Instruction/ maintenance manual of the product 45xx Series Ultra Start
Go to page of 16
-The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle.
Page 2 This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
2WAY R EMOTE ST ARTER/ ALARM OWNER ’S GUIDE Page 3 R emote Star t - A u t o m a t i c T r a n s m i s s i o n 1. Press and release button #3. 2. The park light s will flash and the siren will chirp one time. 3. The vehicle will then remote start. The p ark light s will flash four times then remain on while the vehicle is running.
Page 4 Idle Mode 1. While the vehicle is running with key , press button #3 . 2. The park light s will turn on and the siren will chirp once. 3. T urn the ignition key off and the vehicle will continue to run. 4. Exit the vehicle and leave it running safely without leaving the keys in the Ignition.
Manual transmission remote st arters must be set into Reservation Mode before the remote st arter will activate. There are two different ways to place the system into Reservation Mode. The activation type of Reservation Mode is determined when the system is inst alled.
Page 6 1. Press and hold button #2 and the doors will unlock, continue holding button #2, the trunk release will activate. The trunk release will be confirmed by one park light flash and one siren chirp. Note: The trunk release output will not activate when the ignition key is in the “On” position.
Page 7 Car Finder is a feature that can be used to find your vehicle in a crowded parking lot. 1. Press and release button #4 twice within 3 seconds. 2. The park light s will flash and the siren will chirp five times to draw attention to the location of the vehicle.
Page 8 Auxiliary Output 1 (Optional) Sir en On/Of f Auxiliary Output 2 (Optional) Auxiliary Output are optional output s from the system. These output s Can be used to activate such things as power window roll-up/ down modules or to open and close a power sun roof.
Page 9 Cold S tart Mode will st art the vehicle at a user selectable st art interval or temperature setting. The vehicle can be set to start once every 1, 2, 3 or 4 hours in T imer Mode or to st art at 0,-5,-15 or -25 Celsius in T emperature Mode (L T Models Only) for a maximum 12 start s.
Page 10 KEY ICON- This icon will begin to flash when the remote st arter button is first pressed. Af ter the vehicle has st arted this icon will stay on solid. SIREN ICON- This icon indicates that the alarm has been triggered. The remote will st art to beep and the siren icon will come on solid at the same time as the icon for the violated zone.
Page 1 1 TIMER ICON- When this icon is displayed in the left program column if confirms that the T imer Mode has been programmed ON. When this icon is turned on in remote program mode the Cold S t art feature will be activated. Cold S t art will default to the last time or temperature setting.
Page 12 1 2 3 4 1 2 3 4 1st 2nd This feature can be used if the vehicle is p arked in an area with above average noise or vibrations. (Airport s, construction zone...) T o T emporally Byp ass The Shock Press the button #1 to arm the alarm then press button #3 within three seconds.
Page 13 1) Press and hold buttons #1 and #4 until the minute portion of the clock begins to flash. 2) T o set the minute, press button #3 to increase and button #2 to decrease the minute. 3) T o set the hour , press button #1 and the hour portion of the clock will begin to flash.
Page 14 A TTENTION: T O A VOID SERIOUS INJUR Y , this remote st art system must be set into Service Mode before any under hood servicing is st arted. Service Mode will prevent the vehicle from st arting while the vehicle is being serviced. It is the sole responsibility of the vehicle’ s owner to place the system into Service Mode.
Page 15 Being that the installer does not always see when the system shut s down or fails to start, Diagnostic Memory will store in memory up to four shut down codes. This information can then be accessed to determine the source of the shut down. T o Enter Diagnostic Mode: St ep 1 - T urn the ignition on then off.
Limited Lif etime W ar r anty The manufacturer warrants to the original purchaser of their remote starters and alarms, that the product shall be free from defects in material and workmanship.
An important point after buying a device Ultra Start 45xx Series (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Ultra Start 45xx Series yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Ultra Start 45xx Series - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Ultra Start 45xx Series you will learn all the available features of the product, as well as information on its operation. The information that you get Ultra Start 45xx Series will certainly help you make a decision on the purchase.
If you already are a holder of Ultra Start 45xx Series, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Ultra Start 45xx Series.
However, one of the most important roles played by the user manual is to help in solving problems with Ultra Start 45xx Series. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Ultra Start 45xx Series along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
