Instruction/ maintenance manual of the product T36 Williams Sound
Go to page of 8
MAN 142A ©2008 Williams Sound Corp. ® Thank you for purchasing the T36 transmitter from W illiams Sound. The T36 is designed to operate with a wideband FM, 72–76 MHz receiver . For more infor- mation on available receivers, visit www .williamssound.
2 ® O PERA TING I NSTRUCTIONS IMPORT ANT : If Alkaline (non- rechargeable) batteries are being installed, slide the battery selection switch in the battery compartment to the “Alkaline” position. See FIG. A below . If installing NiMH (or recharge- able) batteries, slide the battery selec- tion switch to the “NiMH” position.
3 ® NOTE: Up to eight T36’ s can operate simultaneously on channels 1-8 (FIG. C) when used with an R35-8 receiver . 6. Position the headset microphone boom as close to the speaker ’ s mouth as pos- sible without actually touching. Lapel clip microphones should be attached to a collar or lapel, as close to the speak- er ’ s mouth as possible.
4 ® C OMPRESSION S ELECTOR By default, the T36 compression is set to “Off” for normal operation, or “1:1” com- pression. For hearing assistance applica- tions, the compression selector can be set to “On” for “2:1” compression. T o change this setting, open the battery door and locate the Compression Selector (FIG.
5 ® B EL T C LIP I NST ALLA TION T o Install: Position the belt clip on the rear of the T36 transmitter as shown in FIG. E. T urn the belt clip 180˚ left or right as shown in FIG. F . The belt clip is now installed and ready for use. T o Remove: Turn the belt clip 180˚ so the open end of the clip points to the top of the unit as shown in FIG.
6 ® A P AR TICULAR PURPOSE. WILLIAMS SOUND SHALL NOT BE LIABLE T O ANY PERSON OR ENTITY FOR ANY MEDICAL EXPENSES OR ANY DIRECT , INCI- DENT AL OR CONSEQUENTIAL DAMAGES CAUSED BY ANY USE, DEFECT , F AILURE OR MALFUNC- TION OF THE PRODUCT , WHETHER A CLAIM FOR SUCH DAMAGES IS BASED UPON W AR- RANTY , CONTRACT , TOR T OR OTHER WISE.
7 ® Dimensions: 4.1” L x 2.8” W x 1.1” H (104 mm x 71 mm x 28 mm) W eight: 2.6 oz (74 g), no batteries Housing Material: Shatter-resistant PC/ABS plastic Battery T ype: T wo (2) AA 1.5 V non-rechargeable Alkaline batteries (BA T 001), 70 mA nominal current drain, 30 hours approx.
® 1032 1 West 70th St., Eden Prairie, MN 55344 U.S.A. 800.843.3544 | 952.943. 2252 | FAX: 95 2.943.2174 www.williamssound.com MAN 142A ©2008 Williams Sound Corp.
An important point after buying a device Williams Sound T36 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Williams Sound T36 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Williams Sound T36 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Williams Sound T36 you will learn all the available features of the product, as well as information on its operation. The information that you get Williams Sound T36 will certainly help you make a decision on the purchase.
If you already are a holder of Williams Sound T36, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Williams Sound T36.
However, one of the most important roles played by the user manual is to help in solving problems with Williams Sound T36. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Williams Sound T36 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
