Instruction/ maintenance manual of the product CDA 645 F Beko
Go to page of 11
CDA 645 F BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF T el: 01923 654650 Fax: 01923 819653 e-mail: service@beko.co.uk website: www .beko.
CONTENTS P AGE SAFETY FIRST / ELECTRICAL REQUIREMENTS TRANSPORT A TION INSTRUCTIONS INST ALLA TION INSTRUCTIONS GETTING TO KNOW YOUR BEKO FRIDGE / FREEZER REVERSING THE DOORS SUGGES.
ELECTRICAL REQUIREMENTS Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply . Rating label is on the left hand side of fridge inner liner .
5 6 GETTING TO KNOW YOUR COMBI BEKO FRIDGE / FREEZER 3. Do not place the appliance near cookers, radiators or in direct sunlight as this will cause your appliance to work harder .
7 8 REVERSING THE DOORS (Y ou may need somebody to help you.) 1- Switch off the appliance at the socket outlet and pull out the mains plug. 2- Remove all loose items and fittings and food, if any , from inside the appliance and door racks .
SUGGESTED ARRANGEMENT OF FOOD IN THE FRIDGE/FREEZER Arrangement Examples (See diagram) 1. Baked, chilled cooked food, dair y products, cans. 2. Meat, sausages, cold cuts. 3. Fruit, vegetables, salads. 4. Making, storing ice cubes. 5. Frozen food. 6. Frozen food and freezing of fresh food.
STORING FROZEN FOOD Prepacked commercially frozen food should be stored in accordance with the frozen food manufacturer's instructions for a frozen food storage compartment. T o ensure that the high quality achieved by the frozen food manufacturer and the food retailer is maintained, the following should be remembered: 1.
DEFROSTING A) FRIDGE COMP ARTMENT The fridge compartment defrosts automatically . The defrosting water runs to the drain tube via a collection container at the back of the appliance (1). (see diagram) During defrosting water droplets may form at the back of the fridge compartment where concealed evaporator is located.
REPLACING THE INTERIOR LIGHT BULB (See diagram) Should the light fail to work, proceed as follows. 1. Switch off at the socket outlet and pull out the mains plug.
18 ENERGY SA VING TIPS 1- Ensure your appliance is installed in a well ventilated area. If the ambient temperature is low (but in no case lower than 5 degrees C), then the energy saving will be more.
19 HOW TO OBT AIN SERVICE Please keep your purchase receipt or other proof of purchase in a safe place; you will need to have it should the product require attention under guarantee. Y ou should also complete the details below; it will help us assist you when requesting ser vice.
An important point after buying a device Beko CDA 645 F (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Beko CDA 645 F yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Beko CDA 645 F - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Beko CDA 645 F you will learn all the available features of the product, as well as information on its operation. The information that you get Beko CDA 645 F will certainly help you make a decision on the purchase.
If you already are a holder of Beko CDA 645 F, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Beko CDA 645 F.
However, one of the most important roles played by the user manual is to help in solving problems with Beko CDA 645 F. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Beko CDA 645 F along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
