Instruction/ maintenance manual of the product SC118 Stoelting
Go to page of 33
SC1 18 - S towaway Slush/Cocktail OWNER’S MANUAL Manual No. 513556 Jan., 2001 Rev . 0.
.
Need Part s or Service? We stock the parts you need. Our Technicians are factory trained and are certified in the Stoelting Technicare program. Model No.: _______________________ Serial No.: _______________________ Purchase Date: ____________________ Start-Up Date:____________________ CALL Distributor: _________________________ Phone No.
.
OWNER'S MANUAL FOR MODEL SC118 STOELTING COUNTER MODEL FREEZER This manual provides basic information about the freezer. Instructions and suggestions are given covering its operation and care. The illustrations and specifications are not binding in detail.
.
SECTION DESCRIPTION PAGE 1. Introduction ................................................................................................................ . 1 2. Installation Instruction 2.1 Safety Precautions ..........................................
FIGURE TITLE PAGE 1 Model SC118 ......................................................................................................... 1 2 Specifications ..............................................................................................
1 The Stowaway is a countertop profit machine. This compact unit fits onto any crowded bar, yet its high capacity means it will turn out more than seven gallons every hour. And the Stowaway is as versatile as it is fast, dispensing frozen, pre-mixed or ready-to-serve blends all with the same smooth consistency.
2 Figure 2. Specifications Specifications 12 running amps 1 15/60/1 15-amp fuse 2.5 gallon (9.5 liter) hopper capacity 5.5 quart (5.2 liter) barrel capacity 1/3 horsepower drive motor UL & C-UL ap.
3 SECTION 2 INSTALLATION INSTRUCTIONS 2.1 SAFETY PRECAUTIONS Do not attempt to operate the freezer until the safety precautions and operating instructions in this manual are read completely and are thoroughly understood. Take notice of all warning labels on the freezer.
4 D. Connect the power cord. The plug is designed for 115 volt/15 amp duty. The unit must be connected to a properly grounded receptacle. The electrical cord fur- nished as part of the freezer has a three prong ground- ing type plug. The use of an extension cord is not recommended.
5 SECTION 3 INITIAL SETUP AND OPERATION 3.1 OPERATOR'S SAFETY PRECAUTIONS SAFE OPERA TION IS NO ACCIDENT ; Observe these rules: A. Know the freezer . Read and understand the Operating Instructions. B. Notice all warning labels on the freezer . C.
6 Figure 7. Front Door and Auger Assembly T o disassemble the freezer , refer to the following steps: A . Remove the front door by removing the upper and lower plastic shrouds then turn off the knobs, and pull the front door off the studs. B . Remove the spigot body from the spout by pulling the horse shoe clip up and out.
7 C. Lubricate the drive end of the agitator (rear) shaft with a small amout of white socket lubricant. A small container of socket lubrication is shipped with the freezer. D. Install the two plastic agitator blades onto the agitator. Install front agitator bearing.
8 CAUTION PROLONGED CONT ACT OF SANITIZER WITH FREEZER MA Y CAUSE CORROSION OF ST AIN- LESS STEEL P ARTS. In general, sanitizing may be conducted as follows: A . Prepare 2 gallons (7.5 liters) of sanitizing solution following manufacturer's instructions.
9 SECTION 4 BULB REPLACEMENT 4.1 LIGHT BULB REPLACEMENT 1. Remove the upper plastic shroud. 2. Remove the four retaining screws from the electrical panel and tip forward. 3. Grasp faulty bulb and pull out. 4. Push in replacement bulb until it snaps into place.
10.
11 SECTION 5 SEQUENCE OF OPERATIONS 5.1 LIGHTS On/Off light switch is independent of all other switches. When on, the light transformer is operational and the lights illuminate.
12.
13 PR OBL E M: CA US E CO RR ECTION High Pressure Cuto ut Sw itch T ripped. Dirty c o ndense r. Clea n conde nse r Drive moto r overl oad tri ps. (Freezer shuts down when runni ng) I m p r o per B r ix readi ng . Re f ill wit h prod uct that ha s Brix r e a ding b e twee n 11 and 1 3.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
W ARRANTY MIX TRANSFER PUMPS / COCKT AIL / SLUSH 1. Scope: Stoelting LLC warrants to the first user (the “Buyer”) that the evaporator assembly and compressor (if applicable) of Stoelting mix trans.
An important point after buying a device Stoelting SC118 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Stoelting SC118 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Stoelting SC118 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Stoelting SC118 you will learn all the available features of the product, as well as information on its operation. The information that you get Stoelting SC118 will certainly help you make a decision on the purchase.
If you already are a holder of Stoelting SC118, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Stoelting SC118.
However, one of the most important roles played by the user manual is to help in solving problems with Stoelting SC118. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Stoelting SC118 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
