Instruction/ maintenance manual of the product RJE-960P Whirlpool
Go to page of 20
TKirlpool SO-INCH FREE-STANDING EYE-LEVEL ELECTRIC RANGE Models RJE-960P and RJE-963PP Hood Knockout Upper Oven Control Panel Top Light Porcelain Enamel Model and Serial Number Plate Automatic Oven Li.
. Digital Clock A Minute Timer A Stop Time Knob A Start Time Knob . Upper Oven Signal Light - Upper Oven Temperature Control Knob : Upper Oven Seiector Knob Lower Oven Signal Light Lower Oven Temperat.
Table of Contents BEFORE USING YOUR RANGE ......... ............ USING THE SURFACE UNIT CONTROLS ............. USING THE OVEN CONTROLS ................. l Baking. .................................... l Broiling ., .... ... ... ... ................ l Variable Broil Feature .
PUSH IN and turn until the setting shows in the window. To bake, turn the Oven Selector Knob to BAKE. . Using the surface unit controls The Surface Unit Control Knobs must be pushed in before turning them This helps avoid turning them on accidentally when wiping off the Control Panel.
To broil, turn the Oven Selector Knob to BROIL. 1 Upper Oven ALWAYS broil with the door open about 4 inches (10 cm). Lower Oven Broiling: First-Follow the directions below for placlng the meat at the right distance from the Broil Element. Second-Turn the Oven Selector to “BROIL.
< Remove the locking 1 screw; NOTICE position of notches. Lower: move black part toward “LO.” One notch equals about 10°F (5LC). Higher: move black part toward “HI.
To start and stop your oven automatically: 1. Be sure the clock is set to the right time of day. (The start and stop time hands will also show the correct time.) 2. Place the food in the oven. 3. Push in and turn the Start Time Knob clockwise to the time you want the oven to start.
Oven rack positions Your upper oven and lower oven each have two racks. Always put the racks where you want them to be before you turn on an oven. To remove a rack. take hold of it on the front edge and pull it out until it stops. Then lift up the front edge and pull again.
Gasket To replace the lower oven light bulb: The lower oven light bulb has a glass cover which is held on by a wire holder. This cover must be in place when the oven is being used. To replace the oven light, remove glass cover and gasket. remove screws To replace top light, remove three outer screws.
Your continuous cleaning upper oven How a Continuous Cleaning Oven Works: A standard oven has walls with a smooth porcelain enamel finish. A Continuous Cleaning Oven also has a porcelain enamel finish with one important difference: instead of being smooth.
3. Slide the foil sheet under the bake element. Make sure it is centered and long enough to start up the sides. 4. When you put the bake element back down. make sure all the feet rest solidly on the foil and that the foil is smoothed out across the bottom of the oven.
l Turn on the vent hood fan or other kitchen vents durtng the cleaning cycle. This will help remove smoke, odor and heat that are normal during the cycle. l If you have a rotisserie. be sure the motor socket cover is closed. Setting the controls to the Self- Cleaning cycle: 1.
6. The oven will shut off when the preset stop time is reached, but the oven door will stay locked until the oven has cooled. When the Lock Light turns off, turn the Oven Selector Knob and Oven Temperature Control Knob to “OFF.” This turns off the Clean Light.
Special tips: l If the cleaning cycle doesn‘t get the oven as clean as it should be. the ttme set for cleaning was probably not long enough. Set the cleaning time longer next time. You can set it for more than 3 hours, if you want. l Plan to clean the oven before it gets too heavily soiled.
I , Terminal To remove surface unit, lift and pull straight out. Hold surface unit level when replacing. Push / e w a t Lift Removing surface units and reflector bowls: 1 First. be sure the Surface Unit Controls are all “OFF” and that the surface units are cool.
Cleaning under the cooktop: To clean the area under the cooktop. lift the front of the cooktop at he center. Ratse the swing-up rod to hold it. (Be sure the tip of the rod is in the notch in the cooktop ) Use warm soapy water and a sponge or cloth.
WHAT TO USE HOW TO CLEAN Aluminum Warm, soapy water or soapy l Wash with other cooking utensils broiler pan and steel wool pads grid l Do not place in Self-Cleanlny Oven. Control panel Warm. soapy water l Wash. rinse and dry with soft cloth Oven racks Commercial glass cleaner l Follow directions Lvith cleaner.
IF YOO NEED SERVICE OR HELP, WE SUGGEST YOU FOLLOW THESE THREE STEPS: 1. Befcre you call for service : It y(~)iir rai:yG does not st’t’rll to bcl operating pr(>pe~-Iv.
2. If you need service‘ : If your WHIRLPOOL’ appliance e~w needs service anywhere in the Unlted States, help IS lust a phone call away to your nearest WhIrlpool franchlsed TECH-CARE’ service rep.
FSP is a reg~sferecl trademark 0 of Whirlpool Gxporafi~ for quality ports. Look forthis FSP symbol of quality whenever void need a replacement part 8 for your Whlrtpool appliance. FSP replacemen parts will fli right and work right, because they are made to the same exacting specifications wed to butId every new Whir!pti appliance.
An important point after buying a device Whirlpool RJE-960P (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Whirlpool RJE-960P yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Whirlpool RJE-960P - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Whirlpool RJE-960P you will learn all the available features of the product, as well as information on its operation. The information that you get Whirlpool RJE-960P will certainly help you make a decision on the purchase.
If you already are a holder of Whirlpool RJE-960P, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Whirlpool RJE-960P.
However, one of the most important roles played by the user manual is to help in solving problems with Whirlpool RJE-960P. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Whirlpool RJE-960P along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
