Instruction/ maintenance manual of the product 200 Viking
Go to page of 12
Viking Range Corporation 111 Front Str eet Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.
IMPORT ANT– Please Read and Follow! 3 Site Pr eparation It is recommended that a thor ough site inspection be conducted PRIOR to unpacking and moving this appliance. W ARNING Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying voltage, hertz, and amps is attached to the product.
5 4 IMPORT ANT– Please Read and Follow! IMPORT ANT– Please Read and Follow! A GFI shall be used if requir ed by NFP A-70 (National Electric Code), federal/state/local laws, or local ordinances. • The requir ed use of a GFI is normally related to the location of a receptacle with r espect to any significant sources of water or moistur e.
Dimensions & Cutout Dimensions 6 7 2 3 - 7 / 8 ” ( 6 0 . 6 c m ) 2 8 - 3 / 4 ” ( 7 3 . 0 c m ) 3 3 - 7 / 8 ” ( 8 6 . 0 c m ) 4 9 ” ( 1 2 4 .
11-17/32" (29.3 cm) 29-3/4" (75.6 cm) to 31-1/4” (79.4 cm) 22-21/32" (57.5 cm) 23-9/32" (59.1 cm) with trim or 23-7/8” (60.6 cm) without trim 10" (25.4 cm) 10-5/8" (27.0 cm) 5/8" (1.6 cm) 5/8" (1.6 cm) 5/8" (1.
Electrical Connections Grounding Instructions This appliance must be grounded. In the event of a malfunction or breakdown, grounding will r educe the risk of electric shock by providing a path of least r esistance for electric current. This appliance is equipped with a cord having an equipment- grounding conductor and a gr ounding plug.
UL approved strain relief d Common Green Ground White Black Run wires thr ough bottom pan. Using a UL approved strain relief, connect wir es to terminal block.
14 15 T rim Installation Options (cont’d.) (not available on all units) T rim Installation Options (cont’d.) (not available on all units) 2 a Dishwasher will ship with trim installed for panel flush install. If needed, attach wiper gasket by pulling protective film off adhesive back on wiper gasket and apply behind hemmed edge of side trim.
Disconnect cable from hook. a Set counter balance spring connector in appropriate location. 2 1 b Increase tension Decrease tension Reconnect cable to hook. c Counter Balance Spring Adjustment - If Necessary NO T E : For custom panel installation, the door may requir e adjustment to the preload of the counterbalance springs.
Remove front panel to access the front leveling legs. 6 a Front Panel Removed Front Panel Attached 5 b Front Panel Removed Front Panel Attached Installation Procedur e (cont’d.) 18 19 Leveling legs will be raised during shipping. Adjust front leveling legs down by using a 1/4 drive ratchet.
20 21 Installation Procedur e (cont’d.) 1 1 A Air Gap (Discharge with food waste disposer and air gap) 1 1 B Air Gap (Discharge with air gap) Connect water line.
23 22 Only authorized replacement parts may be used in performing service on the appliance. Do not repair or replace any part of the appliance unless specifically recommended in the manual.
An important point after buying a device Viking 200 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Viking 200 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Viking 200 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Viking 200 you will learn all the available features of the product, as well as information on its operation. The information that you get Viking 200 will certainly help you make a decision on the purchase.
If you already are a holder of Viking 200, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Viking 200.
However, one of the most important roles played by the user manual is to help in solving problems with Viking 200. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Viking 200 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
