Instruction/ maintenance manual of the product WS 9245-IT Technoline
Go to page of 15
18 WIRELESS 868 MHz TE MPERA TURE STATION Instruction Manual INTRODUCTION: Congratulations o n purchasing this temper ature station wi th wireless 868 MHz transmission of o utdoor temperature a nd display of indoor temperature.
19 The Temperature Station Manual time setti ng (hour and minu te display) Time display 24-hour time form at Temperature di splay in degree Celsius (°C) Indoor and out door temperature display with M.
20 1. First, insert the batter ies to the transmitter (see “ Ho w to install and replace batteries in the Temperature tra nsmitter ” below). 2. Within 30 seconds of powering up the trans mitter, insert th e batteries to the Temperature St ation (see “ Ho w to install and replace batter ies in the Temperature station ” below).
21 HOW TO INSTALL AND R EPLACE BATTERIES IN THE TEMPERA TURE STATION The Temperatur e Station uses 2 x AA, IEC LR6 , 1.5V batteries. When batteries will need to be rep laced, the low battery icon will appear on t he LCD. To install and replac e the batteries, please fol low the steps below: 1.
22 Note: In the event of c hanging batteries in a ny of the units, all uni ts need to be reset by following the setu p procedures. This is because a rand om security code is assigned by the transmitter at start-up and this code must be recei ved and stored by the Temperature Station in th e first few min utes of power sup plying.
23 Outdoor Reception Signal icon * MIN/MAX Outd oor temperature SET key Press and hold for about 3 seconds to enter the Manual setting mode. + key Press to make adjust ment in the setting mode .
24 Minutes (flashing) Hour (flashing) * When the signal from the trans mitter is successfully received by the Temperat ure Station, this icon will be switched on. (I f not successful, the icon w ill not be shown on the LCD). User can therefor e easily see w hether the last reception w as successful (“ON” icon) or not (“OFF” icon).
25 MAX outdoo r temperature MIN outdoo r temperature Outdoor temperat ure Indoor temper ature MAX indoor temperature MIN indoo r temperature VIEWING THE INDOOR TEM PERATURE AND MIN/MAX The indoor te m.
26 Note: The minimum/maximum temperature resol ution is 1 ° C. The resolution of the outdoor temperature is 0.1ºC TO RESET THE MIN/MA X DATA: The MIN/MAX temper ature can be rese t manually by pr essing and holding the + key for about 3 seconds.
27 same signal freque ncy (868MHz) may prevent correct signal tra nsmission and reception. 4. Neighbors using electrical devic es operating on the 868M Hz signal frequency can also cause inter ference.
28 To wall mount: Before wall mou nting, please check th at the outdoor temper ature values can be received from the desired locatio ns: 1. Fix a screw (not sup plied) into the desired w all, leaving the head extended out by about 5mm. 2. Hang the Tempera ture Station onto th e screw.
29 To wall mount: 1. Secure the brack et onto a desired wal l using the screws and plastic anchors. 2. Clip the remote temperature transmitter onto the bracket. Note: The mounting sur face can affect the transmis sion range. If, for instance, the unit is attache d to a piece of metal, it may then either reduce or incre ase the transmitting r ange.
30 Do not submerg e the units in water. Furt hermore, fix all par ts in place where th e units are adequat ely protected ag ainst moisture an d rain. Immediately r emove all low powered batteries to avoi d leakage and da mage. Replace only w ith new batteries of th e recommended type.
31 Temperature St ation : approximately 24 mon ths Outdoor Temperatur e Transmitter : approximately 12 mont hs Dimensions (L x W x H) Temperature St ation : 79.8 x 29 x 127mm Outdoor Temperatur e Transmitter : 32.4 x 14.1 x 86.5 mm LIABILITY DISCLAIMER: The electrical an d electronic wastes co ntain hazardous substances.
32 This product is d esigned for use in the home only as indicati on of the temper ature and other weather data. This product is n ot to be used for medical purposes or for publ ic information. The specifications o f this product may chang e without prior noti ce.
An important point after buying a device Technoline WS 9245-IT (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Technoline WS 9245-IT yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Technoline WS 9245-IT - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Technoline WS 9245-IT you will learn all the available features of the product, as well as information on its operation. The information that you get Technoline WS 9245-IT will certainly help you make a decision on the purchase.
If you already are a holder of Technoline WS 9245-IT, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Technoline WS 9245-IT.
However, one of the most important roles played by the user manual is to help in solving problems with Technoline WS 9245-IT. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Technoline WS 9245-IT along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
