Click Finish. Configuring IP , SubNet, and Gateway A ddresses 1. Fr om the ps_files folder on the XANTÉ CD-R OM, c opy dhcpoff.ps to y our c: drive. 2. Go to DOS (Command) Pr ompt . 3.
22 Fig. 87 Printer Properties W indow . Fig. 88 Select P orts T ab . 11. Select A dd P ort from the P orts T ab . 12. Highlight Standar d TCP/IP P or t ; then, click N ew P ort (fig . 89). Fig. 89 Highlight Standard TCP/IP P or t, click N ew P ort. 13.
23 Fig. 90 Dev ice Setting s W indow 4. Select Installed for each option your printer may ha v e; then, click Apply . 5. Click OK. Installation - Ma cintosh (7.5 or higher) If y our Mac v ersion is less than 8.1, some libraries required b y setup are not available.
24 Fig. 95 W arning W indow . Fig. 96 I nstallat ion Complete; click Quit. Not e: If A dob ePS doesn ’t open, simply double-click A dobePS Installer in the Printer Driv ers: AdobePS 8.
25 Fig. 100 R ev iew Setting s. Click I nstall. Fig. 101 I nstallation Complete. Click Quit. W hen the Main Scr een reappears, you can r egister your printe r (if online).
26 OS X (v ersion 10.1.5) Not e: Y ou must double-click the OSX_setup icon The installation window does not open auto- matically . Fig. 104 Click I nstall Pr inter . Fig. 105 Click Add P rinter. Fig. 106 Select AppleT alk, AppleT alk Network, your printer , and your pr inter’ s PPD; the n, c lick Add.
27 Mac OS X Printer C onfiguration Y ou can configur e your printer by selecting P age Setup and Printer F ea- tures. 1. Close the Print Center windo w to return to your deskt op. 2. F ollow this path to acc ess the Rea dM e file: CD: OSX_Installer: XANTÉ U tilit ies: ColourLaser_OSX: r eadme.
28 Fig. 112 Select A ppropriate F eatures; click Print. OS X (ve rsion 10.2.1) No te : Y ou must double-click the OSX_setup icon The installation window does not open auto- matically . Fig. 113 Click I nstall Pr inter . Fig. 114 Click Add P rinter. Fig.
29 Fig. 117 S el ect I nstallable Options to configure your printer’ s options, resolution, and memory . Then, click A pply Changes. Fig. 118 Locate T e xt Edit. No t e : Go to F ile: P a ge Setup to mak e sure your printe r appears in the Format For dr op-down menu.
30 2 . Select Format F or: ColourLaser in the P age A ttributes window (fig. 120). 3. Click OK once y ou hav e selecte d the desired paper size, or ientation, and scale for your print job . Fig. 120 P age Attr ibutes Windo w Not e : If the w ord Generic app ears below the F ormat For dr op- down menu, the installation proc ess must be restarted.
31 • Tech Support 1-800-926-8393 (US and Canada) Other areas, call your XANTÉ vendor. • Fax 251-473-6503 • Hours of Operation 7 a.m.- 6 p.m. Mon.—Fri. (CST) • E-mail ts1@xante.com europesupport@xante.com For mo re information about the ColourLaser or other XANTÉ printers, please log onto our websit e: www .
An important point after buying a device Xanté 100-100621 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Xanté 100-100621 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Xanté 100-100621 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Xanté 100-100621 you will learn all the available features of the product, as well as information on its operation. The information that you get Xanté 100-100621 will certainly help you make a decision on the purchase.
If you already are a holder of Xanté 100-100621, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Xanté 100-100621.
However, one of the most important roles played by the user manual is to help in solving problems with Xanté 100-100621. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Xanté 100-100621 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center