Instruction/ maintenance manual of the product 316000181 Tappan
Go to page of 16
P/N 316000181 (9810) G A S RANGE SEALED SURF ACE BURNERS WITH PORCELAIN ENAMEL OR CONTINUOUS CLEANING OVEN Product Registration .................................................. 2 IMPORT ANT S AFETY INSTRUCTIONS ..................... 3-4 Grounding Instructions .
2 Thank you for choosing this appliance. The information contained within this Owner's Guide will instruct you on how to properly operate and care for your range. Please read through the information contained in your literature pack to learn more about your new appliance.
3 IMPORT ANT SAFETY INSTRUCTIONS Read all instructions before using this appliance. Save these instructions for future reference. This guide contains important safety symbols and instructions. Please pay attention to these symbols and follow all instructions given.
4 IMPORT ANT INSTRUCTIONS FOR USING YOUR COOKTOP Use Proper Flame SizeAdjust flame size so it does not extend beyond the edge of the utensil. The use of undersized utensils will expose a portion of the burner flame to direct contact and may result in ignition of clothing.
5 Your model may be equipped with the clock shown below. Follow the instructions to set the clock and minute timer on your range. T o Set the Clock When the range is first plugged in, or when the power supply to the range has been interrupted, "12:00" will flash in the display window.
6 For most cooking , start on the highest control setting and then turn to a lower one to complete the process. Use the chart below as a guide for determining proper flame size for various types of cooking. The size and type of utensil used and the amount of food being cooked will influence the setting needed for cooking.
7 Before Setting Oven Controls Arranging Oven Racks (Some models may have one rack.) ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven. REMOVING & REPLACING OVEN RACKS To remove , pull the rack forward until it stops.
8 The surface controls shown below may not look identical to the surface controls on your range. They are only representational. Bake 1. Arrange oven racks while the oven is still cool. See "Arranging Oven Racks" under Before Setting Oven Controls .
9 Adhere to the following cleaning precautions: Allow the oven to cool before cleaning. Wear rubber gloves when cleaning the appliance manually. REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS WILL REDUCE THE NUMBER OF MAJOR CLEANINGS LATER.
10 Oven Cleaning (continued) Continuous Cleaning Oven (some models) Continuous cleaning ovens have a special coating which is a porous ceramic material. This rough coating tends to prevent grease spatters from forming little beads which run down the side walls leaving streaks that require hand cleaning.
11 Surfaces Aluminum (Trim Pieces) & Vinyl Glass, Painted and Plastic Body Parts, Control Knobs and Decorative Trim Pieces Control Panels Porcelain Enamel Burner Grates, Cooktop Surface, Below.
12 Use caution when replacing the burner cap so the electrode is not damaged. This may cause a delayed ignition or prevent the burner from igniting. Any additions, changes or conversions required in o.
13 General Cleaning (continued) T o Remove and Replace Oven Door To Remove Oven Door: 1. Open the door. 2. Remove screws located on the inside of the oven door near the hinges A (one on each side.) 3. Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up and off the hinges.
14 OCCURRENCE Range is not level. Cannot move appliance easily. Appliance must be accessible for service. Surface burners do not light. POS SIBLE CA USE/SOLUTION Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at base of range until the rack is level.
15 Burner ports are clogged. With the burner off, clean the ports with a small- gauge wire or needle. Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame is full. Dry the burners thoroughly following instructions under General Cleaning.
TAPPAN, THROUGH ITS AUTHORIZED SERVICERS, WILL: Pay all costs for repairing or replacing any parts of this appliance which prove to be defective in materials or workmanship. All of the provisions of the full warranty above and the exclusions listed below apply.
An important point after buying a device Tappan 316000181 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Tappan 316000181 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Tappan 316000181 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Tappan 316000181 you will learn all the available features of the product, as well as information on its operation. The information that you get Tappan 316000181 will certainly help you make a decision on the purchase.
If you already are a holder of Tappan 316000181, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Tappan 316000181.
However, one of the most important roles played by the user manual is to help in solving problems with Tappan 316000181. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Tappan 316000181 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
