Instruction/ maintenance manual of the product RD-4610 Winegard
Go to page of 16
® OWNER’S MANUAL INST ALLA TION INSTRUCTIONS R V Digit al Satellite System with RS-1000 Antenna Model RD-4610 U.S. P A TENTS 5,532,710 and 5,554,998 Made in U.S.A. WINEG ARD Winegard Company • 3000 Kirkwood S t. • Burlington, IA 52601-2000 319/754-0600 • F AX 319/754-0787 Printed in U.
FIGURE 1 INST ALLA TION & ASSEMBL Y STEP 1. Choose a location for antenna that will allow it to rest in travel position with antenna pointing toward rear of vehicle and raise and rotate without interfering with other roof-mounted equipment. Make sure inside ceiling area is clear where ceiling plate will mount.
FIGURE 2 (4) 5/16-18 x 5/8" Flat Head Bolt (4) 5/16" Flat Washer (4) 5/16-18 Hex Nut Backup Assembly RS-1000 Antenna Reflector STEP 3. Attach reflector to backup assembly as shown in Figure 2. STEP 4. Attach RS-1000 antenna to elevating tubes, see Figure 2, using the two Eclips and pins provided.
ROOF ELEV A TING SHAFT W/R W -1000 DIRECTIONAL THICKNESS LENGTH HANDLE LENGTH 4 3/4" 6 1/4" RP-4200 req. 5 3/8" 4 1/2" 6" RP-4200 req.
STEP 11. Feed downleads through roof using Winegard Model CE-2000 cover plate (included with hardware). Weatherproof cable entry by applying approved sealant under lip of roof-thru plate and where cable enters roof. Attach plate to roof with screws provided.
3 Directional Handle Extension 4 Directional Handle ALIGN POINTER WITH ANTENNA TRA VEL POSITION 2 (4) #10 Phillips Flat Head Screws FIGURE 4 5 ELEV A TING CRANK HANDLE (When installed, extends 2-1/4" from ceiling). Snap Handle into base when not in use.
FIGURE 5 Directional Dial Elevating Crank Directional Handle Pointer Rotation Clamp Directional Handle STEP 2. Move rotation clamp to the LOCK position.
TUNING ANTENNA FOR BEST PICTURE STEP 8. Y our receiver should indicate it is receiving a signal. T o tune your antenna for the best picture, slowly move the antenna left, then right until you have found the position that gives the highest signal strength.
Satellite Receiver VCR Video Switch Coax downlead from RS-1000 Coax downlead from satellite antenna Power Supply Coax downlead from RS-1000 Coax downlead from satellite antenna Satellite Receiver VCR .
LUBRICA TING RUBBER QUAD RING Lubricate rubber quad ring on elevating shaft which is below worm gear with silicone spray lubricant at least twice yearly (Figure 10). This will keep quad ring from becoming brittle which could result in leaks down elevating shaft.
TROUBLE SHOOTING NO PICTURE 1. Check that you have a clear line of sight to the satellite (no trees, buildings, etc.). 2. Check that you have the TV set tuned for the correct channel 3 or 4 (same channel as output of receiver). 3. Double check that you have entered the correct zip code into the receiver .
P ARTS LIST (not all p arts listed due to sp ace constraints) Rev 4/98 (5) E-Clip P .N. 5160818 (2) 1/4-20 Hex Nut, Nylock P .N. 2160220 (4) 1/4" Flat W asher P .N. 2160039 (2) 1/4-20 X 1.75" Hex Bolt P .N. 2160238 46cm (18") Reflector , White P .
P ARTS LIST (2) Cable Clamp P .N. 2200060 (4) 1/4-20 Hex Nut, Nylock P .N. 2160220 (2) T ravel Link P .N. 2745050 (3) 1/4 x 2-5/16" Pin P .N. 2160814 (5) E-Clips P .N. 5160818 LNBF Pivot Arm P .N. 2745059 Spring P .N. 2160820 (not shown for clarity) (4) Nylon Bearing P .
P ARTS LIST NOT T O SCALE Ceiling Base Directional Dial (4) #10 Phillip Flat Head Screws Directional Handle Azimuth Lock Azimuth Lock Knob W asher #10 x 3/8" Phillips #8-32 Square Nut Crank Handl.
Rev 1/2001 SPECIFICA TIONS Height when raised 37" max. Height in the travel position 12.0" max. Operating radius 17" (34" diameter circle) Roof space required 19.5" x 46.75" LNB Compatible with DSS ® and DISH Network TM Color White Satellite antenna height 20.
Rev . 8-97.
An important point after buying a device Winegard RD-4610 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Winegard RD-4610 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Winegard RD-4610 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Winegard RD-4610 you will learn all the available features of the product, as well as information on its operation. The information that you get Winegard RD-4610 will certainly help you make a decision on the purchase.
If you already are a holder of Winegard RD-4610, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Winegard RD-4610.
However, one of the most important roles played by the user manual is to help in solving problems with Winegard RD-4610. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Winegard RD-4610 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
