Instruction/ maintenance manual of the product KEU-300 Series Ultra Start
Go to page of 8
FCC/ID Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
St atus LED/ Program Switch Shock Sensor Sensitivity Brown St arter Disable Relay St arter Disable Relay Ground When Armed See Page 3. See Page 5. See Page 5. See Page 3. See Page 3. See Page 3. See Page 4. See Page 4. See Page 3. See Page 3. See Page 3.
12 pin Main Harness Red - +12volt Power Source Input. Connect this wire to a +12 VDC constant power source. T o Battery or Ignition Harness. Black - System Ground Input. Connect this wire to chassis ground. T o a clean unpainted metal surface. Y ellow - Switched ignition input.
12 Pin Connector ....Continued Purple- Positive Door Pin Input. Connect this wire to vehicles that have a door pin that switches to 12 volts when the door is opened. Green- Negative Door Pin Input. Connect this wire to vehicles that have a door pin that switches to Negative when the door is opened.
3 Pin Connector Continued Y ellow- Unlock Switch Sense Input Mode. This input is designed to prevent the switch from disarming the alarm system. Connect this wire to the Unlock wire that is activated with the unlock switch in the door but not by the factory remote.
DIP Switch Settings The DIP switches on the module are used to turn programmable features ON and OFF . The following are the features that are controlled by the DIP switches.
System Programming The following features are programmed using the ignition switch and the LED/ Program Switch. T o Enter Program Mode 1) T urn the ignition key “ON/OFF”, “ON/OFF” “ON” Leaving the key in the ON position. 2) Press and release the LED/ V alet Switch One time.
Setting #3- Park Light Output T urn the ignition key “ON/OFF”, “ON/OFF” “ON”, press and release the program switch 3 times. The LED will flash Three times to confirm setting Three. Hold the program switch until the siren chirps the appropriate number of times.
An important point after buying a device Ultra Start KEU-300 Series (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Ultra Start KEU-300 Series yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Ultra Start KEU-300 Series - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Ultra Start KEU-300 Series you will learn all the available features of the product, as well as information on its operation. The information that you get Ultra Start KEU-300 Series will certainly help you make a decision on the purchase.
If you already are a holder of Ultra Start KEU-300 Series, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Ultra Start KEU-300 Series.
However, one of the most important roles played by the user manual is to help in solving problems with Ultra Start KEU-300 Series. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Ultra Start KEU-300 Series along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
