Instruction/ maintenance manual of the product 3360619 Whirlpool
Go to page of 16
Installation Inst r uctions IMPOR T ANT : Read and sav e these instr uctions IMPORTANT: Installer: Leave Installation Instructions with the owner. Owner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use.
PAGE 2 Check location where washer will be installed. Proper installation is your responsibility. Make sure you have everything necessary for correct installation. No. T20 Torx screws Hot and cold water faucets must be within 1.2 meters (4 feet) of the back of the washer and provide water pressure 690 kPa (10-100 PSI).
T ools needed for installation: level pliers utility knife wrench scissors flat-blade screwdriver Electrical requirements If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.
PAGE 4 2. Insert a flatwasher into each end of the inlet hoses. Check that washers are firmly seated in couplings. coupling washer 7. Before attaching water inlet hoses, run water through both faucets into a bucket. This will get rid of particles in water lines that might clog hoses.
14. If washer is not level, adjust the front legs up or down. Make final check with level. When washer is level, use wrench to turn nuts on front legs up tightly against washer base. If nuts are not tight against washer base, the washer may vibrate. 20.
Check list for washer operation Check the following if the washer is not operating properly: 1. Power supply cord is plugged in. 2. Circuit breaker is not tripped or fuse blown. 3. Timer has been advanced to start of a cycle. 4. Water faucets are turned on.
PAGE 7 Power supply cord 4 cm (1-1/2") Cold Hot 65 cm (25-1/2") Drain hose connector 18 cm (7") 109 cm (43") 2.5 cm (1") 97 cm (38-1/8") 13.3 cm (5-1/4") 89 cm (35") 68.5 cm (27") 70.5 cm (27-3/4") Water Inlets 12.
Part No. 3360619 ©1999 Whirlpool Corporation Printed in U.S.A..
Instr uctions d’installation IMPOR T ANT : Lire et conser ver ces instr uctions . IMPORTANT : Installateur : Remettre la brochure des instructions d’installation au propriétaire. Propriétaire : Conserver la brochure des instructions d’installation pour référence ultérieure.
Inspecter l’emplacement où la laveuse sera installée. Assurez-vous d’avoir tout le matériel nécessaire pour la réalisation d’une installation correcte. C’est au propriétaire de l’équipement qu’incombe la responsabilité d’une installation correcte.
Outillage nécessaire pour l’installation : niveau pince couteau utilitaire clé à molette ciseaux tournevis à lame plate Pièces fournies pour l’installation : Retirer les pièces de l’emballage. Vérifier que toutes les pièces sont incluses.
Utiliser les tuyaux d’arrivée d’eau et joints neufs fournis avec la laveuse. 2. Insérer un joint dans chaque raccord des tuyaux d’arrivée d’eau.
13. Incliner la laveuse vers l’avant pour soulever les pieds arrière de 2,5 cm (1 po) au-dessus du sol. Laisser la laveuse redescendre doucement jusqu’au sol. Vérifier l’aplomb de la laveuse transversalement et de l’avant à l’arrière (des deux côtés) avec un niveau.
Liste de contrôle – fonctionnement de la laveuse Si la laveuse ne fonctionne pas correctement, contrôler ce qui suit : 1. Cordon d’alimentation branché. 2. Disjoncteur ouvert ou fusible grillé. 3. La minuterie n’a pas avancé au point de départ du programme.
PAGE 7 Cordon d’alimentation 4 cm (1 1/2 po) Eau froide Eau chaude 65 cm (25 1/2 po) Raccord du tuyau de décharge 18 cm (7 po) 109 cm (43 po) 2,5 cm (1 po) 97 cm (38 1/8 po) 13,3 cm (5 1/4 po) 89 c.
Pièce n° 3360619 ©1999 Whirlpool Corporation Imprimé aux É.-U..
An important point after buying a device Whirlpool 3360619 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Whirlpool 3360619 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Whirlpool 3360619 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Whirlpool 3360619 you will learn all the available features of the product, as well as information on its operation. The information that you get Whirlpool 3360619 will certainly help you make a decision on the purchase.
If you already are a holder of Whirlpool 3360619, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Whirlpool 3360619.
However, one of the most important roles played by the user manual is to help in solving problems with Whirlpool 3360619. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Whirlpool 3360619 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
