Instruction/ maintenance manual of the product Kitchen Ventilation Systems Unified Brands
Go to page of 16
This manual provides installation & operating instructions for KITCHEN VENTILA TION SYSTEMS OPERA TORS MANUAL NOTIFY CARRIER OF DAMAGE A T ONCE. It is the responsibility of the consignee to inspect the container upon receipt of same and to determine the possibility of any damage, including concealed damage.
NOTICE: Due to a continuous program of product improvement, Randell Manufacturing reserves the right to make changes in design and specifica- tions without prior notice. NOTICE: Please read the entire manual carefully before installation. If certain recommended procedures are not followed, warranty claims will be denied.
MODEL NUMBER SERIAL NUMBER INST ALLA TION DA TE INST ALLA TION INSTRUCTIONS OPERA TING INSTRUCTIONS ST ART - CHECK - BALANCE FINAL AIR BALANCE Installation Requirements for Rande ll Air Systems Hoo ds ................... .............. page 2 Canopy Hoods .
Installation Requirements FOR ALL RANDELL AIR SYSTEMS HOODS 2 888-994-7636 IN ST AL LA T IO N I NST RUC TIO NS Randell Air Systems hoods are provided with slotted hanging brackets designed to re- ceive 1/2” threaded rod with a 1/2” bolt and washer .
3 avtec.com IN ST AL LA T IO N I NST RUC TIO NS 1. Check all local codes prior to installation. Special requirements may be necessary depending upon building material construction. 2. Move crated hood to location of installation and very carefully uncrate vent.
4 888-994-7636 DECK OVEN INST ALLA TION: (MODEL VPO) 1. Check all local codes prior to installation. Special requirements may be necessary depending upon building material construction. 2. Move crated hood to location of installation and very carefully uncrate vent.
5 avtec.com 1. Check all local codes prior to installation. 2. All exhaust fans are supplied with a minimum ?????? , hinge kit, and gr ease box. 3. The exhaust fan curb should be installed directly above the hood if possible. Always maintain the shortest duct run possible.
6 888-994-7636 1. Check all local codes prior to installation. 2. Supply fan inlet must be located to minimum 10’-0’ fr om the exhaust fan. If 10’-0’ is not possible a 3’ vertical separation may be acceptable. 3. Cut and seal supply fan curb to roof.
avtec.com Some Randell Air Systems canopy hoods will be designed with our patented Air V olume Controllers (A VC) located directly behind the standard filter bank. The A VC are specially designed to exhaust high volumes of air over high heat - high grease producing equipment thereby reducing the total exhaust volume.
8 888-994-7636 PIECES PROVIDED One or two optional side skirts may be provided INST ALLA TION 1. Side skirts are of f set at the top and have a 90º bend inward at the rear . 2. Skirts are to overlap the outside of the hood. Bolts and acorn nuts should be at- tached per the drawing.
9 avtec.com INST ALLA TION OF ENCLOSURE P ANELS PIECES PROVIDED Enclosure panels ar e provided for exposed side(s) of hood(s) INST ALLA TION INSTRUCTIONS 1. Hoods order ed with enclosure panels will be shipped with threaded metal studs installed on perimeter of hood top where panels ar e to be installed.
10 888-994-7636 PIECES PROVIDED Insulated wall panel comes in two pieces. A. T op panel will have a 1” flange full length top and bottom and, interlocking slots located on the bottom. B. Bo ttom panel will have inte rlock ing t abs o n top and full lengt h 1” flange on b ottom .
11 avtec.com ST ART - CHECK - BALANCE 1. Close all doors and windows. 2. Operate all exhaust fans, even fans serving other hoods make-up air unit and building HV AC. 3. T urn on all c ookin g equ ipmen t und er th e hoo d to pre heat to op erati ng te mpera tur e.
ST ART - CHECK - BALANCE EXHAUST F AN(S) 1. Open all doors and/or windows leading to outside. 2. Start the exhaust fan only . Do not run the supply fan or Make-up unit. 3. Ref er to Rand ell A ir Sy stems draw ings and/o r U.L . inf ormat ion l abel on ho od fo r pr oper CFM requ ire ments .
13 avtec.com Fan No. Designed RPM Actual RPM Designed CFM Actual CFM 1. 2. 3. 4. 5. T otal Exhaust Fan No. Designed RPM Actual RPM Designed CFM Actual CFM 1. 2. 3. 4. 5. T otal Exhaust Unit No. Designed RPM Actual RPM Designed CFM Actual CFM Outside Air CFM 1.
NOTES AND WORKSHEET UNIFIED BRANDS 1055 Mendell Davis Drive Jackson, MS 39272 888-994-7636 fax 888-864-7636 avtec.com.
An important point after buying a device Unified Brands Kitchen Ventilation Systems (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Unified Brands Kitchen Ventilation Systems yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Unified Brands Kitchen Ventilation Systems - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Unified Brands Kitchen Ventilation Systems you will learn all the available features of the product, as well as information on its operation. The information that you get Unified Brands Kitchen Ventilation Systems will certainly help you make a decision on the purchase.
If you already are a holder of Unified Brands Kitchen Ventilation Systems, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Unified Brands Kitchen Ventilation Systems.
However, one of the most important roles played by the user manual is to help in solving problems with Unified Brands Kitchen Ventilation Systems. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Unified Brands Kitchen Ventilation Systems along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
