Instruction/ maintenance manual of the product RS576PXL Whirlpool
Go to page of 24
d304NCH SLIDE-IN ELECTRIC RANGE WITH CONVERTIBLE COOKTOP Model RS576PXL -Oven Vent Plug-In Surface Units /Heat Deflector Automatic Oven Llaht Swlich Broil Element Plug-lri Cooktop Module One-Plece Chr.
Your responsirbilities.. . Proper Installation and safe use of the range are your personal responslbllltles. Read this “Use and Care Gulde”and the “Cooking Guide”corefully for Important use and safety information. Installation You must be sure your range Is.
.
Using your range Oven Selector / Manual Oven Light Switch / SETTING THE CLOCK Push in and turn the Minute Timer Knob to set the Clock 1 . Push in Minute Timer Knob and turn 2. let the Minute Timer Knob pop out. Turn clockwise until clock digits show the right counterclockwise until the Minute Timer time of day.
Surface Unit Minute Timer Stop Time Knob Right Cooktop Module Signal Light SurGce Unit/ Cooktop Module Indicator Start Time Knob THE OVEN CONTROLS The oven is controlled by two knobs: the Oven Selector and the Oven Tempera.
BAKING OR ROASTING 1 v- -7 Put the rackfs) where you want them before turning on the oven. Rack(s) should be placed so food can be centered in the oven. Always leave at least I’ 2 to 2 inches (4-5 cm] letween the sides of the pan and the oven walls and pans.
BROILING 4 1. Place the rack where you want it for broiling. 4. Set the Oven Temperature Control on BROIL [or on a lower temperature for slower broiling). 2. Put the broiler pan and food on the rack. 5. During broiling, the oven door must be partly open.
USING THE AUTOMAIIC MEALTIMER* CLOCK The Automatic MEALTIMER Clock is designed to turn the oven on and off at times you set...even when you are not around.lMPORTANT: Follow these steps In order. To start and stop baklng automatically: 1. Put the racks where you 2.
If the steps for using the Automatic MEALTIMER Clock are not followed in order, the electric oven door lock may be turned on The door will then either: If the Door Won’t Close: l not open; 1. Make sure the Clock and Start and l not close all the way [the oven light stays onI Stop Times are set to the right time of day, open the oven door.
SURFACE UNIT CONTROLS Unl II you get used to the settings, use the following as a gulde. Control knobs must be pushed In before turning them to a set- ting. They can be set anywhere between HI and OFF. PUSH IN. Turn to setting. YE0 Use HI to start foods cooking or to bring liquids to a boil.
CHANGING COOKTOP MODULES The Cooktop Modules will work on either side of the cooktop Make sure all controls are OFF and modules are cool before removlng them. SURFACE UNIT MODULES 1. To remove, lift slightly by the handle 4. Replace in reverse order GRILL MODULE 2.
OPTIONAL BLACK SMOOTH- 1. To remove, lift 2. With both slrghtly bv the hands pull handle module toward I vou to UnDlua It 1. To replace, use Doth hands to me up the term minal with the receptac ‘e 2. Push smoothtop into place until it’s plugged In 3.
GRILL MODULE A range hood (Whirlpool Model No’sRGH8330 or RGH8336) should be used to help get rid of smoke while using the Grill Module. Approxlmate Grill Module Cooklng Times Preheat grill for five minutes at suggested setting Wel htor 1 Thlc ness GRILL GRILL FOOD FOOD ~.
THE OPTIONAL SMOOTHTOP MODULE Cooking on the black smoothtop module is almost the same as cooking on surface ele- ments. There are three differences you should keep in mind 1. FOR BEST RESULTS, PROPER COOKWARE MUST BE USED... Bottoms must be perfectly flat, with NO ridges, rims, patterns, dents, roughness or scratches.
OPTIONAL ROTISSERIE Rotlrserle Parts Rear gii-iif 1 The Rotisserie has 4 parts. It is used with the Grill Module. Splt and Forks 1. Remove the grills from the Grill Module. 2. Insert rear sup- port tabs into slots at rear of the Grill Module. 3. Slide forward to lock.
Approxlmate rotlsserie cooking times: Internal Control Spit Food Temperature Weight Setting(s) Posltlon Time Comments ~~-- Beef Rolled rib 140 F 3’nlbs. HI High 1 hr. Meat with an (rare) (60 Cl (I.5 kg) 55 min. outer layer of fat Rolled rump 140 F 3;4 Ibs Hi High 2 hr.
Cleaning and caring for your range CONTROL PANEL AND KNOBS 1. FM make sure knobs are set on OFF then pull knob straight off. Wash knobs well and dry. i 4. Push the knobs straight Sack :!r! Maice SIIIF: they point to CjFF SURFACE UN-ITS AND REFLECTOR BOWLS REMOVING 2, :fT?h,+ec:qe .
Terminal ptacle 3. Hold the surface unit as level as possrble with the terminal just started into the receptacle 4. While pushrng the surface unrt terminal Into the receptacle, lift a little on the edge of the unit nearest the receptacle 5.
SPECIAL TIPS 1. Ket?p the kitchen well ventilated during the cleaning cycle to help get rid of normal heat od 31s and smoke 2. Clean the oven before 3.
4. Set the Oven Temper- ature Control to CLEAN. 7. Turn the Oven Tempey- ature Control to,O,FF. 5. The Lock Light comes on when the oven gets above normal baking temperatures. The door can’t be unlocked when the Lock Light is on. 6. When the Lock Light goes off, turn the Oven Selectorto OFF.
CLEANING CHART Smoothtop Module See page 14 PART - WHAT TO USE HOW TO CLEAN Surface Units Griddle Module and Cover Do not clean Warm soapy water l Sol1 burns off. l Do not Immerse. l Do not Immerse grlddle. l Wash, rlnse and dry well. l Do not use metal scouring pads or harsh cleansers Grill Module Grill l Use plastic scouring pad If needed.
STORAGEDRAWER The storage drawer is for storing pots and pans. Never store anything that can burn or metl in the drawer. 1. PUII drawi?r straight out to 2. Lift front and pull out to the first stop the second stop. REPLACING THE STORAGE DRAWER Drawer Slide Rail 1.
If the Self-Cleanlng cycle will not operate: l Are the Oven Selector and the Oven Tem- perature Control set to “CLEAN?” l Does the Start Time Dial show the correct time of day? l Is the Stop firne.
0 FSP is a registered trademark of Whirlpool Corporation for quality parts. took for this FSP symbol of quality whenever ,~~ you need a replacement part for your Whirlpool appliance. FSP replacement parts will fit right and work right, because they are made to the same exacting specifications used to build every new Whirlpool appliance.
An important point after buying a device Whirlpool RS576PXL (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Whirlpool RS576PXL yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Whirlpool RS576PXL - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Whirlpool RS576PXL you will learn all the available features of the product, as well as information on its operation. The information that you get Whirlpool RS576PXL will certainly help you make a decision on the purchase.
If you already are a holder of Whirlpool RS576PXL, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Whirlpool RS576PXL.
However, one of the most important roles played by the user manual is to help in solving problems with Whirlpool RS576PXL. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Whirlpool RS576PXL along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
