Instruction/ maintenance manual of the product BP-2002 Telex
Go to page of 8
BP-1002/BP-2002 Beltpac ks A udiocom ® Inter com System 93507740000 Rev J 5/2006 Operating Instructions.
FCC ST A TEMENT This equipment uses, and can radiate radio frequency energy that ma y cause interference to r adio communications if not installed in accordance with this manual.
3 INTRODUCTION The A udiocom ®1 BP-1002 and BP-2002 are microprocessor controlled one- and two-channel intercom beltpac ks. An internal switch and jumper setting allows the units to be used with Clear-Com ®2 components , if desired.
13 4 Figure 1. BP-2002 & BP-1002 Connections and Controls APPENDIX A OPTIONAL FOO TBALL MODIFICA TIONS GENERAL DESCRIPTION In A udiocom ® Intercom Systems, the Mic-Kill f eature is used to tur n off any activated microphones on a selected channel.
12 5 EXTERNAL CONNECTIONS & CONTROLS NO TE: The numbers refer to the callouts in Figure 1. 1. V OLUME C ONTROL : Use this control to adjust the headset listen lev el. 2. C HAN B UTTON AND I NDICA T ORS : The Chan button (only on the BP-2002) allows the user to select which intercom channel is active .
11 6 7. I NTERCOM C HANNEL C ONNECTORS : On the BP-2002, intercom channels are connected via a pair of 6-pin connectors (one male and one female). The male and female connectors are wired together in par allel, providing a “loop through” at each connector pin.
10 7 Changing Modes of Operation: P erform the following steps to change the mode of operation. 1 . Both the T alk and Call indicators should be off and the headset should be connected 2 . Press and hold the T alk key , then press and hold the Call key , then release both ke ys.
9 8 INTERNAL SWITCHES, JUMPERS AND ADJUSTMENTS There are sev eral internal switches, jumpers and adjustments that aff ect operation. These are described below . T o gain access to the s witches, jumpers and adjustments, disconnect all power and line connections.
An important point after buying a device Telex BP-2002 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Telex BP-2002 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Telex BP-2002 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Telex BP-2002 you will learn all the available features of the product, as well as information on its operation. The information that you get Telex BP-2002 will certainly help you make a decision on the purchase.
If you already are a holder of Telex BP-2002, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Telex BP-2002.
However, one of the most important roles played by the user manual is to help in solving problems with Telex BP-2002. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Telex BP-2002 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
