Instruction/ maintenance manual of the product 200 Toro
Go to page of 8
Specifications: • Controls up to 200 stations for the Stand-Alone model • Input power supply 100 V AC, 50/60Hz 120 V AC, 50/60Hz 240 V AC, 50/60Hz • TDC output voltage: 40 V AC max.
Earth Ground Installation IMPORT ANT! The TDC surge protection components cannot properly function unless an ef ficient pathway to earth ground is provided. The ground path must be as direct as possible, without sharp bends and must not exceed 30 Ohm resistance (when measured with an earth ground resistance device).
Power Source Installation Step 1 – T urn off the power at the power source location and place the controller ’s power switch to OFF . Connect and route the appropriate size 3-conductor cable (10 AWG [2.5mm 2 ] maximum) from the power source to the controller cabinet.
Station Decoder Installation The station decoder module is available in 1-station, 2-station or 4-station configuration. The decoder modules are installed into the TDC output board terminals. The stand-alone TDC model can handle up to 100 stations per output board.
Paths – 1 23 4 V alve Box Maximum communication wire length between the controller and the farthest decoder is 15,000ft (4500m). Recommended Cable for Controller-to-Decoder is the Paige ® P7350D, 14 A WG, Solid Copper , Jacketed 2-Conductor, Direct Burial cable.
Grounding Communication Cable IMPORT ANT! Cable Splices: In order for the wire connections to comply with the 2005 edition of the National Electric Code® Article 300.
Master V alve / Pump Relay Installation TDC provide switch terminals to control a master valve or a pump relay if the system requires it. Step 1 – Place the controller ’s power switch to OFF .
Lithium Battery Replacement A 3.9V Lithium battery (P/N 363-2200) is installed in the timing mechanism to sustain the controller ’s clock time and date for approximately 10-years with no additional power applied. Step 1 – Place the controller ’s power switch to OFF .
An important point after buying a device Toro 200 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Toro 200 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Toro 200 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Toro 200 you will learn all the available features of the product, as well as information on its operation. The information that you get Toro 200 will certainly help you make a decision on the purchase.
If you already are a holder of Toro 200, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Toro 200.
However, one of the most important roles played by the user manual is to help in solving problems with Toro 200. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Toro 200 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
