Instruction/ maintenance manual of the product 6039HF United States Stove
Go to page of 24
USSC 1 851672 CORN & PELLET MUL TIFUEL ST OVE 6039HF OWNER’S MANUAL Installation - Operation - Maintenance Instructions - Repair Parts READ THIS ENTIRE MANUAL , THOROUGHL Y , BEFORE A T TEMPTING TO INST ALL AND/OR BURN YOUR NEW HEAR TH FOCUS CORN AND PELLET MUL TI-FUEL ST OVE.
2 USSC Heat Input, Maixmum 52,200 BTU/HR Heat Output, Maximum , , , , , 48,280 BTU/HR Heating Capacity 1,200 Sq. Ft 0 Fuel Storage Capacity 60 Lbs. Width 29 in.
USSC 3 6039HF ASSEMBLY Assembly 1. Unpack unit and make sure all components are included; (4) Legs and all hardware for installation. 2. Inside the unit are two(2) Ash Dump Covers located to the left and right of the burnpot. Remove these for leg and guiderail assembly .
4 USSC Ashes will have to be R emoved from the stov e periodical ly . See cleaning procedure. Y our Hearth Focus sto v e, due to the natur e of sol id f uels, wi l l r equir e brief periodic at tention. Please do not expect to l ight your stove and walk away from it.
USSC 5 FLOOR PROTECTION The Hearth Focus Multifuel Stove may be installed on a combustible floor , with proper floor protection, or on a masonry hearth. The hearth or noncombustible floor protector must extend a minimum of (6) inches (152mm)in front and (6) inches (152mm) from each side of the ash remov al door .
6 USSC CLEARANCES TO COMBUSTIBLES The stove must be installed with the following minimum clearances to side and back wall combustible materials. NOTE: These are minimum clearances to combustible walls established by the testing lab. The amount of room needed on the left side of the unit to access the electrical panel is (6) six inches (152mm).
USSC 7 GUIDELINES FOR EXHAUST VENTING SYSTEMS DESIGN • • • • • • • • A UL listed 3” or 4” type “PL ” pellet vent exhaust system must be used f or installation and attached to the pipe connector provided on the back of the sto ve.
8 USSC For installations with horizontal through-the-wall exhaust, it is strongly recommended that the stove combustion air be connected to the outside. If the home is newer or has been tightly insulated it is required to install outside combustion air .
USSC 9 Locate proper position f or the type “PL ” wall thimble (F). Use a saber saw or keyhole saw to cut a 7 1/4-inch diameter hole through the wall (E) for a 3-inch pipe. For a 4-inch pipe, cut an 8 1/4-inch hole. Install the wall thimble (F)in the hole.
10 USSC Note: Always check dimensions on unit before cutting hole in wall Dimensional tolerance ±0.25” 10 1/16 11 5/8 12 E XHAUST OUTLET 3' DIA COMBUSTION AIR INTAKE 1 7/8" DIA 6039HF 3.
USSC 11 THROUGH THE WALL, VERTICAL PIPE INSTALLATION WITH TERMINATION CAP The Hearth Pad is not required under the unit if the floor is noncombustible but is required 6 inches (152mm) beyond the front of the unit and 6 inches (152mm) beyond each side of the door if the floor is a combustble floor .
12 USSC Y our Hearth Focus Corn/Pellet Stove comes to you with the glass door installed in place, ready for use. The glass is surrounded on the edges with a gasket and seated in a glass channel. It is held in place with four (2) clips. REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS Open the door and lift off of hinges.
USSC 13 UNDERSTANDING THE CONTROL BOARD CONTROL PANEL T urning the heater OFF/ON, as well as adjustments for the fuel feed rate and room fan speed are performed by pressing the appropriate button(s) on the control panel which is located on the lower left-hand side of your Hearth Focus heater.
14 USSC CAUTION: DO N OT USE CHEMICALS OR FLUIDS TO ST ART THE FIRE HOT WHILE IN OPERA TION. KEEP CHILDREN, CLO THING AND FURNITURE AW AY . CONT ACT MA Y CAUSE SKIN BURNS. LIGHTING INSTRUCTIONS Before lighting y our Hearth Focus for the first time, make sur e that al l items are out of the hopper , ash pan and firebox area.
USSC 15 SPECIAL CLEANING/OPERATIONAL INSTRUCTIONS: After cleaning or when operating the stove, you need to make sure that “both” clean-outs are in their proper position. If left out or placed incor- rectly , the combustion air is eff ected greatly and the stove will not burn properly .
16 USSC FUEL ADDITIVE Chicken Scratch for my Corn Burner? Y es - Cr azy as it may sound, ground Oyster Shells, (calcium carbonate) same as fed to chickens, is the ideal additiv e to promote clean burning, especially when the Corn Fuel is extra high in starch.
USSC 17 Exhaust Blower Agitator Auger Room Fan Automatic Shutdown Normal Operation COMPONENT OPERA TION ST ART OPERA TION END CIRCUIT BOARD FUNCTIONS ST ART -UP SEQUENCE OF EVENTS Once the control panel is turned to on, a timer begins that will start, stop and continue operation of the Hearth Focus as a preset temperature is achieved.
18 USSC ERROR CODES and DISPLAY INDICATORS CAUTION: When performing any internal electrical maintenance • Moving parts inside of the cabinet may cause injury . Do not oper ate unit with panels remov ed or open. • HOT parts. Do not operate the unit with panel open.
USSC 19 TROUBLE SHOOTING Unplug stove before performing any maintenance PROBLEM CAUSE: T oo rich air/fuel mixture ? Fire burns with a lazy , orange flame and/or fuel builds up in the firepot. Glass may become dirty . ? Fire goes out or stove shuts down.
20 USSC WIRING DIAGRAM.
USSC 21 REPAIR PARTS DIAGRAM-6039HF.
22 USSC K EY PAR T # DESCRIPTION QTY. 1 69516 Feed Door Assembly 1 2 25080MB Latch, Door 1 3 25523 Leg, Cast Iron 4 4 69478MB Ash Pan Weldment (6039) 1 5 69486MB Left Side Weldment 1 6 25412MB Cabinet.
USSC 23 1 3 2 4 5 6 7 9 10 8 11 2 3 1 6 4 5 K e y Part No. Descritption Qty. 7 83278 #10 Flat Washer 4 8 25465 R etainer , Bottom Glass 1 9 25464 R etainer , T op Glass 1 10 83202 Machine Screw 4 11 891135 Handle, Spring (Parts Bag) 1 K e y Part No. Descritption Qty.
24 USSC THIS MANUAL WILL HELP YOU OBTAIN EFFICIENT, DEPEND- ABLE SERVICE FROM YOUR HEARTH FOCUS, AND ENABLE YOU TO ORDER REPAIR PARTS CORRECTLY. KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFER- ENCE. WHEN WRITING, ALWAYS GIVE THE FULL MODEL NUMBER WHICH IS ON THE NAMEPLATE ATTACHED TO THE HEATER.
An important point after buying a device United States Stove 6039HF (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought United States Stove 6039HF yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data United States Stove 6039HF - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, United States Stove 6039HF you will learn all the available features of the product, as well as information on its operation. The information that you get United States Stove 6039HF will certainly help you make a decision on the purchase.
If you already are a holder of United States Stove 6039HF, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime United States Stove 6039HF.
However, one of the most important roles played by the user manual is to help in solving problems with United States Stove 6039HF. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device United States Stove 6039HF along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
