Instruction/ maintenance manual of the product FGP300BL0 Whirlpool
Go to page of 7
IMPORTANT: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions witk the homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use.
Before you start... Proper installation is your responsibility. Make sure you have everything necessary for correct installation, It is the responsibility of the installer to comply with the installation clearances specified on the serial/rating plate.
Gas supply requirements Observe all governing codes and ordinances. Fire Hazard l Range must be connected to a regulated gas supply. l L.P. gas supply must Not exceed a pressure of 14” water column. This must be checked by a qualified technician before installing this range.
Now start... with range in kitchen. 1 n Remove racks and other parts from inside oven. 2. Place one foot on the shipping base. Tilt range forward slightly to free rear legs. Gently lower range to floor. Tilt range backwards until legs are free. 3 1 Remove shipping materials, tape and protective film from range.
Numbers correspond 70.’ to steps. 17 m After burner lights, turn control knob to “HI” position. Check each COO~~OP burner for proper flame. The small inner cone should have a very distinct blue fk l/4” to l/l?” long. The outer cone js distinct as the inner cone.
19 A If burneryneed adjusting for proper flame, adjust the air shu’rler to the widest opening that will not cause the flame to lift or blow off of the burner. Repeat as necessary with each burner A 20. Push in and turn the control knob to the “LITE” positlon and then to the low position.
If range does not operate... l Check that the circuit breaker is not tripped or the house fuse blown. l Check that power supply cord is plugged into wall receptacle. l Check that the gas supply is turned on. NOTE: Refer to Use and Care Guide for operaltng instructions and cleaning instructions.
An important point after buying a device Whirlpool FGP300BL0 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Whirlpool FGP300BL0 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Whirlpool FGP300BL0 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Whirlpool FGP300BL0 you will learn all the available features of the product, as well as information on its operation. The information that you get Whirlpool FGP300BL0 will certainly help you make a decision on the purchase.
If you already are a holder of Whirlpool FGP300BL0, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Whirlpool FGP300BL0.
However, one of the most important roles played by the user manual is to help in solving problems with Whirlpool FGP300BL0. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Whirlpool FGP300BL0 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
