Instruction/ maintenance manual of the product 260L77R ML-52116 Vulcan-Hart
Go to page of 20
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201-0696, TEL. (502) 778-2791 FORM 30752 Rev. A (2-96) (Formerly 114583) ECONOLINE SERIES GAS REST AURANT RANGES MODEL 36L77R ML-52113 60L77R ML-521.
— 2 — IMPORT ANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS IS DETECTED.
— 3 — T ABLE OF CONTENTS GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
— 4 — Installation, Operation and Care of ECONOLINE SERIES GAS REST AURANT RANGES KEEP THIS MANUAL FOR FUTURE REFERENCE GENERAL Your Vulcan Econoline Range is produced with quality workmanship and material. Proper installation, usage and maintenance of your range will result in many years of satisfactory performance.
— 5 — LOCATION CAUTION: The equipment area must be kept free and clear of combustible substances. The range, when installed, must have a minimum clearance from combustible and non-combustible construction of 6" at the sides and 6" at the rear.
— 6 — Fig. 2 If it is necessary to disconnect the restraint, turn off the gas supply before disconnection. Reconnect the restraint before turning the gas supply on and returning the range to its installation position. High Shelf The high shelf for this range is shipped as shown in Fig.
— 7 — Fig. 4 Fig. 5 Broiler-Griddle Section Vulcan Econoline Range Broilers are equipped with ceramic radiants for the most efficient operation. These radiants are packed separately in the range oven. Proper installation positions of the radiants are shown in Fig.
— 8 — Conventional Griddles Vulcan Econoline Ranges with conventional griddles have fire brick under the griddle section. The bricks are packed separately in the range oven. Fig. 7 shows the proper installation positions. All griddles have grease collectors which must be installed on the side of the range (Fig.
— 9 — LEVELING Check the leveling of the range. Place a carpenter's level inside the oven cavity across the oven rack. Level the range from front to back and from side to side. To adjust the leveling of the range, tilt the range to one side and, using channel locks, unscrew the adjustable leg insert as required.
— 10 — Fig. 9 Fig. 10 Unless manifold pressure on all connected appliances is the same, a separate regulator must be supplied for all ranges having different manifold pressures. A leak limiter is supplied with every regulator to allow excess gas pressure to escape.
— 11 — Information on the construction and installation of ventilating hoods may be obtained from the standard for "Vapor Removal from Cooking Equipment," NFPA No. 96 (latest edition), available from the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
— 12 — OPERA TION WARNING: THE RANGE AND ITS PARTS ARE HOT. BE VERY CAREFUL WHEN OPERATING, CLEANING OR SERVICING THE RANGE. The Econoline Range does not require special recipes. You may wish to use a temperature up to 25°F higher or lower to obtain the particular product results that you prefer.
— 13 — Oven Pilot 1. Turn main gas supply ON. Remove lower front panel and lift lighting hole cover. 2. Depress the reset button located behind the lower front panel and light pilot with a lit taper (Fig. 12). Continue to hold reset button in for 1 minute.
— 14 — 4. If any pilot fails to light or extinguishes, ensure that the burner valve knob is in the OFF position. Wait 5 minutes, then relight. 5. After all pilots are lit, ensure that all burners are operational. To ignite burners, turn the burner valve knobs fully ON, starting from left to right.
— 15 — To season, heat griddle top section at a low burner setting. Pour one ounce of cooking oil per square foot of surface over the griddle top section. With an insulated cloth, spread the oil over the entire griddle surface to create a thin film.
— 16 — To remove the rack, reverse the procedure by raising the rear of the oven rack support hooks above the runner and pulling the rack forward (Fig. 14). PREHEATING Oven Turn thermostat control to the desired cooking temperature and preheat oven for 25 minutes.
— 17 — 1. Turn the three burner valve knobs fully ON. 2. After preheating for 5 minutes, turn the burner valve knobs down until the desired flame or heating level is achieved. 3. Position removable grid into one of the two slide positions, depending on which will achieve the proper product preparation results.
— 18 — Oven Clean oven and oven door daily, especially if fruit pies or tomato sauces were baked, meats roasted, and if there have been spillovers. Do not use scouring powder. It is extremely difficult to remove completely, and can build up accumulations that will damage the oven.
— 19 — MAINTENANCE WARNING: THE RANGE AND ITS PARTS ARE HOT. BE VERY CAREFUL WHEN OPERATING, CLEANING OR SERVICING THE RANGE. VENT When cool, the vent of this range should be checked every six months for obstructions.
— 20 — FORM 30752 Rev. A (2-96) (Formerly 114583) TROUBLESHOOTING OVEN PROBLEM Too much bottom heat. Uneven bake. Side burning. Too much top heat. Uneven bake side-to-side. Uneven bake front-to-rear. Dried out products. Pilot outage. TOP BURNER Improper burner combustion; excessive valve handle temperature; sticking top burner valves.
An important point after buying a device Vulcan-Hart 260L77R ML-52116 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Vulcan-Hart 260L77R ML-52116 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Vulcan-Hart 260L77R ML-52116 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Vulcan-Hart 260L77R ML-52116 you will learn all the available features of the product, as well as information on its operation. The information that you get Vulcan-Hart 260L77R ML-52116 will certainly help you make a decision on the purchase.
If you already are a holder of Vulcan-Hart 260L77R ML-52116, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Vulcan-Hart 260L77R ML-52116.
However, one of the most important roles played by the user manual is to help in solving problems with Vulcan-Hart 260L77R ML-52116. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Vulcan-Hart 260L77R ML-52116 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
