Instruction/ maintenance manual of the product R9855510 Barco
Go to page of 47
B-1 0 Mobile LED Installation & maintenanc e manual R9855510 R5976956/03 19/06/2007.
Barco nv Eve nts Noordl aan 5, B-8520 Kuurne Phone: +32 56.36.89.70 Fax: +32 56.36.88.24 E-mail: sales.events@barco.com Visit us at the web: www.barco.
Changes Barco provides this manual ’as is’ without warranty of any kind, either ex pressed or implied, including but not limited to the i mplied war- ranties or merchantability and fitness for a particular purpose.
.
Table of con tents T ABLE OF CONTENTS 1 . S a f e t y i n s t r u c t i o n s ................................................................................................ 3 1.1 General instructions . . .......................... ..................
Table of con tents 2 R5976956 B-10 MOBILE LED 19/06/2 007.
1. Safety instruc tions 1. SAFETY INSTRUCTIONS Overview • General instructions • Important Safety instructions • Safety instructions for LED screen setup • Safety instruction when driving the trailer • Important W arnings • Specific warnings for diesel-fueled generator • Specific warning for the jockey wheel 1.
1. Safety inst ructions 1.2 Important Safety instructions Instruction s: • Read these instructions. • Keep these instructions. • Heed all warnings. • Follo w all instr uctions. • IMPORT A NT , plug holder clamps must be locked firmly on all controller units and power boxes to prevent the possible ingress of fluids or solid particles.
1. Safety instruc tions 1.5 Important Warnings Important warnings • High leakage current: The combination of multiple tiles in an installation results in increased levels of leakage current. In order to avoid risk of electric shock due to high leakage current, proper grounding of the installation is required.
1. Safety inst ructions What is a faulty operation • Levelling the trailer by first placing the rear stabilizers. This way almost the half of the w eight of the total trailer (1800 Kg) rests on the jockey wheel. Image 1-1 Wrong way to level tra iler • Unhitching the trailer by first retracting the front stabilizers.
1. Safety instruc tions The good way of wor king, building off the vehicle • Retract the rear stabilizers first and then the fr ont stabilizers till none of them to uch the ground. • T urn the jockey wheel downwards till the wheel to uches the ground.
1. Safety inst ructions 8 R5976956 B-10 MOBILE LED 19/06/2 007.
2. System Over view 2. SYSTEM OVER VIEW Overview • Introduction • B-10 Mobile LED tiles •L E D P r o • B-10 Mobile LED trailer • B-10 Mobile LED generator 2.1 Introduction Overview The B-10 Mobile LED is a mobile outdoor LED display solution.
2. System Over view Image 2-2 All tiles are connected in series via a data path. Each tile picks o ut a part of the video information of the da ta stream on the data path and processes this information for displaying on its LED’ s. 2.2.2 SLite 10 XP s pecification s Specifications Visual Resolution 10.
2. System Over view D320 input compatibili ty S-Video, Composite, YUV , RGB, SDI, HDSDI, Data D VI up to UXGA Certifications E T L ,C E ,C E B E C ,T U V ,F C Cc l a s sA Tile dimensions width: 8 96mm (35.3") height: 672 mm (26.5") depth: 248mm (9.
2. System Over view B C A D E Image 2-4 SLite input /output ports. A Connection module. B Power input port. C Power output port. D Data input port. E Data output p ort. A Image 2-5 A Plug holder clamp. C AUTION : The SLite input/ou tput ports can only be use d in conjunction with Barco ’ s outdoor cables for LED- walls.
2. System Over view Image 2-6 LEDPRo 2.3.2 LED-PRo features Overview • Three universal inputs accept RGBHV/RGBCs/RGsB computer video, component video (STD or HDT V), SVideo, or composite video with loop-through • SD SDI/HD-SD I input. • DVI-I connectors support both univers al analog and DVI input with loop-through.
2. System Over view 2.4.2 Dimensio ns Overview 4240 21 12 2500 2385 2688 3584 Image 2-7 Dimensions 2.5 B-10 Mobile LED generator 2.5.1 Introduct ion Overview Please read this section carefully before using the generator . If you act as stated in this section, your generating set will guarantee you a smooth functioning time after time.
2. System Over view 2.5.2 Components Overview • Type: EPS183TDE • P ower: 3 x 400V : 18kV A, 1 x 230 V : 6kV A • A lternator: Leroy Somer LSA37M8 with A VR (brush less) • Engine: KU BOT A D1 1.
2. System Over view 2.5.3 Control panel Descripti on Image 2-9 Control panel The control panel of the EPS8DE consists of : • Starting key (off / on / glow / start) • Pilot lamp green (contact on /.
2. System Over view On the inside of the co ntrol panel there can be found: • 2 x relay 12V/30A for guarding oil pressure an d temperature of cooling liquid with aid of a stopping coil (Engine shuts off when the oil pressure is low or the temperature of the cooling liquid is to high).
2. System Over view Image 2- 13 Identification 2. In case of overload, the thermal-magnetic protection in the control panel shall be switched of f after a short period of time. Check the load, reduce it if necessary and switch on the thermal-magnetic p rotection again.
2. System Over view Image 2- 15 Altern ator Thermal-magnetic protection and earth l eakage protection (with earth pin). Image 2- 16 2.5.8 Maintena nce Overview All maintenance points (air filter , oil drain pump, oil filler cap, o il filter , fuel filters, radiator filler cap) are easily accessible.
2. System Over view 2 Fuel filter D1 105/V1505 3981 1 1 105 FF 5226 1522143080 3 In line filter D1 105/V1505 130000016 FF 149 128143012 4 Air filter cartridge1 105/V1505 39801 1 105 AF 4939 15741 1 10.
3. Setup of the B-10 Mob ile LED 3. SETUP OF THE B-10 MOBILE LED Overview • Installation of the B-10 Mobile LED • P owering the B-10 Mobile LED • Extending the LED di splay • Rotating the LED display • Move down the LED Display • Preparing for departure 3.
3. Setup of the B-10 M obile LED Image 3-2 Contact key and power cabl e of pump 2. After several seconds turn-on the generator with this contact key . Caution: The generator of the B-10 Mobile LED needs to be well-ventilated. Ther efore, the generator of the B-10 Mobile LED is not indented to run for a long p eriod of time with the roof closed.
3. Setup of the B-10 Mob ile LED Image 3-3 Pump system 2. Push on the black button. 3. Lift the first halve of the LED-wall by using the lever Lift this part of the display up till its 10 cm above the de c k o ft h eB - 1 0M o b i l eL E D . Fastening both di splay halves togeth er 1.
3. Setup of the B-10 M obile LED Image 3-5 Safety pieces Caution: Make sure the safety pins are p laced in the mast. This is mandatory for security reason and to avoid that the mast comes slightly down after closing the pump system. 3. Stop the pump system by closing the air arrival and switching of f the pum p.
3. Setup of the B-10 Mob ile LED How to move do wn? 1. Lift down the disp lay till it’s on the bottom. Note: Do not forget to take away the safety pieces from the mast. Caution: Watch out that cables are not under the display . 2. Open the pump system and lift up th e display a little.
3. Setup of the B-10 M obile LED 26 R5976956 B-10 MOBILE LED 19/06/2 007.
4. Maintenance, Ser vice 4. MAINTENANCE, SER VICE Overview For maintenance, service and repair on the B-10 Mob ile LED please consult qualified servi ce technicians/personnel. Servicing is required when the B-10 Mobile LED has been damaged in any way , such as hydraulic mast or generator is damaged , the B-10 Mobile LED does not operate normally .
4. Maintenance, Service Daily 500 km Quarter ly Y early C L T Cl C L T Cl C L T Cl C L T Cl Light cover Outriggers Functioning Attachment Frame Transverse at si de section support for girders girders .
4. Maintenance, Ser vice Daily 500 km Quarter ly Y early C L T Cl C L T Cl C L T Cl C L T Cl cylinder flexible attachment to grid Generator general moto r alternator oil gas - diesel exhausts fixing state C = Control L = Lubricate T = T ighten Cl = Clean After 50h00 the diesel generator needs to get its first mainten ance.
4. Maintenance, Service Service interval s For a detailed explanation of the service intervals, cons ult the service and maintenance manual of the genera tor .
4. Maintenance, Ser vice Overview se rvice center For Europe Country Engine (Kub ota) Alternator (Leroy Somer) Austria MAG Motoren GmbH A-5023 Salzburg T el. 43.662640460 Fax. 43.662882340 L-S Elektroantriebe GmbH A-1 180 Wien T el. 43.2224706401 Fax.
4. Maintenance, Service Country Engine (Kub ota) Alternator (Leroy Somer) Malta Gaetano Caruana Limited Zebbug, MAL T A G.C. T el. 356.460881 Fax. 356.465824 Netherlands Gebr . Prins B.V . 2676 BD Maasdijk T el. 31.174516240 Fax. 31.174518142 Leroy Somer Nederland 3769 Bt-Soesterberg T el.
4. Maintenance, Ser vice Country Engine (Kub ota) Alternator (Leroy Somer) Brazil Polus Maquina Eletricas Campuci Sao Paulo CEP 01524 T el. 55.1 1.9148766 Chili Clem sa Maipu/Santiago T el. 56.2.5572970 Fax. 56.2.5571439 Moteurs Leroy Somer Santiago T el.
4. Maintenance, Service Country Engine (Kub ota) Alternator (Leroy Somer) Israel FK Generators & Equipm. Ind. Z. Holon P B 1729 T el. 972.3.5570567 Fax. 972.3.5560771 Moteurs Leroy-Somer T el Aviv 66089 T el. 972.3.820996 Fax. 972.3.820040 Japan Kubota Osaka Hea d Off.
4. Maintenance, Ser vice Country Engine (Kub ota) Alternator (Leroy Somer) Tu r k e y Altinboga Istanbul T el. 90.212.5013465 Fax. 90.212.6122381 SASIM Kemeralti 80020 Karaköy-Istanbul T el. 90.1.1515626 Fax. 90.1.1515524 Un. Arab Emirates M. T ayyeb Khoory & Sons P .
4. Maintenance, Service Country Engine (Kub ota) Alternator (Leroy Somer) Guinea Les ateliers de Guinee Conakr y T el. 224.464744 Ivory Coast Sorepel Abidjan 01 T el. 225.359525 Fax. 225.350414 Morocco Cogepra 20300 Casablan ca T el. 212.2.307436 Fax.
A. Drawings B10 trailer A. DRA WINGS B10 TRAILER A.1 Electric al drawings Overview Image A-1 R5976956 B-10 MOBILE LED 19/06/2 007 37.
A. Drawings B10 trailer Image A-2 38 R5976956 B-10 MOBILE LED 19/06/2 007.
A. Drawings B10 trailer Image A-3 R5976956 B-10 MOBILE LED 19/06/2 007 39.
A. Drawings B10 trailer Image A-4 40 R5976956 B-10 MOBILE LED 19/06/2 007.
A. Drawings B10 trailer Image A-5 R5976956 B-10 MOBILE LED 19/06/2 007 41.
A. Drawings B10 trailer 42 R5976956 B-10 MOBILE LED 19/06/2 007.
Revision Sheet To : Barco nv Even ts/Documenta tion Noordlaan 5, B-8520 Kuurne Phone: +32 56.36.8 9.70, Fax: +32 56.36.88.24 E-mail: service.mne@barco.
An important point after buying a device Barco R9855510 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Barco R9855510 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Barco R9855510 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Barco R9855510 you will learn all the available features of the product, as well as information on its operation. The information that you get Barco R9855510 will certainly help you make a decision on the purchase.
If you already are a holder of Barco R9855510, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Barco R9855510.
However, one of the most important roles played by the user manual is to help in solving problems with Barco R9855510. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Barco R9855510 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
