Instruction/ maintenance manual of the product 8315965 Whirlpool
Go to page of 16
Installation Inst ructions IMPOR T ANT : Read and save these instructions IMPORTANT: Installer: Leave Installation Instructions with the owner. Owner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use.
Check location where washer will be installed. Proper installation is your responsibility. Make sure you have everything necessary for correct installation. Do Not store or operate washer below 32°F (0°C) (some water may remain in washer). Hot and cold water faucets: Must be within 4 feet (1.
T ools needed for installation: level pliers utility knife wrench scissors flat-blade screwdriver Electrical requirements ground prong Figure 1 PAGE 3 3-prong ground- type outlet 3-prong ground plug power supply cord Plug into a grounded 3-prong outlet.
Use new hoses and washers that came with your Whirlpool washer. Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker.
1/2" (1.3 cm) base nut 10. Use legs and nuts from parts package. Screw nut down to within 1/2 inch (1.3 cm) of base. 11. Insert legs into correct holes at each front corner of washer until nuts touch washer. Do Not tighten nuts until Step 14. 13.
Check list for washer operation Check the following if the washer is not operating properly: 1. Power supply cord is plugged in. 2. Circuit breaker is not tripped or fuse blown. 3. Water faucets are turned on. 4. Inlet and drain hoses are not kinked. 5.
T ypical full load sizes. Load Loading Load Loading Type Suggestion Type Suggestion Mixed 3 double sheets Heavy 3 pair pants Load 4 pillowcases work 3 shirts 6 pair shorts clothes 1 coverall 8 T-shirt.
Part No. 8315965 ©2000 Whirlpool Corporation Printed in U.S.A. Prepared by Whirlpool Corporation Benton Harbor, Michigan 49022 power supply cord 1-1/2" (4 cm) cold hot 25-1/2" (65 cm) drain hose connector 7" (18 cm) 43" (109 cm) 1" (2.
Inst ructions d’installation IMPOR T ANT : Lire et conserver ces instructions. IMPORTANT : Installateur : Remettre la brochure des instructions d’installation au propriétaire. Propriétaire : Conserver la brochure des instructions d’installation pour référence ultérieure.
Inspecter l’emplacement où la laveuse sera installée. Assurez-vous d’avoir tout le matériel nécessaire pour la réalisation d’une installation correcte. C’est au propriétaire de l’équipement qu’incombe la responsabilité d’une installation correcte.
Outillage nécessaire pour l’installation : niveau pince couteau utilitaire clé à molette ciseaux tournevis à lame plate Installation électrique PAGE 3 Risque de choc électrique Brancher sur une prise à 3 alvéoles reliée à la terre. Ne pas enlever la broche de liaison à la terre.
coupures, signes d’usure ou fuites apparaissent. Lors du remplacement des tuyaux d’alimentation d’eau, inscrire la date de remplacement sur l’étiquette avec un marqueur indélébile. 2. Insérer un joint dans chaque raccord des tuyaux d’arrivée d’eau.
1,3 cm (1/2 po) base écrou 10. Utiliser les pieds et les écrous fournis dans le sachet de pièces. Visser l’écrou jusqu’à environ 1,3 cm (1/2 po) de la base. 11. Insérer le pied dans le trou convenable à chaque angle avant de la laveuse, jusqu’à ce que l’écrou soit en contact avec la base de la laveuse.
Liste de contrôle — fonctionnement de la laveuse Si la laveuse ne fonctionne pas correctement, contrôler ce qui suit : 1. Cordon d’alimentation branché. 2. Disjoncteur ouvert ou fusible grillé. 3. Robinets d’arrivée d’eau ouverts. 4. Tuyaux d’arrivée d’eau et tuyau de décharge déformés.
T aille typique des charges complètes Type de Suggestion de Type de Suggestion de charge chargement charge chargement Charge 3 draps (lit à 2 V êtements 3 pantalons mixte places) de travail 3 chemi.
N° de pièce 8315965 ©2000 Whirlpool Corporation Imprimé aux E.-U. Préparé par Whirlpool Corporation Benton Harbor, Michigan 49022 Cordon d’alimentation 4 cm (1-1/2 po) froid chaud 65 cm (25-1/.
An important point after buying a device Whirlpool 8315965 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Whirlpool 8315965 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Whirlpool 8315965 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Whirlpool 8315965 you will learn all the available features of the product, as well as information on its operation. The information that you get Whirlpool 8315965 will certainly help you make a decision on the purchase.
If you already are a holder of Whirlpool 8315965, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Whirlpool 8315965.
However, one of the most important roles played by the user manual is to help in solving problems with Whirlpool 8315965. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Whirlpool 8315965 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
