Instruction/ maintenance manual of the product RS20AKXDN00 Whirlpool
Go to page of 29
I aFEE’ Use ATCare NO-FROST PART NO. 2173306-A SIDE X SIDE Table of Contents (complete) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 A Note to You . . . . . . . . . . . . . . . . . 2 Refrigerator Safety . . . . . . . 3 Parts and Features .
Table of Contents A Note to You ........................................... 2 Refrigerator Safety ................................... 3 Parts and Features ................................... 4 Before Using Your Refrigerator .............. 6 Using Your Refrigerator.
Refrigerator Safety Your safety is important to us. This guide contains statements under warn- ing symbols. Please pay special attention to these symbols and follow any instructions given.
Parts and Features This section contains captioned illustrations. Use them to become familiar with where all parts and features are located and what they look like.
Stvle 3 I Control panel ke cube tray* Jjijmji Removable wire rhelvest Leveling :E%Z base grille) Style 4 -,r,, Lbht Model and serial 1 number label II (on side wall) 11 Adiustable alass Control pane.
Before Using Your Refrigerator It is important to prepare your refrigerator for use. This section tells you how to clean it, connect it to a power source, install it, and level it.
Installing it properly 1. Allow ‘15 inch (1.25 cm) space on each side and at the top of the refrigerator for ease of installation. Leveling it 2. If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side closest to the wall so the door can be opened wider.
Using Your Refrigerator To obtain the best possible results from your refrigerator, it is important that you operate it property. This section tells you how to set the controls, remove and adjust some of the features in your refrigerator, and how to save energy.
Changing the control settings If you need to adjust temperatures in refrigerator or freezer, use the settings listed in the chart below as a guide. If you have questions, call our toll-free number, 1 -BOO- 44ROPER. l Adjust the Refrigerator Control first.
Removing the door trim (dispenser area) (on some models) Remove the trim above the dispenser area for easier cleaning. To remove trim: 1. Remove all items from the shelf. 2. Pull straight up at each end of the trim. To replace trim: 1. Line up each end of the trim above the trim pocket opening in the door liner wall.
Removing the snack bin (on some models) To remove the snack bin: ’ 1. Slide snack bin straight out to the stop with an even, constant motion. 2. Lii the front. 3. Slide bin out the rest of the way. 4. Replace in reverse order. Removing the crisper To remove the crisper: 1.
Removing the meat drawer and cover To remove the meat drawer: 1. Slide the meat drawer straight out to the stop. 2. Lift the front slightly. 3. Slide out the rest of the way. 4. Replace in reverse order. To remove the cover: 1. Remove the crisper, the crisper cover, and the meat drawer.
Removing the freezer shelves To remove the shelf: 1. Lift right side of shelf off supports. 2. Slide shelf out of shelf support holes. 3. Replace in reverse order. Using the ice and water dispensers (ice dispenser on some models only) Personal Injury Hazard Tumbling ice and pressure can break a fragile glass.
The water dispenser Chilled water comes from a tank behind the meat drawer. It holds approximately 1% quarts (1.5 L). When the refrigerator is first hooked up, press the water dispenser bar with a sturdy glass or jar until you draw and discard 2 to 3 quarts (1.
ice maker mold and lead to poor ice quality. If a softened water supply cannot be avoid- ed, make sure the water softener is operating properly and is well maintained. Removing the ice maker storage bin (on some models) Remove, empty, and clean the storage bin if: l the ice dispenser has not, or will not, be used for a week or more.
Solving common ice maker/dispenser problems PROBLEM CAUSE SOLUTIONS Ice dispenser l Freezer door open l Close the freezer door. won’t work l Ice bin not properly l Make sure bin is pushed in all the way. installed l Wrong ice in bin l Use only crescents from ice maker.
Removing the base grille To remove the grille: 1. Open both doors. 2. Pull base grille forward to release the support tabs from the metal clips. 3. Do not remove Tech Sheet fastened behind the grille. To replace the grille: 1. Line up grille support tabs with metal clips.
To change crisper light (on some models): 1. Disconnect refrigerator from power supply - 2. Pull top of light shield forward until it snaps free. 3. Lower light shield to clear bottom supports. risper light 4. Pull light shield straight out to remove.
Understanding the sounds you may hear Your new refrigerator may make sounds that your old one didn’t. Because the sounds are new to you, you might be concerned about them. Don’t be. Most of the new sounds are normal. Hard surfaces like the floor, walls, and cabinets can make the sounds seem louder.
Caring for Your Refrigerator Your refrigerator is built to give you many years of dependable service. However, there are a few things you can do to help extend its product life. This section tells you how to clean your refrigerator and what to do when going on vacation, moving, or during a power outage.
PART Door liners and gaskets Plastic parts (covers and panels) WHAT TO USE HOW TO CLEAN Sponge, soft cloth, l Wash, rinse, and dry thoroughly. or paper towel with mild deteigent and DO NOT USE cleaning waxes, concen- warm water trated detergents, bleaches, or cleaners containing petroleum on plastic parts.
Vacation and moving care Short vacations No need to shut off the refrigerator if you will be away for less than four weeks. 1. Use up any perishables. 2. Freeze other items. 3. If you have an automatic ice maker: l Raise signal arm to OFF (up) position.
Power interruptions If electricity goes off, call the power com- pany. Ask how long power will be off. 1. If service will be interrupted 24 hours or less, keep both doors closed. This helps food stay frozen. 2. If service will be interrupted longer than 24 hours: (a) Remove all frozen food and store in a frozen food locker.
Food Storage Guide There is a correct way to package and store refrigerated or frozen food. To keep food fresher, longer, take the time to study these recommended steps. Storing fresh fodd Wrap or store food placed in the refrigerator in airtight and moisture-proof material.
Storing frozen food The freezer section is designed for storage of commercially frozen food and for freezing food at home. NOTE: For further information about prepar- ing food for freezing or food storage times, contact your local Cooperative Extension Service or check a freezer guide or reliable cookbook.
Troubleshooting Performance problems often result from little things you can fix without tools. Please read the chart below before calling for service on your appliance. Before calling for assistance . . . Listed in this chart are the mosf common problems consumers Please read through this and see if it can solve your problem.
Requesting Assistance or Setiice - Before calling for assistance or service, please check Yroubleshooting” on page 26. ft may save you the cost of a service call. If you still need help, follow the instructions below. 1. lf you need assistance* . . .
Index This index is alphabetical. Look for the word or phrase you are interested in, then look for the page number. TOPIC PAGE BASE GRILLE Removing .............................................. 17 CARE Moving .........................................
ROPER” Refrigerator Warranty LENGTH OF WARRANTY FULL ONE-YEAR WARRANTY (from date of purchase) FULL FIVE-YEAR WARRANTY (from date of purchase) WE WILL PAY FOR FSP replacement parts and repair labor to correct defects in materials or workmanship. Service must be provided by an authorized Roper service company.
An important point after buying a device Whirlpool RS20AKXDN00 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Whirlpool RS20AKXDN00 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Whirlpool RS20AKXDN00 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Whirlpool RS20AKXDN00 you will learn all the available features of the product, as well as information on its operation. The information that you get Whirlpool RS20AKXDN00 will certainly help you make a decision on the purchase.
If you already are a holder of Whirlpool RS20AKXDN00, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Whirlpool RS20AKXDN00.
However, one of the most important roles played by the user manual is to help in solving problems with Whirlpool RS20AKXDN00. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Whirlpool RS20AKXDN00 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
