Instruction/ maintenance manual of the product CB-MVPWDS Bakers Pride Oven
Go to page of 16
! ! W ARNING: Improper installa tion, adjustment, alterati on, service or maintenance can caus e property damage, injury or death. Read the Installa tion, Operating and Maintenance Instructions thorough ly before installing or servicing this equipment.
2 I. INST ALLA TION INSTRUCTIONS SECTION ITEM P AGE A Receiving 2 B Set-up/Mounting 2 C Installation with Casters 3 D Location & Minimum Clearances 3 E E l e c t r i c a l C o n n e c t i o n s 4 F Flue Connection V entilation 4 G Initial Cleaning 4 H System Check - Rotary Controls 5 II.
3 (2) Using proper lifting equipment, lift up the left-hand side and attach two 31” legs on the left-hand side the same way . For a stack of two ovens: Refer to Figure 3 (1) Remove flue from top oven and replace with flue-adaptor supplied in the stacking kit.
4 E. ELECTRICAL CONNECTION: Install according to the spacing requirements listed in the installation section of this manual. We strongly recommend having a competent professional install this equipment. A licensed electrician should make the electrical connections and connect power to the unit.
5 H. SYSTEM CHECK- ROT AR Y CONTROL (standard): (1) Open the oven door . (2) T urn Selector Switch to “HI.” The green indicator light near Selector Switch and oven light will illuminate. (3) Close the door . Oven lights will go off and fan will run.
6 Timed cooking rotary control: (1) Close the oven doors. (2) Turn Selector Switch to “HI” or “LO” position. The indicator light near the Selector Switch will be illuminated. (3) Turn the thermostat knob to the desired cooking temperature. (4) Upon reaching the set temperature, the indicator light near the thermostat will go out.
7 OVEN INTERIOR: Clean The Racks And Rack Support Guides: Open the doors and remove all wire racks and rack support guides. T ake them to the sink and thoroughly clean in warm water with mild detergent or soap. Use a nylon scouring pad or stiff nylon brush.
8 D. SERVICING: NOTE: THIS APPLIANCE MUST BE SERVICED BY AN AUTHORIZED SERVICE AGENT . (1) Power supply to the unit must be disconnected before any service is performed. (2) Most of the service on the unit can be performed from the front and/or control panel side.
9 Figure 3 Item 1 Item 2 Item 3 E3770A E3771A 3/8”-16 Bolt ST ACKING INSTRUCTIONS FOR: COB-E & COM-E CONVECTION OVENS Remove flue from top oven and replace with item 1 2 1 3 Attach part # 21818062 with 6 each 8-32 stainless screws Material: 14 ga 201 Stainless Remove flue from bottom oven, and re-install after top oven is in place.
WITH PLA TE CASTER WITHOUT PLA TE CASTER Figure 4 LEG ASSEMBL Y INSTRUCTIONS - MODEL: COB-E & COM-E 1. Attach four item 2 to four item 1 using item 3, 4 and 5. 2. Using proper lifting equipment attach item 1 to the corresponding hole patterns located in the bottom of the oven with item 6.
COB-E & COM-E 208, or 240V AC, 1 Phase (Dial Control) E. WIRING DIAGRAMS 18 2 1 27 Green Power Light 23 10 30 Amber Pilot Light 19 24 RTD Probe T4 T5 T2 T1 T3 T6 T7 T8 T9 T10 T11 Probe T -Stat Rel.
COB-E & COM-E 208, or 240V AC, 3 Phase (Dial Control) 18 2 1 27 Green Power Light 23 10 30 Amber Pilot Light 19 24 RTD Probe T4 T5 T2 T1 T3 T6 T7 T8 T9 T10 T1 1 Probe T -Stat Relay Thermostat 26 2.
13 PROBE DOOR HEA T FAN LIGHTS POWER COM REL A Y L1 L 3 L 2 SINGLE PHASE 2 08/ 240 V DOORS ACTIV A TE SWITCH WHEN C LOSED GND FRONT ELEMENT 28 29 10 9 16 17 14 15 27 4 21 20 26 25 23 22 18 2 1 27 24 1.
14 86 1 89 1 120 1 119 1 107 1 91 1 118 1 101 1 85 1 112 2 113 2 115 2 32 2 29 1 27 5 50 6 52 1 53 1 5 1 4 3 1 50 6 49 2 54 2 114 2 21 2 111 1 45 1 61 1 79 4 76 8 80 1 17 2 83 2 60 2 121 3 63 6 4 1 31.
15 6 1 1 22 10 1 12 2 1 1 1 1 8 1 1 4 1 1 1 2 4 1 1 4 1 1 1 1 1 1 1 1 1 1 1 1 1 3 1 1 1 1 1 1 1 2 4 1 1 2 2 2 2 2 2 1 1 1 3 3 1 1 Support, Element Motor Panel Motor Mount Pop Rivet, Ø.
16 WHA T IS COVERED This warranty covers defects in material and workmanship under normal use, and applies only to the original purchaser providing that: ♦ The equipment has not been accidentally or.
An important point after buying a device Bakers Pride Oven CB-MVPWDS (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Bakers Pride Oven CB-MVPWDS yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Bakers Pride Oven CB-MVPWDS - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Bakers Pride Oven CB-MVPWDS you will learn all the available features of the product, as well as information on its operation. The information that you get Bakers Pride Oven CB-MVPWDS will certainly help you make a decision on the purchase.
If you already are a holder of Bakers Pride Oven CB-MVPWDS, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Bakers Pride Oven CB-MVPWDS.
However, one of the most important roles played by the user manual is to help in solving problems with Bakers Pride Oven CB-MVPWDS. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Bakers Pride Oven CB-MVPWDS along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
