Instruction/ maintenance manual of the product viking Viking
Go to page of 18
Viking Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.
IMPORT ANT 3 – Please Read and Follow T able of Contents • Before beginning, please read these instructions completely and carefully . • Do not remove per manently affixed labels, warnings, or plates from product. This may void the warranty . • Please observe all local and national codes and ordinances.
Specifications (30" & 36" 100 and 300 Series) 5 Dimensions (30" & 36" 100 and 300 Series) 4 35-7/8" (91.1 cm) 29" (73.6 cm) 34-1/4" (86.9 cm) 17-3/16" (43.7 cm) 10-5/8” (26.9 cm) 30" (76.2 cm) 29" (73.
30”W & 42”W 500 Series Grills Description VGBQ53002RE VGBQ54203RE/ VGIQ54203RE Cutout width 28-5/8” (72.7cm) 40-1/4” (102.2cm) Cutout depth 28” (71.1 cm) Cutout height 10-1/4” (26.0 cm) Overall width 29-1/2” (74.9 cm) 41-3/16” (104.
9 8 54”W 500 Series Grills Description VGBQ55404RE/VGIQ55404RE Cutout width 52-1/4” (132.7 cm) Cutout depth 28” (71.1 cm) Cutout height 10-1/4” (26.0 cm) Overall width 53-3/16” (135.1 cm) Overall depth 32-3/4” (83.2 cm) Gas requirements Natural: standard residential 1/2” (1.
General Infor mation • A minimum of 6” (15.2 cm) from the sides, or a minimum of 8” (20.3 cm) from the right side if there is a rotisserie motor and a minimum of 24” (61.0 cm) from the back must be maintained from the grill above the cooking surface to adjacent vertical combustible construction.
22-15/16” (58.3 cm) 17-3/16” (43.7 cm) 10-5/8” (26.9 cm) 34-1/4” (86.9 cm) 8” (20.3 cm) 5-3/8” (13.7 cm) 29” (73.6 cm) 27-13/16” (70.6 cm) 3” min. (7.6 cm) to non- combustable surface 24” min. (61.0 cm) to combustable surface 6” (15.
22-15/16” (58.3 cm) 16-5/8” (80.2 cm) 10-1/4” (26.0 cm) 41-3/16” (104.6 cm) 8” (20.3 cm) 5-3/8” (13.7 cm) 32-3/4” (83.2 cm) 31-9/16” (80.2 cm) 3” min. (7.6 cm) to non- combustable surface 24” min. (61.0 cm) to combustable surface 6” (15.
22-15/16” (58.3 cm) 16-5/8” (80.2 cm) 10-1/4” (26.0 cm) 6” (15.2 cm) 50” (127 cm) 8” (20.3 cm) 5-3/8” (13.7 cm) 32-3/4” (83.2 cm) 31-9/16” (80.2 cm) 3” min. (7.6 cm) to non- combustable surface 24” min. (61.0 cm) to combustable surface VGBQ55404RE/VGIQ55404RE 10-1/8” (25.
10-1/4” (26.0 cm) 36” (91.4 cm) **Access door opening 28” (71.1 cm) 28-5/8” (72.7 cm) 3” (7.6 cm) min. Electrical connection for rotisserie motor (position unit so that the plug is always accessible) Electrical connection for power supply cord on 500 Series to be located on rear wall with a maximum distance of 2’ (61.
10-1/4” (26.0 cm) 36” (91.4 cm) **Access door opening 28” (71.1 cm) 52-1/4” (132.7 cm) 3” (7.6 cm) min. Electrical connection for rotisserie motor (position unit so that the plug is always accessible) Electrical connection for power supply cord on 500 Series to be located on rear wall with a maximum distance of 2’ (61.
Gas and Electrical Connection Gas Connection V erify the type of gas supply to be used, either natural or LP , and make sure the marking on the grill rating plate agrees with that of the supply . Never connect an unregulated gas line to the appliance.
3/8” 3/8” male male flare flar e dapter dapter 3/8” male flare adapter Installer supplied flexible gas line with 3/8” female adapter or Viking GHS12 Installer supplied shut-off valve must be e.
3/8” 3/8” male male flare flar e adapter adapter 3/8” male flare adapter T ype 1, QCC-1 connector 3/8” female flare adapter 3/8” male flare adapter Regulator Assembly NOTE: T ank must be mou.
29 5 6 Bubbling bubbles in the soap solution indicates that a leak is present. Stop a leak by tightening the loose joint or by replacing the faulty part with a replacement part recommended by the manufacturer . 7 2 8 1 Do not attempt to repair the cylinder valve if it should become damaged.
31 1/2 " ( 1 .3 cm) 3/8" (. 95 cm) CORRECT YELLOW BLUE LIFTING 5 1 Off 6 2 3 If the flame is yellow, turn the air shutter counter clockwise to allow more air to the burner . If the flame is noisy and lifting away from the burner , turn the air shutter clockwise to reduce the amount of air to the bur ner .
Perfor mance Checklist A qualified installer should carry out the following checks: • All internal packaging removed. • Specified clearances maintained to combustible materials. • Pressur e regulator connected and set. • Manual shut-off valve installed and accessible.
35 34 Service & Registration Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referr ed to a qualified technician.
An important point after buying a device Viking viking (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Viking viking yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Viking viking - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Viking viking you will learn all the available features of the product, as well as information on its operation. The information that you get Viking viking will certainly help you make a decision on the purchase.
If you already are a holder of Viking viking, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Viking viking.
However, one of the most important roles played by the user manual is to help in solving problems with Viking viking. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Viking viking along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center