Instruction/ maintenance manual of the product PELLET 5660(I) United States Stove
Go to page of 40
1 Report #: 215 ‐ S ‐ 32 ‐ 4 and 215 ‐ S ‐ 33 ‐ 4 Installation and Operating Manual Models 5660( I ) Safety Notice Please read this en tire manual before installation and use of this pellet fuel ‐ bu rning room heater.
2 TABLE OF CONTENTS Topic Page(s) Introduction 3 Safety Information .
3 Introduction The entire family of United States Stove Company thanks you for pur chasing your new pellet burning room hea ter.
4 SAFETY INFORMATION Be sure to read the entire owner’s manual prior to installing and operating this Pellet heater.
5 SAFETY INFORMATION ‐ continued Keep foreign objects out of the hopper. Contact your local building officials to obtain .
6 SPECIFICATIONS Heating Specifications: Burn Rate: *43,900 btu’s per hour or 5.1 lbs. of fuel per hour Hopper Capacity: 55 lbs. *Dependent upon quality and heating value of pellet fuel.
7 DIMENSIONS ‐ continued The minimum installation dimensions, of the insert opening, are: 32” (813mm) wide x 22 ‐ 3/4” (578mm) high x 12 ‐ 1/4” (311mm) deep.
8 OPERATING INSTRUCTIONS Check and Fill the Fuel Hopper with Pellets: This Pellet Stove is available as a freestanding unit or as a fireplace insert.
9 OPERATING INSTRUCTIONS ‐ continued When the pellets have ignited and flame has been established, the start ‐ up cycle will end; this procedur e takes between 8 and 12 minutes.
10 OPERATING INSTRUCTIONS ‐ continued Control Board Functions: MODE Button: The MODE button allows you to switch operating mode on your Pellet Stove Room Heater.
11 OPERATING INSTRUCTIONS ‐ continued the Auger feed rate will help keep the flames from extinguishi ng on the minimum heat level setting.
12 THERMOSTAT INSTALLATION Optional thermostats are available for use with your pellet stove. A thermostat can help you maintain a constant room temperature.
13 USA 6” CANADA 8” USA 6” CANADA 8” CLEARANCES TO COMBUSTIBLES INSTALL ALL VENTS AT CLEARANCES SPECIFIED BY THE VENT MANUFACT URER! .
14 INSTALLING YOUR ROOM HEATER You have already made the important decision of choosing your U.
15 INSTALLING YOUR ROOM HEATER ‐ continued HORIZONTAL EXHAUST VENT INSTALLATION 1. Locate your pellet stove in a location .
16 INSTALLING YOUR ROOM HEATER ‐ continued HORIZONTAL EXHAUST VENT INSTALLATION .
17 INSTALLING YOUR ROOM HEATER ‐ continued FREESTANDING INTERIOR VERTICAL INSTALLATION 1. Locate your Pellet Stove Room Heater .
18 INSTALLING YOUR ROOM HEATER ‐ continued FREESTANDING EXTERIOR VERTICAL INSTALLATION 1. Locate your Pellet Stove Room Heater i.
19 .
20 INSTALLING YOUR ROOM HEATER ‐ continued SELKIRK DIRECT ‐ TEMP VENT SYSTEM FOR PELLET STOVE HEATERS Images courtesy of Selk.
21 INSTALLING YOUR ROOM HEATER ‐ continued SELKIRK DIRECT ‐ TEMP VENT SYSTEM FOR PELLET STOVE HEATERS Images courtesy of Selk.
22 INSTALLING YOUR ROOM HEATER ‐ continued SELKIRK DIRECT ‐ TEMP VENT SYSTEM FOR PELLET STOVE HEATERS Images courtesy of S.
23 INSTALLING YOUR ROOM HEATER ‐ continued SELKIRK DIRECT ‐ TEMP VENT SYSTEM FOR PELLET STOVE HEATERS Images courtesy of .
24 MOBILE HOME INSTALLATION Mobile home installation shoul d be done in accordance with the Manufactured Home and Safety Stan dard (HUD), CFR 3280, Part 24.
25 INSERT PELLET STOVE INSTALLATION U.S. Stove Pellet Burning Room Heaters are also available as an insert into existing masonry of factory ‐ built fireplaces.
26 INSERT PELLET STOVE INSTALLATION ‐ continued Step 3: Sh roud Top: Facing the back of the unit take the top shroud side piece and fasten, as shown, with 4 screws provided.
27 INSERT PELLET STOVE INSTALLATION ‐ continued Minimum Clearance to Combustibles and Floor Protection .
28 Installation into a Masonry Fireplace: 1. Your chimney must be inspected by a certified chimney sweep or installer to determine its structural condition.
29 VENT TERMINATION LOCATIONS Figure 22 .
30 MAINTENANCE FAILURE TO CLEAN AND MAINTAIN THIS UNIT AS INDICATED MAY RESULT IN POOR PERFORMANCE AND HAZARDOUS SITUATIONS. CLEAN THE HEATER FREQUENTLY AS ACCUMULATION OF SOOT, CREOSOTE OR FLYASH MAY OCCUR.
31 MAINTENANCE ‐ continued Ash Removal ‐ Freestanding Unit: If left neglected ashes will eventually fill the ash pan. Remove the ashes per iodically to avoid unnecessary ash build up.
32 MAINTENANCE ‐ continued Cleaning Heat Exchanger Tubes – Your Pellet Stove Room Heat er is designed with a built in heat exc hanger tube cleaner.
33 MAINTENANCE ‐ continued Chimney/Vent System Cleaning: 1. Soot Formation – When wood products are burned slowly they produce tar and other organic vapors which combine with expelled moisture to form soot.
34 TROUBLE SHOOTING See figure 26, page 31, for component locations . The heater will not light: Check that the heater is plugged in and that the wall outlet has power.
35 TROUBLE SHOOTING ‐ continued The auger motor does not function normally. If the auger shaft does not turn but the motors armature tries to spin then this is a sign your auger is jammed.
36 TROUBLE SHOOTING ‐ continued Door Glass has soot buildup at a fast rate and flame is lazy with black tips.
37 WIRING DIAGRAM .
38 REPLACEMENT PARTS Contact your authorized U.S. Stove Pellet Burning Room Heater dealer to obtain any of these parts.
39 LIMITED WARRANTY United States Stove Company warrants to the original purchaser its Pellet Heaters against premature failure of any component du e to workmanship, quality, or materials as follows: TIME PERIOD: Firebox / Firepot ................
40 .
An important point after buying a device United States Stove PELLET 5660(I) (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought United States Stove PELLET 5660(I) yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data United States Stove PELLET 5660(I) - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, United States Stove PELLET 5660(I) you will learn all the available features of the product, as well as information on its operation. The information that you get United States Stove PELLET 5660(I) will certainly help you make a decision on the purchase.
If you already are a holder of United States Stove PELLET 5660(I), but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime United States Stove PELLET 5660(I).
However, one of the most important roles played by the user manual is to help in solving problems with United States Stove PELLET 5660(I). Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device United States Stove PELLET 5660(I) along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
