Instruction/ maintenance manual of the product UH-048XR Uniden
Go to page of 32
UH-048XR Operating Guide.
➤ Do not operate the transmitter of any radio equipment unless all the Radio Frequency (RF) connectors are secured and any open connectors are properly terminated. ➤ Do not operate the transmitter of any radio equipment near electrical blasting caps or in an explosive atmosphere.
Introduction Features 1 T echnical Support & Service 2 Included in your UH-048XR Package 3 Getting Started Battery Installation 4 Low Battery Alert 5 Belt Clip 5 Wrist Strap 6 Operation Power on/o.
The UH-048XR is a portable two-way UHF-CB radio. It is compact, rugged and fits easily in your hand. This hand held UHF radio will give you consistent, outstanding performance in virtually all conditions and situations.
TECHNICAL SUPPORT AND SERVICE Should you find it desirable or necessary to service your UH-048XR , we suggest you contact the Uniden dealer where you purchased your radio.
INCLUDED IN YOUR UH-048XR P ACKAGE 3 Note: If any of these items are missing from the box, contact your Uniden Dealer . Wrist Strap Belt Clip Desk T op Charger UH-048XR AC Adaptor Operating Guide Prod.
BA TTERY INST ALLA TION Y our UH048XR radio uses 4 AAA batteries (not supplied) for power . Please refer to page 14 should you wish to use rechargeable batteries. T o install the batteries: 1. Make sure your radio is off. 2. Press battery cover release.
LOW BA TTERY ALERT The LCD on your radio shows a battery meter in the upper right corner . icon indicates a fully powered unit. As the batteries lose power , will flash. When the batteries in the unit are low replace the batteries immediately to continue using the radio.
WRIST STRAP 1. Insert the short end of the strap through the belt clip hole in the top of the belt clip. 2. Slip the long end through the loop to enclose the clip in the strap and pull tight.
➤ When you press any key (except PTT), a short tone sounds. ➤ See the Controls and Indicators page at the back of this operating guide for button and key operations. POWER ON/OFF Press and hold [Power/Enter] button until a melody is heard. A channel number and battery level should appear on the display .
SELECTING CHANNEL 1. Press [ Function] until “ ” appears in the large display . The current channel flashes. 2. Press [ ▲ ] or [ ▼ ] to select the desired channel 3. Press [] to confirm your selection, otherwise, the radio will automatically return to standby and the new channel will be displayed.
The TX indicators and appear on the LCD. Hold the radio with microphone approximately two inches in front of your mouth with the antenna at approximately 45˚ angle away from your head. Speak in a clear , normal conversational voice. 4. When you have finished speaking, release the [PTT] and listen for a response.
Press [ ▲ ] or [ ▼ ] to select the additional channel you wish to monitor . Press [] to confirm your selection and to activate dual-watch mode. Otherwise, the selected channel is automatically accepted if no key is pressed after 5 Secs. Note: Pressing [Function] will stop Dual-W atch Mode operation.
CONTINUOUS TONE CODED SQUELCH SYSTEM (CTCSS) CTCSS is a feature that allows a group to talk to each other without hearing other users on the same channel. NOTE : Uniden discourages the use of CTCSS feature until the Australian Communications Authority (ACA) grants the use of CTCSS on CB frequencies.
On the example below only radio 1 and 9 can communicate or hear each other because they are using the same or common CTCSS code. CTCSS T one Display This feature allows you to select the preferred display format for the CTCSS code setting. If frequency was chosen, then the display in the CTCSS will be shown as frequency .
3. Press [] to confirm your selection. Otherwise, the displayed state is automatically accepted if no key is pressed after 5 Secs. VOICE ACTIV A TED (VOX) VOX feature enables user to transmit automatically by speaking on the microphone without pressing the PTT switch.
in the large display and the VOX icon [ ] flashes. 2. Press [ ▲ ] or [ ▼ ] to select the delay time. 3. Press [] to confirm your selection. Otherwise the selected time is automatically accepted when no key is pressed after 5 Secs.
The radio momentarily beeps as appears on display and [ ▲ ] or [ ▼ ] and [] immediately goes into auto lock if no key is pressed within 10 Secs. T o deactivate keylock temporarily , press and hold [Function] until disappears. Keys will go into auto lock again if no key is pressed within 10 Secs.
T o use Call Melody: Press [PTT] twice. Call Melody will be heard on user ’ s radio and on all radios using the same channel. MONITOR This feature enables users to listen in for weak signals on the current channel at the press of the [Monitor] button.
BA TTERY LEVEL DISPLA Y The icon in the top right hand corner of the screen indicates the UH-048XR current battery voltage level at all times. The battery level is displayed in 3 levels: LEVEL 3 Batte.
BA TTERY CHARGE Warning Notice! This UH048XR is designed to charge Ni-Cd batteries only . Use only the power Adaptor AAD-048S with 4 AAA size Ni-Cd batteries. T urn the power off. Follow charging set-up below . Note 1: To fully charge the battery , leave the AC Adaptor (AAD- 048S) charging for 14-16 hours.
* Emergency calling for simplex operation Please do not use this channel in non-emergency cases. # Back-up Emergency Channel Ch. Freq. Usage Ch. Freq. Usage 01 476.425 Simplex 21 476.925 Simplex 02 476.450 Simplex 22 476.950 Simplex 03 476.475 Simplex 23 476.
• AC Adaptor (AAD-048) • Desk T op Charger (DTC-048) • Speaker Microphone (SM-048) • Headset Microphone (HM-048) OPTIONAL ACCESSORIES ACCESSORIES Code No. Freq. (Hz) Code No. Freq. (Hz) Code No. Freq. (Hz) 00( ‘ oF ’ ) OFF 13 103.5 26 162.
General Channels T ransmit 40 Receive 40 Oper . T emp. 0 ˚ C - +55 ˚ C Antenna Fixed Microphone Built-in Electret type Display Liquid Crystal Display Speaker Round T ype Power Source 4 x AAA Size Batteries Size (without antenna) 99(H) x 51.7(W) x 24.
Receiver Receiver T ype Dual Conversion Super Heterodyne Phase Locked Loop System for Local Oscillator Frequency Range 476.425 to 477.4 MHz Sensitivity @ 0.28 µV 20 dB SINAD Squelch Sensitivity 0.19 µV (Threshold) Audio Frequency Response 500Hz, 5dB (ref: 1KHz, ± 3KHz Dev .
UNIDEN UH-048XR UHF CB RADIO Limited One Y ear Warranty Note: Please keep your sales docket as it provides evidence of warranty . Warrantor: Uniden Australia Pty Limited ACN 001 865 498 Uniden New Zea.
Warranty card: If a warranty card has been included with this product, please fill it in and return it to us within 14 days of purchase. Procedure for obtaining performance or warranty: In the event t.
6 1 5 2 7 8 9 10 3 4 12 13 11 Power/Enter Function Monitor UH048 CONTROLS & INDICA TORS 25.
1. Detachable Belt Clip 2. Battery Cover 3. Antenna 4. PTT (Push-to-talk) Button 5. External Mic/Speaker/ Charger Jack 6. LCD Display 7. Function Button 8. Monitor Button 9. Built-in Speaker 10. Down Button & V olume Control 11. Up Button & V olume Control 12.
.
.
© 2000 Uniden Australia Pty Limited/ Uniden New Zealand Limited.
An important point after buying a device Uniden UH-048XR (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Uniden UH-048XR yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Uniden UH-048XR - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Uniden UH-048XR you will learn all the available features of the product, as well as information on its operation. The information that you get Uniden UH-048XR will certainly help you make a decision on the purchase.
If you already are a holder of Uniden UH-048XR, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Uniden UH-048XR.
However, one of the most important roles played by the user manual is to help in solving problems with Uniden UH-048XR. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Uniden UH-048XR along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
