Instruction/ maintenance manual of the product BQ04023-2 BBQ
Go to page of 28
Grill Guide For Model BQ04023-2(BQ52006) LP Gas Barbecue Grill o ; FOR YOUR SAFETY: 1. Read this Grill Guide before attempting to assemble or operate your grill. 2. Follow all safety instructions. 3. Check tbr leaks according to directions in this Grill Guide betbre operating your grill, even if purchasing an assembled grill.
Safety Precautions Always read and follow all DANGER, WARNING, AND FOR YOUR SAFETY notices in this Grill Guide. Failure to do may result in serious bodily injury or death, or in a fire or an explosion causing damage to property.
Table of Contents Safety Precautions .................................................................................... 2 Table of Contents ..................................................................................... 3 Warranty ............
Limited Warranty The manuthcturer warrants to the original consumer-purchaser that this product shall be free from detects in workmanship and materials under normal and reasonable use when assembled a.
Assembly Instructions This page will give you an overview of inforlnation to assemble your grill. The following pages will show in step-by-step detail how to do so. We offer the tbllowing suggestions to make your grill assembly as easy as possible. 1.
BQ04023-2 BQ52006 Detail 1 Thermometer 37 2 Thermometer Seat 38 3 Stainless Steel Lid- Outer 39 4 Logo Plate 40 5 Name Plate 41 6 Lid Side Panel - Right 42 7 Lid Side Panel - Left 43 8 Hood Handle 44 .
.
Cabinet and FireboxAssembly Assembly Parts List Side Burner Assembly... 1 PC Side Shelf Assembly... 1 PC Locking Casters...2PCS Warming Rack... 1 PC Warming Rack Bracket (left) Standard Casters...2PCS Heat Diffusers...4PCS Warming Rack Bracket (right) Cooking Grates.
STEP1 Insert 4 Caster Caps into the legs of the Cabinet and Firebox Assembly. Ensure the arrows on the top of the Caster Caps point out and away t_om the cabinet. Insert 2 Locldng Casters into 2 Caster Caps in the t_ont legs of Cabinet and Firebox Assembly.
STEP3 Attach the Side Burner Assembly to the Cabinet and Firebox Assembly using 2 Phillips Head Bolts (A) and 2 Lock Washers (D) going from the inside of the firebox and into the Side Burner Assembly as shown in Insert 1.
STEP 5 Insert the side burner valve into the side burner. The valve should be centered in the stein robe of the side burner. o STEP 6 Insert the valve stein up through the hole in the side burner front panel t_om the back side. Secure to the side burner front panel using 2 Phillips Head Bolts (C).
STEP 7 Slide the side burner ignition wire over the side burner igniter connector. STEP 8 Place the Heat Diffusers inside the firebox. Ensure the long extensions on the front of the Heat Diffusers go into the appropriate holes at the *_ont of the firebox.
STEP 9 Insert the Cooking Grates into the firebox. The bottoms of the Cooking Grates have a support on each corner that should sit on the firebox lip. STEP 10 Attach the Left and Right Warming Rack Support Brackets to the inner left and right sides of the firebox walls using 4 Phillips Head Bolts (B) and 4 Lock Washers (D).
STEP 11 Insert the smaller ends of"S" Hooks (E) into the side of the Side Shelf Assembly. STEP 12 Unscrew the electronic igniter top. Place the "AA" Battery (I) into the electronic igniter with the Positive (+) end _hcing up. Screw the electronic igniter top back into place on the electronic igniter.
STEP 13 Pull the cylinder support ring up to the top of the cabinet. Place the LP cylinder down into the tank support hole in the bottom panel. Ensure the valve faces toward the left panel of the cabinet.
General Information and Instructions Your new BBQ Pro TM Grill has been designed and manufactured to high quality standards. It will provide you with many years of enjoyment with a minimal amount of maintenance. Please keep in mind the following FOR YOUR SAFETY.
. 2. WARNING Do not attempt to use a cylinder with any other type of connection device. Do not attempt to use a cylinder with a larger capacity LP CYLINDER FILLING AND EXCHANGE Some areas only allow you to exchange your empty cylinder tbr a replacement that is already full.
DANGER Bubbles indicate a leak. In that case. call vour LP dealer or fire department immediatelv. TRANSPORTATION AND STORAGE 1. Always use the Safety Cap when transporting or storing your cylinder. 2. Do not store in a building, garage, or other enclosed area.
The regulator must enter the cylinder valvein a straight line. _.C.C.1 Type 1 Connector Center this nipple of the regulator into the cylinder valve. WARNING 1. Do not connect this grill to any unregulated sources of propane. 2. Protect the regulator fitting from damage when disconnected.
. . Grill Placement ,_ FOR YOUR SAFETY Minimum clearance required from sides and back of unit to ac[iacent combustible construction is 24 inches (61 cm). Do not locate this outdoor cooking gas appliance under unprotected overhead combustible surfaces.
LIGHTING THE MAIN BURNERS USING ELECTRONIC IGNITION 1. ()pen the lid. 2. Ensure all burner control knobs are in the "OFF' position. 3. Turn on the LP gas by slowly turning the hand wheel on the cylinder valve. 4. Turn one main burner control knob to "High".
TURNING OFF YOUR GRILL 1. Turn all burner controlknobs to the "OF' position. 2. Turn off the gas supply at theLP tank by turning the valveclockwise. Cleaning Your Grill '_ WARNING 1. Do not clean aW part of your barbecue grill in a self-cleaning oven.
CLEANING THE BURNERS 1. Ensure the LP gas is turned off at the LP cylinder. 2. Remove the cooking grates, heat diffusers, and grease tray. 3. Remove the Phillips Head screws located at the back end of each burner. 4. Lift each burner up and out. 5. Clean the inside of the burner using a stiff wire.
DIRECT - used for preheating and searing Use Direct cooking to sear meats. This helps to keep tbod 1hoist by locking in juices. Some food, such as steak, is first seared using Direct cooking, and then finished cooking using the Indirect method. This is generally used fbr quicker cooking foods.
2. The thermolneter measures the temperature at thetop of the lid. Thetemperature down by the cooking grates is generally SOlnewhat warmer. 3. Alwayscook with thelid down. This provides more even circulation of heat, and the food cooks faster. Remember thatheat is lost each time the hood is raised.
IRREGULAR FLAME OR YELLOW FLAME 1 .) New burner may have residual oil, which will burn offi 2.) Tubes in burners areblocked.Remove andclean. 3.) Burners have a high grease or dirt build-up. Remove and clean. 4.) Burners are not aligned properlywith thevalves.
gas line in each grill arealsoindividually tested when each grill comes offthe assembly line just prior to packaging.Each burner is ignited for this test. What is the humming noise I sometimes here coming from my regulator? The hulnming sound you can hear is just gas flowing through tire regulator.
Customer Support PHONE: 1-800-933-0527 Hours 8:30am to 5:00 pm Central time FAX: 1-847-252-1001 WEBSITE: http ://www.omahagrills.com MAIL: Customer Support - Barbecues 1375 Mitchell Blvd.
An important point after buying a device BBQ BQ04023-2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought BBQ BQ04023-2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data BBQ BQ04023-2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, BBQ BQ04023-2 you will learn all the available features of the product, as well as information on its operation. The information that you get BBQ BQ04023-2 will certainly help you make a decision on the purchase.
If you already are a holder of BBQ BQ04023-2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime BBQ BQ04023-2.
However, one of the most important roles played by the user manual is to help in solving problems with BBQ BQ04023-2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device BBQ BQ04023-2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
