Instruction/ maintenance manual of the product 42376 Weber
Go to page of 16
BUILT-IN LP SIDE BURNER INST ALLA TION/ OWNER'S GUIDE 42376 US 01/10/06 LP YOU MUST READ THIS O WNERS GUIDE BEF ORE OPERA TING YOUR G A S GRILL DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open fl ames. 3. Open lid.
2 DANGERS & W ARNINGS DANGER Failure to follow the Dangers, W arnings and Cautions contained in this Owner ’s Manual may result in serious bodily injury or death, or in a fi re or an explosion causing damage to property . W ARNINGS Do not store a spare or disconnected liquid propane cylinder under or near this barbecue.
3 STORA GE AND/ OR NONUSE • The gas must be turned of f at the liquid propane cylinder when the Weber ® gas barbecue is not in use. OPERA TING W ARNING: Only use this barbecue outdoors in a well-ventilated area. Do not use in a garage, building, breezeway or any other enclosed area.
4 L OCA TING YOUR BUIL T -IN SIDE BURNER When determining a suitable location for your Built-In Side Burner installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and keeping any gas supply lines as short as possible.
5 MOUNTING THE SIDE BURNER Connect the corrugated gas line to the side burner valve located on the back right hand side of side burner . TEST CONNEC TIONS All connections and joints must be thoroughly tested for leaks in accordance with local codes and all listed procedures in the latest edition of ANSI Z223.
6 TYPICAL BULK PROP ANE GAS SUPPL Y INST ALLA TION We recommend that this installation be done by a LICENSED professional. General Specifi cations for Piping Note - Contact your local municipality for building codes regulating outdoor gas grill installations.
7 TYPICAL 20 LP PROP ANE GAS SUPPL Y INST ALLA TION We strongly recommend that you use the Summit ® Built-In T ank Cabinet (#21280) for installations using a 20 lb LP cylinder , mounted remotely in an “island” structure.
8 3). The minimum size of the ventilation hole (s) should not be less than 1/4 inch. d). The remote LP cylinder enclosure should be constructed with non- combustible materials.
9 GAS INSTRUC TIONS FILL LIQUID PROP ANE CYLINDER T o fi ll, take the liquid propane cylinder and fi ller adapter to an R V center or look up gas-propane in the phone book for other sources of liquid propane gas.
10 T o Connect the hose to the cylinder: 3) Remove the plastic dust cover from the valve. 4) Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand-tighten only . Note: This connection tightens clockwise and will not allow gas to fl ow unless the connection is tight.
11 Check: 3) “T” Connection-to-Hose connections. 4) The hose-to-Regulator connection. W ARNING: If there is a leak at connections (2,3, or 4), turn OFF the gas. DO NOT OPERA TE THE GRILL. Contact Customer Service 1-800-446-1071. When leak checks are complete, turn gas supply OFF at the source and rinse connections with water .
12 LIGHTING THE SIDE BURNER. 1) Open the side burner lid. 2) Check that the side burner valve is turned OFF . (Push knob in and turn clockwise to ensure that it in the off position.) W ARNING: The burner control knob must be in the OFF position before turning on the liquid propane cylinder valve.
13 CROSSOVER ® IGNITION S YSTEM OPERA TIONS If the Crossover ® ignition system fails to ignite the LEFT burner in a burner set, light the LEFT burner with a match. If the LEFT burner lights with a match, then check the Crossover ® ignition system. • Check that both ignition wires(1,2) are attached properly .
14 PROBLEM CHECK CURE Side Burner does not light. Is gas supply off? T urn supply on. Flame is low in HIGH position. Is the fuel hose bent or kinked? Straighten hose. Is LP fuel low or empty? Refi ll LP cylinder . The excess fl ow safety device, which is part of the barbecue to cylinder connection, may have activated.
15 A TTENTION: This product has been safety tested and is only certifi ed for use in a specifi c country . Refer to country designation located on outer carton. These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co.
©2003 The following trademarks are registered in the name of W eber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.
An important point after buying a device Weber 42376 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Weber 42376 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Weber 42376 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Weber 42376 you will learn all the available features of the product, as well as information on its operation. The information that you get Weber 42376 will certainly help you make a decision on the purchase.
If you already are a holder of Weber 42376, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Weber 42376.
However, one of the most important roles played by the user manual is to help in solving problems with Weber 42376. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Weber 42376 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
