Instruction/ maintenance manual of the product U-CO2175FW-00 U-Line
Go to page of 25
® COMBO ® MODELS REFRIGERA T OR / FREEZER MODELS COMBO® MODELS USE AND CARE GUIDE REFRIGERA T OR FREEZER MODELS U-LINE.COM U-CO2175FB-00 U-CO2175FS-00 U-CO2175FS-01 U-CO2175FW -0 0 U-CO29B-00 U-CO2.
u-line.com FOR PRODUCT ASSIST ANCE, CALL 1-800-779-2547 MIL W AUKEE, WI U.S.A. Serial/Serie: Model/Modele: HIGH SIDE DESIGN PRESSURE 300 PSI LOW SIDE DESIGN PRESSURE 140 PSI REFRIGERA TOR AND/ BTL LISTED 674R OR FREEZER HOUSEHOLD U C L R US www .u-line.
Safety Precautions Safety Alert Defi nitions ................. .......................... ..................... ......................... ............. ....................... ........... 1 General Precautions ........................... .............
u-line.com 1 NOTICE • PLEASE READ all instru ctions befor e installing, operating, or servicing the appliance. • Proper installation pr ocedures must be follo wed when completing an inst allation or relocation of a unit.
2 u-line.com Pr oduct Featur es Combo® Model F eatures: Built-in or Freestanding. Pro vides custom look w hen built-in with no additional v enting clearance needed on sides, top or r ear . Do not obstruct the gri lle. Ice making and r efrigeration in one unit.
u-line.com 3 Contr ol Systems A portion of models cov ered in this guide use an electr onic touch contr ol while others use a man ual contr ol system. See the table below to identify your model and equipped contr ol system.
4 u-line.com Checking Pr oduct T emperatur e T o check the actual pr oduct temperatur e in the unit. 1. Partially fill a plas tic (nonbr eakable) bottle with wat er . 2. Insert an accurate thermom eter . 3. Tighten the bottle ca p securel y . 4. Place the bottle in the desi red ar ea for 24 hours.
u-line.com 5 Electr onic Control Quick Guide Ta s k To u c h To u c h Displa y Comment T urn ON/OFF Hold 10 seconds Release when °F flashes. or Adjust Te m p e r a t u r e or T ouch an d release or T ouch to change temperature. °F flashes after f irst touch, set-point sav ed after 5 seconds of i nactivity and ° F stops flas hing.
6 u-line.com Air Flo w NOTICE The unit requires pr op er air flow to perf orm at its highest efficiency . Do not block the fr ont grille or internal fans at any time, or the unit will not p erform as expected. Do not install the unit behind a door . CO29FF Initial Startup All U-Line contr ols are pr eset at the factor y .
u-line.com 7 Adjusting Air T emperatur e Combo Models NOTICE • Adjust the set point temperatur e in single increme nts, and wait 24 hours f or the temperatur e to stabiliz e be fo re re c he c ki ng . • Factory recommended set-point is between 3 & 4 on the dial contr ol.
8 u-line.com Dra wers The dra wers shou ld only be r emov ed for ser vicing by a trained and certified repair personal. To p S t o r a g e B i n Grasp the bin handle and slide ba ckward to access the contents below .
u-line.com 9 Ice Mak er Operation When the ice buck et is full, the ice making mechanism will shut off. How ev er , the r efrigeration system will continue to cool and maintain the ice supp ly . Frost-fr ee ice maker units ha ve low er ice pr oduction than manual defr ost units.
10 u-line.com Le veling NOTICE Unit must be lev e l, for pr oper door and ice mak er (if equipped) operation. For Models with adjustable lev el ing feet: 1. Use a level to check the levelness of the unit from front to back and from side to side . Place th e le ve l along top edge and side edge as show n (1).
u-line.com 11 Remo ving and Installing Grille WARNING ! Disconnect electric pow er to the unit before r emo ving the grille . WARNING ! DO NO T touch the condenser fins (4). The condenser fins are SHARP and can be easily dama ged. Remo ving the grille.
12 u-line.com Door Systems A portion of models cover ed in this guide use the “Self-Closing” door system while ot hers use the standar d door system. See the table below to help identify which door system y our model is equipped with. Standar d doors should refer ence “Standard Doors” on page 15 .
u-line.com 13 Door Re versability Location of the unit ma y make it desirable to mount the door on the opposite side of the cabinet. Man y doors are r ev ersible . See table below . Re versing Black or White Doors • The hinge hardwar e will be remov ed and reinstalled on the opposite side of the cabinet.
14 u-line.com Prepar e door for reinstalla tion. 1. Remov e plastic hole plug from top of door handle and r einstall on opposite si de. 2. Wit h bottom of door facing up, remo ve pivot plate (5) (two scre ws). 3. Fli p ov er and instal l pivot plate on opposit e side of door .
u-line.com 15 Door Alignment and Adjustment Align and adjust the door if it is not lev el, or is not sealing prope rly . If the door is not sealed the unit ma y not cool properl y , or excessiv e fros t ma y form in the interior .
16 u-line.com Install bottom hinge: 1. If you ha ve a plate hinge, reorient the pivo t screw so it pr otrudes the opposite dir ection form the hinge. Remove the pivot scre w from the hinge. T urn the plate ov er and reinstall the scre w . 2. Al ign hinge outer edge wit h cabinet.
u-line.com 17 Checking Dra wer Alignment The unit’ s draw ers are aligned at the fac tor y befor e shipment. How ev er , their alignmen t could ha ve been disturbed during shipment or during ov erlay panel installatio n.
18 u-line.com Minor Adjustment: Note: The mounting holes on the slide ar e slightly larger than the scre ws’ diameter . 1. Loosen one slide’ s mounting screws. 2. Lev el the slide. 3. Retighten the scr ews. 4. Repe at procedure for the other slide .
u-line.com 19 To d e f r o s t : 1. Disconnect po wer to the unit. 2. For combo models remov e al l products fr om t he interior . 3. Remove ice buck et and discard ice. 4. Pl ace tow el or other absorbent material on bottom of ice bin. For combo models, a lso place in bottom of uni t.
20 u-line.com Condensor Cleaning Interv al - Ev er y Thre e Months T o maintain operational efficiency , keep the fr ont grille free of dust and lint, and clean the condenser ev er y three months. Depending on envir onmental conditions, mor e or less fr equent cleaning ma y be necessary .
u-line.com 21 Befor e Calling for Ser vice If you think y our U-Line pro duc t is malfunctioning, r ead the OPERA TION section of this guide to cl early understand the function of the contr ol.
® USE AND CARE GUIDE ©2013 U-Line Corpor ation Publication Number 30265 4/ 2013 Rev . F The American Built-In Under c ounter Leader Since 1962 U-LINE.
An important point after buying a device U-Line U-CO2175FW-00 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought U-Line U-CO2175FW-00 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data U-Line U-CO2175FW-00 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, U-Line U-CO2175FW-00 you will learn all the available features of the product, as well as information on its operation. The information that you get U-Line U-CO2175FW-00 will certainly help you make a decision on the purchase.
If you already are a holder of U-Line U-CO2175FW-00, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime U-Line U-CO2175FW-00.
However, one of the most important roles played by the user manual is to help in solving problems with U-Line U-CO2175FW-00. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device U-Line U-CO2175FW-00 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
