Instruction/ maintenance manual of the product SD-R6112 Toshiba
Go to page of 34
TOSHIBA STORAGE DEVICE DIVISION SD-R6112 DVD-R/-RW DRIVE PRODUCT SPECIFICATION APRIL 200 3 REV. 1. 0 Specifications are subject to change without notice DOCUMENT NUM BER 15998.
SD-R6112 Rev.1.0 LIMITATION OF LIABILITY Those warranties in the express warranty separately agreed between TOSHIBA and your company are the only warranties given to the consumer and are in lieu of any other warranties, whether express or implied with regard to this component.
SD-R6112 Rev.1.0 DO NOT use this equipment in the system such as medical equipment which may cause personal injury or property damages resulting from malfunction of this equipment and unexpected data corruption or data error in reading operation.
SD-R6112 Rev.1.0 Contents 1. Introduction ---------------------------------------------------------------------------------------------------------------------- 1 2. Features -------------------------------------------------------------------------------------------------------------------------- 1 3.
SD-R6112 Rev.1.0 7. Power Requirements ----------------------------------------------------------------------------------------------------- 22 7.1. Source Voltage ------------------------------------------------------------------------------------------------------ 22 7.
1/28 SD-R6112 Rev.1.0 1. Introduction This document describes TOSHIBA's SD-R6112 DVD-R/-RW Drive. 2. Features This drive reads DVD CSS (Contents Scramble Systems) Disc. This drive reads digital data stored on CD-ROM, DVD-ROM and CD audio discs. This drive read and records the digital data on DVD-R/-RW and CD-R/-RW discs.
2/28 SD-R6112 Rev.1.0 3. Specifications 3.1.Performance (1) Applicable Write Format DVD-R :Disc at once, Incremental write DVD-RW :Disc at once, Incremental write, restricted overwrite CD-R/RW :Disc at once, Track at once, Session at once,Packet write (2) Applicable Write Disc * 1 DVD-R :DVD-R (Ver2.
3/28 SD-R6112 Rev.1.0 (5) Rotational Speed * 2 DVD (Single) : Approx. 4,670 rpm (3.3-8X CAV) DVD (Dual) : Approx. 3,792 rpm (2.5-6X CAV) DVD-R Ver.1.0 : Approx. 2,560 rpm (1.7-4X CAV) DVD-R Ver.2.1 : Approx. 2,224 rpm (1.7-4X CAV) DVD-RW Ver. 1.1 : Approx.
4/28 SD-R6112 Rev.1.0 Sustained Data Transfer Rate DVD (Single) : CAV 4,410-10,800 KByte/s DVD (Dual) : CAV 3,375-8,100 KByte/s DVD-R, DVD-RW : CAV 2160-5,400 KByte/s DVD-RAM Version 2.
5/28 SD-R6112 Rev.1.0 *1: All discs written in CD or DVD formats except CD-Audio disc, require additional specific application software and/or hardware.
6/28 SD-R6112 Rev.1.0 3.2. Environmental Conditions This drive should be used under the conditions listed below. 3.2.1.Temperature and Humidity (1) Operating Temperature 5 ° C to 50 ° C (Media are e.
7/28 SD-R6112 Rev.1.0 (2) Operating (Write) ------------------------ no error -------------- 14.7 m/s 2 [1.5 G] (Horizontal) 7.8 m/s 2 [0.8 G] (Vertical) (Half sine wave 11 ms/10 s interval) (3) Non-o.
8/28 SD-R6112 Rev.1.0 3.3.2.Installation (1) The mounting surface of the equipment must keep good flatness. When mounting, care should be paid that an excessive force which may caused torsional distortion on the equipment does not apply to the equipment.
9/28 SD-R6112 Rev.1.0 3.3.3.Recommendation: As for mounting bracket to incorporate this product into an equipment, (1) When this product is incorporated into an equipment by using the mounting screw holes in the right and left side planes, the clearance between this product and the mounting bracket is too wide.
10/28 SD-R6112 Rev.1.0 ( Unit: mm ) Figure 5 External Dimensions.
11/28 SD-R6112 Rev.1.0 3.5. Reliabilites 3.5.1. Error Rate (1) Hard Read Error Rate (Byte Error Rate) ----- Allowing 5 Retries(default) ----- DVD: 10 -15 Max CD: Mode 1:10 -15 Max Mode 2:10 -12 Max (2) Seek Error Rate --- Allowing 10 Retries 10 -6 Max (default) 3.
12/28 SD-R6112 Rev.1.0 D VD-R/-RW DRIVE MODEL SD-R61 12 BLOCK DIAGRAM Disc Motor PUH F eed Motor P osition Detector R F Amp EQL T racking Amp Focus Amp T A1365AF Power Driver BA5962FVM Power Driver Po.
13/28 SD-R6112 Rev.1.0 5.Functions 5.1. Disc Data Configurations 5.1.1. DVD-ROM Data Configurations Figure 7 shows how data is constructed in the case of dual layer/parallel track data DVD disc. The DVD spec defines the single layer, the dual layer/opposite and parallel track disc, that the DVD-ROM drive supports.
14/28 SD-R6112 Rev.1.0 5.1.3. CD-R / CD-RW Data Configurations Before writing CD-R / CD-RW disc contains time-code information called ATIP. ATIP is abbreviation of "Absolute Time In Pre-groove" in the wobbling groove by modulating the carrier frequency.
15/28 SD-R6112 Rev.1.0 5.2. Power ON/OFF Timing (Target) Figure 11 shows the initialization sequence Power ON or ATAPI-RST System Initialization Focus Search Spindle ON Learning Stand-by "TEST UNIT READY" Command "Command" Receivable "Check Condition" Status "Good" Status Max.
16/28 SD-R6112 Rev.1.0 6.2.Signal summary The physical interface consists of single ended TTL compatible receivers and drivers communicating through a 50P-connector as shown in Figure 16 and Figure 17 "Interface connector". 6.2.1. Signal Specification Figure 12 shows the Signal Specifications N P N Sig.
17/28 SD-R6112 Rev.1.0 6.2.2.Timing of Host Interface (PIO) Figure 13 shows the Host Interface Timings t1 t4 Address valid*1 DIOR-/DIOW-*1 Write data valid*1 t6 t7 Read data valid*1 IOCS16-*1 t8 IORDY tRD t6Z t9 tA tB t2i t3 t5 t0 t2 *1: In all timing diagrams, the low line indicator negated, and the upper line indicators asserted.
18/28 SD-R6112 Rev.1.0 6.2.3.Timing of Host Interface (DMA Multi) Figure 14 shows the Host Interface DMA multi word Timings DMARQ DMACK-*1 DIOR-/DIOW-*1 Read DD0-15 Write DD0-15 tZ tI tJ tD tE tL tF tH tG t0 tK *1: In all timing diagrams, the low line indicator negated, and the upper line indicators asserted.
19/28 SD-R6112 Rev.1.0 6.2.4.Timing of Host Interface (Ultra DMA ) Figure 15 shows the Host Interface Ultra DMA word Timings DMARQ DMACK- STOP DMARDY STROBE tMLI tUI tACK tFS tENV tZAD tZIORDY t2CYC t.
20/28 SD-R6112 Rev.1.0 6.3. Connector Figure 16 shows the connector and Figure 15 shows the interface pin assignments Use Japan Aviation Electronics Industry Limited KX15-50KLD L or equivalent. Conformable connector is Japan Aviation Electronics Industry Limited KX14-50 series.
21/28 SD-R6112 Rev.1.0 6.4. Support Command List ATAPI Packet Command for DVD-ROM Devices 00h Test Unit Ready 01h Rezero Unit 03h Request Sense 12h Inquiry 1Bh Start / Stop Unit 1Ch Receive Diagnostic.
22/28 SD-R6112 Rev.1.0 ATA Command for ATAPI DVD-ROM Devices No. OP Code OP Code - 00h Nop 1 08h ATAPI Soft Reset 2 20/21h Read Sector (s) 3 90h Execute Drive Diagnostics 4 A0h ATAPI Packet Command 5 .
23/28 SD-R6112 Rev.1.0 7.2.7. Peak in executing Access 1,700 mA (DVD/CD) (Exclude Spike Current) *Spike: Less than 1 ms of duration 7.2.8. Write 1,000 mA (CD-R 16X) 660 mA (CD-RW 4X) 985 mA (High speed CD-RW 10X) 650 mA (DVD-R 2X) 600 mA (DVD-RW 1X) 8.
24/28 SD-R6112 Rev.1.0 10. Busy Indicator The LED at Front Bezel (Busy Indicator) indicates the drive status. Color: AMBER (1) After Drawer is closed, Busy Indicator start blinking at 0.8 s intervals, and then ----- (1-1) Turns off when the drive in the 'Idle' status.
25/28 SD-R6112 Rev.1.0 11.Emergency Release Execute following procedure only in the case of emergency (Drawer will not release and disc can not be removed although pressing Release Button). (1) Turn the drive supplying power off. (2) Insert solid bar (like paper clip) into Emergency Release hole and push as shown in Fig.
26/28 SD-R6112 Rev.1.0 13. Electrostatic Discharge Standard IEC61000-4-2 (1) Operating 8 kV or less (2) Damage including 15 kV or more 14. Accessories None 15. Packaging (1) 50 units in a bulk package 24 bulk packs on one pallet. * All transportation is allowed with pallet.
27/28 SD-R6112 Rev.1.0 TOSHIBA TOSHIBA EUROPE GMBH EU-Declaration of Conformity Product: DVD-R/-RW Drive Manufacturer(s): Toshiba Corporation 1-1, Shibaura 1-chome, Minato-ku, Tokyo 105-8001 Japan See.
28/28 SD-R6112 Rev.1.0 EU-Declaration of Conformity ED-Directive Related Standard Issude Level/Test condition EMC-emission: EMC-immunity Product/Options Model Related EU-Directive 89/336/EEC X Manufac.
SD-R6112 Rev.1.0 Deviation List Page Item Rev # 0.9 Rev # 1.0 22 7.2. Current Drain 7.2.1.Sleep 20 mA (DVD/CD) 28 mA (DVD/CD) 7.2.2.Standby 23 mA (DVD/CD) 30 mA (DVD/CD) 25 12.Safety Standards /Agency Approvals (1) Safety UL 60950 UL 1950 CAN/CSA-22.2 No.
An important point after buying a device Toshiba SD-R6112 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Toshiba SD-R6112 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Toshiba SD-R6112 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Toshiba SD-R6112 you will learn all the available features of the product, as well as information on its operation. The information that you get Toshiba SD-R6112 will certainly help you make a decision on the purchase.
If you already are a holder of Toshiba SD-R6112, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Toshiba SD-R6112.
However, one of the most important roles played by the user manual is to help in solving problems with Toshiba SD-R6112. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Toshiba SD-R6112 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
